Pyle PLVW-1342 Owners manual

Specifications

Screen Size: 13 inch 4:3TFT
System: PAL/NTSC
Display Method: TFT Active matrix system
Power source/Consumption: DC12V+/-20%, 15W
Storage Temperature: -10 ~ +85
Display Method : Color LCD
Monitor dimension: 325x275x30mm
Pixs: 800x600
Weight: 900g

13 TFT LCD COLOR MONITOR

Cautions

Never connect the car adaptor to cigarette lighters for such as trucks

or buses which use 12V DC power.

Do not expose the monitor to high humidity, dust, steam,oily smoke,

direct sunlight etc.

For your safety, turn power OFF when not in use and unplug the adaptor.
Never attempt your own maintenance. Consult your TV dealer or the

company.

Avoid dropping and strong impact.
For your safety, the driver should not watch the Monitor or operate the

controls while driving.

Accessories

1xRemote control 1xinstruction manual

WARNING:
DO NOT WATCH MONITOR WHILE VEHICLE IN MOTION.
IT CAN BE HAZARDOUS.

Instruction Manual

WARNING:
HAZARD DO NOT OPERATE THIS
UNIT UNLESS VEHICLE IS PARKED
IN SAFE AND LEGAL AREA

5

PLVW1342

REMOTE CONTROL BATTERY

Thank you for the purchase of this roof mounting 13inch TFT-LCD
monitor .Before operating the unit ,please read this manual
thoroughly and keep it for future reference.

Back of the remote

Battery tank

Battery

Transparent slice

1.Always use new batteries when replacing the old set .

2. Do not attempt to charge ,short-circuit ,disassemble ,heat or burn
used batteries.

3.Battery replacement is necessary when remote control acts
sporadically or stops operating this device.

4.Do not place objects between the remote control and remote receiver.

5.If the monitor does not operate even when operating the remote
control from a colse rangre ,it is time to replace the batteries
Product number :(cr2025)

INSTALLATION

The device is an overhead ,fold-down 13 inch monitor with an infrared
ir eye .It will accept a video signal from any video source with composite
videout .

1.Look over the vehicle for a location for the monitor .Each vehicle
is different and locations will vary .Make sure the monitor will not
interfere with the driver.

2.Once a location has been determined ,connect the IR ,A/V RCAs
and Powercables to the designated sources.

3.Feed the cables through the hole in the mounting bracket and
screw the bracket to the head liner ,Use short screws so as not to
damage the roof.

4.Plug the cable into the monitors 6 pin din connector .Mount the
monitor with the provided hardware.

PREAUTIONS

The set is for use in DC12V ,negaive ground vehicles.
Do not operate the set in ways other than described in this guide .Doing
so may damage it and may void your warranty.
SAFETY FIRST FOR REAR SEAT USE ONLY .Do not install on dashboard
or any where else that would permit monitor to be viewed by the driver .
Monitor must never be used in any manner that will distract driver or
interfere with the drivers
safe operation of the monitor vehivle.
Be careful not to run down the car battery while using the set with the
car stopped.Do not disassemble or modify the set .Doing so may damage
it and voids your warranty.
Keep drinks and drops from numberllas away from the set .Water may
damage the internal circuitry.
Do not let the set become hot .If temperature in the car is high or the
set has been exposed to direct sunlight and is hot ,lower the temperature
before using it .In extremely cold temperature ,the movement of the
picture may be slow and the picture may be dark ,but this is not a
malfunction .The set will work normally once the temperature increases.

4

1