PYLE PMX801 User Manual

OWNERS MANUAL

PMX401

PMX601

PMX802

4 CHANNELS

6 CHANNELS

8 CHANNELS

www.pyleaudio.com

1

FEATURES AT A GLANCE

4,6,8 Balanced microphone inputs, 4,6,8 high impedance microphone/line

Inputs and Tape/CD inputs. All may be used simultaneously. Reverb built in with

individual control on each channel line out for connection to external amplifiers. Record

out jack for taping performances. R.F interference protection on all inputs and outputs.

The powered mixer is not only easy to use and transport, but designed with the latest

technology. The is designed with a strong metal structure, wood cabinet, with vinyl surface,

and metal corners. This makes the ideal powered mixer.

2

SAFETY INSTRUCTIONS

CAUTION: To reduce the risk of electrical shock, do not

remove the cover (or back). No user
serviceable parts inside; refer servicing to
qualified personnel.

WARNING: To reduce the risk of fire or electrical shock, do not

expose this appliance to rain or moisture.

This symbol, wherever it appears,
alerts you to the presence of
uninsulated dangerous voltage.
Inside
the enclosure-voltage that may be
sufficient to constitute a risk of

This symbol, wherever it appears,
alerts you to important operating
and maintenance instructions in
the accompanying literature. Read
the manual.

3

A. FRONT PANEL SECTION FEATURES

1. BALANCE INPUT (MIC)

Electronic Balanced inputs acceptable a standard XLR male connector. It is designed to accept a

4

balanced low impedance input signal, Phantom power (15 volts) for condenser microphones is
always on and available. It has an input impedance of 1K ohm. The connector is wired as: Pin=
shield ; Pin3= negative(cold).

2. BALANCE INPUT(LINE)

Electronic Balanced inputs acceptable a standard 1/4＂ jacks connector. It is designed to accept a
balanced high impedance input signal (This use for connection Deck , Turntable, Keyboard etc… ).

3. VOLUME

This is function to adjust the volume of signal connection into each channel and adjust the volume of
output, together with master fader.

4. TREBLE

This control gives you up to 15 db of boost or cut at 10 kHz and above, and it is also flat at the detent.
Use it to add sizzle to cymbals, and an overall sense of transparency or edge to key-boards, vocals,
guitar, and bacon frying. Turn it down a little to reduce sibilance, or to hide tape hiss.

5. LOW

This control gives you up to 15 dB boost or cut at 100Hz and below. This circuit is flat (no boost or
cut) at the center detent position. This frequency represents the punch in bass drums, bass guitar, fat
synch patches, and some really serious male singers.

5

6. EFF

This is a send control to the reverb buss, It controls the amount of reverberation added to the input
Signals.

7. GRAPHIC EQUALIZER

2×5-band equalizer is provided for tone control over each frequency , and for precise high quality
sound by final tone control. It can control main channel and rec channel.( 60,250,1K,2K,8KHz )
shelving at +/-12dB).

8. VOLUME
Using by this control, you can adjust signal level of phone.

9. PHONE
Phone output jack.

10. OUTPUTS LEVEL INDICATOR

This is level meter which shows output levels of left & right channel condition on the way of
operation, therefore, you can see output condition thru this master level indication.

11.POWER LED
It lights when power switch turn on.

6