Pyle PSMSP6 User guide

Wall-Mountable with 0.75'' Silk Dome Tweeter

and Aluminum Voice Coils, Pair

To ensure you will be completely satised with this product, read and
understand this manual carefully before use. Keep the manual in a safe place.
The Operating Manual must be passed on to all subsequent users.

IMPORTANT SAFETY PRECAUTIONS

• Make sure to match your speaker and amplier power ratings.
Failure to do so can result in pennanent damage to your speakers.

• Distortion is an indication that amplier or speaker is operating beyond its
design limits. If you hear distortion, immediately turn down the volume to
avoid permanent damage.

• Do not place these speakers on an unstable cart, stand, bracket or table.
The speaker may fall, causing serious injury to a child or adult and serious
damage to the unit.

• Do not use these speakers near water; for example, near a bathtub, sink, in a
wet basement, or near a swimming pool.

• The speakers should be situated away from heat sources such as radiators, heat
registers, stoves, or other devices that produce heal.

• Clean only with a soft damp cloth.

CONNECTING THE SPEAKERS

These speakers are passive and thus require an amplier or receiver to give them
power. They can be connected to any 4 or 8 ohm amplier.
When using the Home Theater Bookshelf Speakers 4 ohm model, you can
connect one speaker per amp channel. When using the 8 ohm model, you can
connect up to 2 speakers per channel as long as your amp is 4 to 8 ohm capable.
If your speakers are relatively close to the signal source (50 feet or less), 16 gauge
wire can be used. For longer distances, 12 or 14 gauge wire is recommended.
Be sure to observe proper polarity by ensuring that the wire from the red speaker
terminal is connected to the red or positive terminal of the signal source and that
the wire from the black speaker terminal is connected to the black or negative
terminal of the signal source.

www.PyleUSA.com

2

The Home Theater Bookshelf Speakers features
5-way binding posts which can accept various
types of connections:

1. Banana plugs can be inserted into the open end
of the binding post.

2. Spade tenninals can be placed around the metal
post and clamped by the screw down cap.

3. Looped wire can be wrapped around the binding
post and clamped by the screw down cap.

4. Straight wire can be inserted into the hole drilled
through the bottom of the binding post and
clamped down by the screw cap.

5. Pin connectors can be inserted into the hole
drilled through the bottom of the binding post
and clamped down by the screw cap.

FEATURES

• Audiophile-Grade Black Woven Glass Fiber Woofer Cone

• Ultra-Stiff Polypropylene Dust Cap on Woofer

• Rubber Surrounds on Woofer

• Silk Dome Tweeter gives Crisp and Realistic Sounding Highs

• Gold-Plated 5-Way Binding Post Terminals can Accept Banana, Bare Wire,
Spade Terminals and more

• Detachable Magnetic Grill

• Wall Mount Hanging Bracket

• 1'' Aluminum Voice Coil

MAGNETIC GRILLS

The grills included with your Home Theater Bookshelf Speakers speakers use
high strength magnets to hold them in place. They can be easily removed for
cleaning or for aesthetic purposes. To remove them, place one nger on each
top corner of the grill and gently pull the grill towards you. To replace, position
the grill squarely over the face of the speaker and it will attach itself. Align the
grill if needed.

www.PyleUSA.com

3

POSITIONING THE SPEAKERS

To place the speakers, start with them placed directly in front of your primary
listening position. Make sure the tweeters are as close to ear level as possible.
As you are listening to music, make sure to pay close attention to the quality
and separation of vocals and instruments. You can move the speakers closer
together or further apart to optimize your listening experience, but make sure
they are set as far away from the listener as each other.

Always listen to several musical selections so that you hear lows (bass), (vocals
and horns), and highs (treble) from a variety of instruments and vocalists.
Allow your speakers a "break in" period before permanently positioning them.
To break-in your speakers: at a moderate to low level, play a variety of music
through the speakers over a day or two.
This will help to prepare them for regular use and optimal performance.

CABINET CARE

The nish of your Home Theater Bookshelf Speakers speakers can be maintained
by periodically wiping it down with a lightly dampened ber cloth.
The grills can be brushed or vacuumed to remove dust.

www.PyleUSA.com

4

TROUBLESHOOTING

PROBLEM SOLUTION

No sound

1. Please make sure your speaker wires/connections are
inserted completely into the speaker terminals and all
connectors are properly seated.

2. These speakers require power, please make sure your
receiver has amplied speaker outputs. If it does not, we
are happy to help you nd the right receiver or amplier
for your set up. Email us at [e-mail].

3. Please make sure your active audio source
(cd, aux, tape, etc.) is selected on your receiver.

SPECIFICATIONS

• Construction Material: Top Quality 12mm MDF with Beautiful Wood Grain Finish

• MAX Power: 240W

PSMSP5

• RMS Power: 40W each, 80W per Pair

• Woofer: 5.25'' Woven Glass Fiber Cone

• Tweeter: 0.75'' Silk Dome Tweeter

• Crossover Slope: 12dB/Octave

• Frequency Response: 75Hz – 20KHz

• Sensitivity: 87dB 1W/1m

• Impedance: 8 ohms

• Product Dimensions (L x W x H): 10.6'' x 6.3'' x 6'' -inches

PSMSP6

• RMS Power: 50W each, 100W per Pair

• Woofer: 6.5'' Woven Glass Fiber Cone

• Tweeter: 0.75'' Silk Dome Tweeter

• Crossover Slope: 12dB/Octave

• Frequency Response: 65Hz – 20KHz

• Sensitivity: 87dB 1W/1m

• Impedance: 8 ohms

• Product Dimensions (L x W x H): 11.8'' x 7.1'' x 6.4'' -inches

www.PyleUSA.com

5

Questions? Issues?

We are here to help!

Phone: [phone]

Email: [e-mail]