Page 1
Snowmobile Storage Cover
MODEL: PCVSNM12, PCVSNM13, PCVSNM14
Cleaning and Care
Clean your cover with a soft brush and some
lukewarmwater. It may also be machine washed in
A C
B
CAUTION!
Do not use while transporting your snowmobile — the
cover could blow o and cause injury to others.
COLD water.
DO NOT USE SOAP, as it may remove the protective
coatings added by the factory. Line dry or machine
dry on air or delicate.
Storage
A handy storage sack is attached to the rear of your
cover. Be sure the cover is completely dry before
you store it in the sack for an extended period.
Installation
1. Cover any sharp points (such as a windshield corner)
with cloth or a sponge to avoid stressing your cover
when it is stretched tight across your snowmobile.
2. Find the white label with arrows sewn in the hem of
the cover–this is the front of your cover. Now stretch
the cover down over your snowmobile.
3. Locate the strap [A] in the middle of your cover
(Fig. 1). From where the strap attaches to the cover,
run the strap end with the male buckle under your
snowmobile and then back up to clip it into the female
buckle. Tighten the strap so that is snug, but not
cinched completely tight.
4. Run the forward strap [B] under your snowmobile
behind the ski struts and connect it into the buckle on
the opposite side.
5. Run the rear strap [C] under the tail of your
snowmobile into the buckle on the opposite side.
Tighten all the straps as necessary for a tight t on
your snowmobile.
Loading...