by
by
SLPRWAS46
Pure Clean Pressure Washer
Electric Outdoor Power Washer
WARNING: READ THE INSTRUCTION BEFORE OPERATION
THIS MACHINE IS DESIGNED FOR DOMESTIC USE ONLY!
COMMERCIAL OR INDUSTRIAL USE ARE PROHIBITED.
>> CONTENTS
Illustration of Appliance ------------------------------------------------------------------ 1
General Instruction -------------------------------------------------------------------------- 2
Safety Instruction -------------------------------------------------------------------------- 3
Operation -------------------------------------------------------------------------------------- 4
Maintenance & Care ----------------------------------------------------------------------- 6
Troubleshooting ----------------------------------------------------------------------------- 7
Storage ---------------------------------------------------------------------------------------- 8
Schematic Drawing ------------------------------------------------------------------------- 9
>> ILLUSTRATION OF APPLIANCE
Spare parts are subject to the
specic model. The right of
modication is reserved.
1. Water Supply Connector
2. High Pressure Hose
3. Water Outlet
4. Water Inlet
5. ON/OFF Switch
6. Transport Handle
7. Detergent Tank
8. Power Cord
9. Wheels
10. Trigger Gun
www.PyleUSA.com www.PyleUSA.com
11. Spray Lance
12. Safety Lock
13. Hose Lock
14. Trigger Handlr Holder
15. Trigger Handle Locker
16. Retractable Rod
17. Detergent Suction Pipe
18. Filter
19. Degergent Tank Lock
20. Spraylance Holder
1
READ AND UNDERSTAND OPERATORS MANUAL
BEFORE USING THIS MACHINE. FAILURE TO
FOLLOW OPERATING INSTRUCTIONS COULD
RESULT IN DEATH OR SERIOUS INJURY
>> GENERAL INSTRUCTION:
This high pressure washer is designed for domestic use only:
1. To clean cars, motorbikes, caravans, bicycles.
2. To clean patios, fences, garden walls, pathways, driveways and house
facades, particularly useful for cleaning blocked driveway.
3. To remove of algae and moss from roofs, brickwork and guttering.
4. To clean garden tools and machinery, furniture and barbecues.
5. To clean hygienic of animal pens and their surrounding area.
With accessories, replacement parts and detergents approved by factory.
Observe the instructions provided with these detergents.
The packing material can be recycled. Please do not place the packaging
into the ordinary refuse for disposal, but arrange for the proper recycling.
Old appliances contain valuable materials that can be recycled. Please
arrange for the proper recycling of old appliances. Please dispose your
old appliances using appropriate collection systems.
Read symbols in the operating instructions
Danger: Immediate danger that can cause severe injury or even death.
Warning: Possible hazardous situation that could lead to severe injury or
even death.
Caution: Possible hazardous situation that could lead to mild injury to
persons or damage to property.
The high pressure washer may not be directed at persons,
animals, live electricalequipment or at the appliance itself.
Protect the appliance against frost
>> SAFET Y INSTRUCTION
Danger
1. Never touch the mains plug and the socket with wet hands.
2. The appliance must not be used if the power cord or important parts of
the appliance, e.g. high pressure hoses, trigger gun or safety devices are
damaged. Please arrange for it to be replaced immediately by an
authorised repair agent or a skilled electrician.
3. The appliance may not be used in areas where a risk of explosion is
present.
4. The high pressure washer must not be directed at other persons or
directed by the user at him/herselfto clean clothing or footwear.
5. If the appliance is used in hazardous areas (e.g. lling stations) all of the
safety provisions and operating instructions detailed in this manual must
be observed.
6. Never use the appliance to clean objects containing hazardous
substances.
7. Vehicle tyres or tyre valves are susceptible to damage from the high
pressure washer and may burst. The rst indication of this is a discoloration
of the tyre. Damaged vehicle tyres/tyre valves are highly dangerous.
Ensure that a distance of at least 30 em is observed when cleaning with
the washer.
8. Risk of explosion. Do not spray ammable liquids. Never draw in uids
containing solvents or undiluted acids. This includes petrol, paint thinner
and heating oil. The spray mist thus generated is highly inammable,
explosive and poisonous. Do not use acetone, undiluted acids or solvents
as they are damaging to the materials from which is the appliance is made.
