Pyle PCA2 User guide

USER’S MANUAL

STEREO

POWER AMPLIFIER

PCA2

CONTROLS

1. Power ON LED Indicator: Lights to indicate power is turned ON.

2. Treble Tone Control: Lets you boost or attenuate treble for the desired sounds.

3. Bass Tone Control: Lets you boost or attenuate bass for the desired sound.

4. Master Volume Control: Lets you adjust the overall sound level.

5. RCA L/R LINE Input: Lets you connect the desired LINE input source.

6. Push Type Speaker L/R Terminals: Lets you easily connect speaker wires directly to the Amplifer.

7. Voltage Selector: Lets you slect the voltage of AC power input source. The amplifer has selectable
input voltage from 110V/60Hz which is the standard in USA and CANADA. You can also switch the
input voltage to 230V/50Hz for EUROPEAN operation. Please make sure the switch is in the proper
position before operating otherwise sever damage will result not cover by the warranty. Please also
replace the fuse with proper rating in this situation (see the next instruction for the fuse rating).

2

8. Fuse: The amplifer uses a fuse for protection against surges and short circuit. If the amplifer suddenly
turns OFF and will not urn ON, check the fuse. If necessary, replace it with a 1-amp, 250V, fast-acting,

5 x 20mm fuse (not supplied).

9.AC IN

-AC Input

IMPORTANT

Replacing a fuse
This amplifer requires a fuse with proper rating for protection from power surges and short circuits. If
the amplifer suddenly turns off or will not turn on, the fuse is may be blown.

• Let the amplifer cool down and see if it start again before you assume the fuse to be replaced.

• Unplug the amplifer from the AC outlet.

• Turn the fuse holder cap and pull out the cap.

• Remove the old fuse and replace it with an identical one.

CAUTION: Never use a fuse with a higher rating.

Connecting two 4-8 ohm speakers in stereo mode

3

TROUBLESHOOTING

No Power The fuse might be blown

Sound source or speakers not
connected properly.

MASTER volume control set to
minimum.

No Sound

The speaker’s wire might be the
wrong impedance.

The amplifer might has shut
down.

STEREO POWER AMPLIFIER
FEATURES AND SPECIFICATIONS

Check the amplifer’s fuse and re ­place it if necessary.

Check all connections.

Adjust the volume control to de­sired settings.

Make sure all connected speak­ers have the same impedance
rating,

Turn the amplifer off and let it
cool. Make sure the amplifer is
properly ventilated, and then turn
it back on.

• Harmonic Distortion: 0.3%

• 2 x 40 Watt Peak at 4-Ohm

• Blue LED Output Level Display

• Frequency Respone: 20Hz-40kHz

• Power Fuse: 1.5 A, 250V Fast-Acting (5 x 20mm)

• Power Requirement: 120V AC 50Hz/230V AC 50Hz

• Tone Controls: Bass & Treble: +/-10dB (100Hz/10kHz)

• Dimensions: 6.3"; W x 2.72"; D x 4.7"; H (190 x 70 x 137mm)

• Sold as: Unit

• Weight: 3.56 lbs.

4