Page 1
Introduction
The device measures
inH20.
It features
11
InHg,
Hold
years
2
mmHg,
ozin
and
Auto
Power
of reliable service.
Gauge/Differential
selectable units
FtH20,
,
Off
disabled.
Pressure from 0
of
measure:inH20,
cmH2 0, kgcm,Additional features indude Data
Careful
use
of
this
inH20
to
2078
psi, bar, mbar, Kpa,
meter
will
provide
Specifications
Function Range Resolution
InH20
2078
5168
517.1
15.00
3878
Pressure
Time
Indicator
0.01
0.1
0.01
Psi 75.00
Mbar
kPa
inHg
mmHg
Display
Accuracy
Repeatability
linearity/Hysteresis
Maximum
Response
Low Battery
Over
Range Indicator
Under
Range Indicator
Operating Conditions
Storage Conditions
Power
Supply
Standard Accessories
Function
Range
ozin'
1200
FtH20
173.0
5272
cmH20
2
5.250
Kgcm
Ba.
5.138
Dual
LCD
±O.3%FSOI25°q
±0.2%{Max+/-O.5%FSO)
±0.29%
FSO
150psi
0.5Seconds typical
Ye,
Err.l
Err.2
32°F
to
122°FIO
to
14°F
1 X
Pouch
9Y
500q
to
140FC(-1
to
60°C)
Battery (induded) or
&.Tubing
Resolution
0.1
0.001
0.001
External
9YDC
PYLE®
PDMM15
Digital
Manometer
1 1
WWW.PYlEHUDlo.com
Display
1.
Hold
Function
2.
Differential
3.
Primary
4.
Record
5.
MAX/MIN/AVG
6.
Low
Battery Indicator
7.
Pressure
8.
Relative
.1
.1
Description
Mode
Data Screen
Mode
Unit
Indicator
Time
Clock
Button
The
meter
1.
UNITS
2.
DlF
3.
HOLD
4. ON/OFF
A.
REC
B.
BACKLIGHT
1
D
Operation
1.
Power
Press
has
six
buttons.
the ON/OFF button
a short
selF-test
the last operation.
2.
Zero
Before
use and without
for
more than 2 seconds
"'
000"
from
If
it
is
desired
taking a measurement subsequent reading
current measurement and the measurement that was
DIF
button
3. Data
Press
the HOLD
HOLD icon
HOLD button again
4 Record
The
MAX/MIN
(MIN) or anerage
1.
Press
the
Functions
clock also appears
2.
Press
the
Display
recorded.
to
turn
power
when turned on.
Adjust
and
fittings
to
right
to
left.
0.000
to
offset the meter and display, press the
was pressed.
Hold
button
momentarily
will
appear
on
to
return
mode allows the user
(AVG)
REC
button once and RECappears
are locked out except for Power &
in
the secondary display and starts counting.
REC
button again and
is
now
shOWing
on
The
meter defaults
OHset
attached
to
zero the
meter.
will
be display.
to
freeze the displayed reading the
the upper left-hand side of the display. press the
to
normal
operation.
to
view only the highest (MAX), lowest
readings
with
relative
MAX
the
maximum
or
off.
The
meter
will
perform
to
the setting used during
the meter, press the HOLD button
The
meter
will
reset and display
DIF
button
on
the display when the
stamp.
the display
(All
The
relative
time
while
other
The
time
it
was
will
be the difference between the
time
on
Backlight).
appears on the display.
pressure and relative
3.
Press
the
REC
button
time.
4.
Press
the
REC
button
relative
time.
5.
Press
the
REC
button again
measurements.
6.
To
exit
the MIN/MAX/AYG mode, press the
return
to
normal operation.
7.
Backlight
Display
Press
the Backlight
40
seconds.
8. Automatic
9.
Error
An
diagnostic
1.
2.
3.
4.
BaHery
When the battery power
the
Power
The
meter
will
automatically
To
disable
Auto
an
disabled.
Units
Press
available
the display.
error message
Err.
Err.
Err.
Err.
9Y
Power
"'nit
will
appear
in
The
meter
will
the
Unit
button
units
of measure as indicated by the cursor
Codes
will
appear
test.
1:
Pressure value
2:
Pressure value
3:
DIF
function,
4:
battery.
the differential pressure value
DIF
function, the differential pressure value
Replacement
to
display the
minimum
MIN
reading
to
display the average value AVG reading
to
continue recording
button
to
turn
OFF
shut
off after
OFF,
hold
down the
the display indicating that
return
to
normal operation when
momentarily and the meter
on
the display
is
over
the
range.
is
below
the
falls
low,
"BAT"
on
the backlight.
range.
will
20
hold
if
appear
REC
minutes
the meter
MIN/MAX/AVG
button
It
will
to
button and
Auto
Power
will
cyde through the
on
fails
is
over range.
is
below range.
on
the
with
the relative
with
for
3 seconds
remain
on
conserve battery
turn
on
the
OFF
mode
it
is
turned
off.
the button of
an internal
LCD.
Replace
the
for
to
meter,
is
11
life.
Loading...