Warning
1. The mains plug and the coupling of an extension cable must be
watertight and must never lay in the water.
2. Unsuitable extension cables can be hazardous. Only use extension
cables outdoors which have been approved for this purpose and labeled
with a sucient cable cross-section: 1-10m: 1.5mm² 10-30m: 2.5mm²
3. Always fully unroll electrical cables.
4. High pressure hoses, xtures and couplings are important for the safety of
the appliance. Only use high pressure hoses, xtures and couplings
recommended by the manufacturer.
2 3
www.PyleUSA.com www.PyleUSA.com
5. This appliance is not intended for use by persons with reduced physical,
sensory or mental capabilities. The appliance must not be operated by
children or persons who have not been instructed accordingly. Children
should be supervised to prevent them from playing with the appliance.
6. The operator must use the appliance correctly. When working with the
appliance, he must consider the local conditions and pay due care and
attention to other persons, in particular children who are nearby.
Caution
1. Do not use the machine if the persons nearby do not wear safety
protection device.
2. Wearing protective clothing and safety goggles to protect against
splash back containing water or dirt.
3. Create stability for the appliance prior to all work on or with the appliance
to prevent accidents or damage. The stability of the appliance is
warranted when it is placed on to an even surface.
4. For safety reasons, we recommend that you operate the appliance only
via an earth-leakage circuit breaker (max. 30mA).
5. Make sure that the power cord or extension cables are not damaged by
running over, pinching, dragging or similar. Protect the power cable from
heat, oil, and sharp edges.
6. Never leave the appliance unattended when it is in operation.
>> OPERATION
Special accessories expand the possibilities of using your appliance.
Please contact the dealer for further information.
Illustrate accessories before start-up.
1. Install coupling for water connection (pic A).
Screw the coupling to the water connection on the appliance.
2. Install high pressure hose (pic B. pic K).
Insert the high pressure hose tightly in to coupling on the appliance, it will
lock in audibly. Note:make sure the connection nipple is aligned correctly.
Check the secure connection by pulling on the high pressure hose.
3. Install the storage of trigger gun (pic C).
Insert the storage of trigger gun and push down all the way.
4. Install spray lance (pic F).
Push the spray lance into the trigger gun and fasten it by turning it
through 90 degree.
Water Supply
Impurities in the water can damage the high pressure pump and accessories.
All high pressure washer (except hot water system) use cold water.
The suitable water temperature is 41°F to 140 °F.
Water Supply from Mains
Observe regulations of water supply.
For connection values, use bre-reinforced water hose (not included) with a
standard coupling, normally the length is 5m, connect the water hose to
the appliance and water supply.
1. Open the water tap
2. Unlock the lever on the trigger gun
3. Pull on the lever of the trigger gun
4. Turn ON the appliance (pic G ON: open OFF: close)
Start Up
Dry runs lasting longer than two minutes lead to damages to the high
pressure pump. If the appliance does not build up pressure within two
minutes, switch it o and proceed as instructed in the Chapter "Trouble-
shooting". The trigger gun is subjected to recoil force when the water
washer is discharged. Make sure that you have a rm footing and are also
holding the trigger gun and spray lance rmly. The spray lance has two main
settings stream and fan for easy cleaning (pic H).
Caution
Prior to cleaning, make sure that the high pressure washer is placed safely
on level ground. Wear protective goggles and protective clothing during
the cleaning process.
Notes: Release the lever ofthe trigger gun, the device will switch o again.
High pressure washer remains in the system.
4 5
www.PyleUSA.com www.PyleUSA.com
Working with Detergent
>> TROUBLESHOOTING
Use detergent when cleaning. Remove the lid from the detergent bottle and
press the detergent bottle into detergent (pic E).
Notes:The device is under low pressure when using detergent and pulling
out spray lance.
Release the lever on the trigger gun, lock the lever on the trigger gun, insert
the spray lance into trigger gun when interrupting operation. (as pic Q)
Finish Operation
1. Turn o tap.
2. Press the lever on the trigger gun to release any remaining pressure and
water in the system.
