Please read these operating instructions before using the unit
and save them for future reference.
Introduction
This is a multifunctional Wireless BT speaker with professional-quality for meetings
at home, in oce or on-the-go. You can use it as a basic Wireless BT speaker too.
If you want to have a better experience, please read this instruction carefully.
Important:
Your speakerphone is shipped from the factory in a deep sleep mode to conserve
battery. Activate your speakerphone by connecting the USB cable to a power
source before rst use.
What's in the Box:
• Conference Speakerphone
• Protective Carrying Case
• USB-C Data Cable
• 3.5mm Aux Cable
At a Glance
1. Phone call button
2. Volume down
3. Power button
4. Mute button
5. Volume up
6. Pause/Play
7. Status LED
8. USB port (type-C) for charging
9. Audio Input port
www.PyleUSA.com
2
Page 3
Connecting
a. Connect to your computer by using a USB-C data cable.
b. Connect to your computer or mobile device via Wireless BT pairing.
Power ON this product for the rst time, it will automatically enter the Wireless
BT pairing mode.
Note: in our sample, usually the Wireless BT pairing name is PYLE Conference
Speaker
Conference Speakerphone
Flashes blue quicklyEnter Wireless BT pairing mode
Flashes blue every 5 secondsWireless BT paired
www.PyleUSA.com
3
Page 4
Each time you power on the product, it will automatically connect with the
last successfully connected device if available.
Powering ON/OFF
Press and hold the power button for 2 seconds to power ON. The status LED will
light on counterclockwise and then fade out. To power OFF, press and hold the
power button for 2 seconds.
Power LED behavior
Flashes light purple slowly and
turns blue and ashes quickly
in circles
Power ON
Flashes red in circles
and light o
Once connected to your computer, it will automatically power ON.
•
Power OFF
• It will automatically power o after 4 minutes of inactivity when the Wireless BT
is not paired.
Button Controls
Press to increase and decrease Volume
Press to Answer/End a call
Press and hold for 2 seconds to reject a call
Press to Mute or restore the microphone
Press to Play/Pause music
www.PyleUSA.com
4
Page 5
Status LED behaviors
• Steady purple: USB connected to computer
• No LED Flash but a “beep”: Incoming call
• Lights up light purple counterclockwise or counterclockwise:
Increase or decrease volume
• Steady red: Muted
• Lights up red: Press Power button to check the battery level
• Steady blue: Aux connected
• Flashes blue every 5 seconds: Wireless BT paired
Charging
Power LED behavior
• Steady purple: Being charged
• Light o: Fully charged
• Flashes red: Low battery
Audio Input
Connect an external audio source to the AUX jack of this product by using an
AUX cable (included). The audio will be played through the speakerphone.