3. Pull out the mains plug.
4. Store the water hose and high pressure hose.
>> MAINTENANCE AND CARE
Symptom Cause Recommended Action
Appliance is not running
Pump stop working
Fluctuating pressure
Appliance does not
reach operation pressure
1. Machine not plugged in
2. Defective socket
3. Defective extension
cable
4. Incorrect mains voltage
5. Switch is o
6. Fuse has blown
Lack of water lead to
high temperature
1. Spray lance blocked
2. Pump is sucking air
3. Impurities in pump
1. Spray lance blocked or
worn
2. Short supply of water
3. Hose kinked
4. Filter blocked
5. Hose blocked
1. Plug in machine
2. Try another socket
3. Try another extension
cable
4. Check voltage correctly
5. Turn on switch
6. Replace fuse
Check water ow quantity
~ put the hose in the 10
(bottle per minute)
1. Clean lance with needle
2. Check that hoses and
connections are airtight
3. Contact the dealer
1. Clean or change spray
lance
2. Check inlet ow rate
3. Straighten out hose
4. Clean lter
5. Clean hose
Turn o the appliance and remove the mains plug prior to any care
and maintenance work. Prior to longer periods of storage, pull out
the lter (18) in the detergent bottle and clean under running
water. Pull out the lter in the water connection and clean under running
water (pic J). Use the needle to clean the residue (pic M). In winter, please do
not putthe machine outside without draining the water to avoid damage to
the machine. Just put it in a room with frost prevention.
Trigger gun can’t be used Trigger gun is locked Unlock Trigger gun safety
Machine often starts
and stops by itself
1. Safety valve worn out
2. Pump, high pressure
hose, trigger gun is
leaking
1. Contact the nearest
service center
2. Contact the nearest
service center
The content in this instruction manual (include accessories) IS kept the nal
modifying and explanation rights
Appliance is Leaking
Slight leakage from the appliance pump is normal. If the leakage increases
contract the authorized customer service.
Transport Instruction
Mind the weight of appliance during moving. Put the appliance a level
ground. Pull out the telescopic rod (Max. length 410mm, as pic D) to move
the appliance.
6 7
www.PyleUSA.com www.PyleUSA.com
>> STORAGE
1. Place the appliance on a level ground
2. Disconnect trigger gun and high pressure hose
3. Disconnect high pressure hose with outlet
4. Put the trigger gun into the trigger gun holder
5. Wind back power cord and high pressure
Please store the machine properly especially during winter
>> SCHEMATIC DRAWING
AC 110V/60Hz
8 9
www.PyleUSA.com www.PyleUSA.com
SLPRWAS46
PURE CLEAN PRESSURE WASHER
ELECTRIC OUTDOOR POWER WASHER
What’s in the Box:
• Pressure Washer
• Trigger Spray-Gun
Features:
• High-Powered Pressure Washer
• Simple & Hassle-Free Plug-in Operation
• Trigger Activated Spraying Nozzle
• Integrated Liquid Detergent / Shampoo Dispenser Bottle
• Adjustable Water Flow Jet-Stream
• Input Valve for Directly Connecting Water Hose
• Universal Threaded Water Hose Connector
• Compact & Lightweight Design for Mobility
• Water-Resistant Construction Housing
• Convenient Carry Handle & Rolling Wheels
• Used for Cleaning Homes, Cars, Boats, RVs, Driveways & Decks
• Nozzle Wand Attachment
• Water Hose, 16.5’ ft.
• Water Hose Coupling Connector
Technical Specs:
• Max. Pressure: Up to 2030+ PSI
• Power Output: 1800 Watt
• Water Flow: 380L / per Hour (1.67 Gal. per Min.)
• Max. Operating Pressure: 85bar (8.5Mpa)
• Liquid/Detergent Tank Capacity: 400ml
• Marine Grade Rating: IP-X5
• Construction Material: Engineered PP
• U.S. Universal Water Hose Threading
• High pressure Water Hose Material: Reinforced PVC
• Power Cord Length: 35’ ft.
• Power Supply: 110V
• Dimensions (L x W x H): 11.6’’ x 11.6’’ x 21.6’’ -inches
• Sold as: 1
10 11
www.PyleUSA.com www.PyleUSA.com
Loading...