PXM PX106, PX105, PX114 Instruction Manual

INSTRUCTION

MANUAL

DMX

Demultiplexer

PX106 (128 channels)

PX105 (64 channels)

PX114 (32 channels)

R

CONTENTS

1. General description...................................................................

2. Safety conditions.......................................................................

3. Rules of creating the DMX installation......................................

4. DMX starting address setting....................................................

5. Front panel view........................................................................

6. Programmable parameters.......................................................

7. Demultiplexer programming......................................................

8. DMX signal connection.............................................................

9. Analog signals connection.........................................................

10. Technical specification...............................................................

11. Declaration of conformity...........................................................

1

1

2

2

3

4

4

5

5

5

6

Manufacturer reserves the right to make modifications in order to improve device operation.

PXM s.c.
ul. Przemysłowa 12
30-701 Kraków
POLAND

tel.: [phone]
fax: [phone]
E-mail: [e-mail]
Internet: www.pxm.pl

1. GENERAL DESCRIPTION

1

2. SAFETY CONDITIONS

DMX Demultiplexer PX105 / PX106 / PX114 is powered from standard 230 V grid, what
can cause electric shock when safety rules are not observed. Therefore it is necessary to observe
the following:

1. The device installation can be performed by a person holding the appropriate qualifications
only, according to the description in the instruction manual.

2. Demultiplexer can be connected to socket which has protecting instalation in working order (3

- wire grid) only.

3. All the conductors should be protected against mechanical and thermal damage.

4. In the event of damaging any conductor, it should be replaced with a conductor of the same

technical data and attestations.

5. All repairs demanding casing opening should be made with cut off power supply.

6. Demuliplexer should be strictly protected against contact with water and other liquids.

7. All sudden shocks, particularly dropping, should be avoided.

8. Device with damaged (cracked) casing should not be connected to the mains.

9. The device cannot be turned on in places with humidity exceeding 90%.

o o

10. The device cannot be used in places with temperature lower than 2 C or higher than 40 C.

11. Cleaning only with damp duster - demultiplexer has to be cut off the power supply.

directly

DMX Demultiplexer is a converter, that enables the co-operation of a DMX system with the
devices controlled with the analog signal. The received DMX signal is decoded and sent to the
outputs as the standard 0 / +10 V analog signals.
PX106 DMX Demultiplexer is a proffesional device that can receive the data from 128 DMX
channels and convert them into the 0 / +10 V analog form.The device maintenance is very simple

- after the signal cables are connected and the DMX starting address is set the receiver is ready to
operate. The DMX starting address is set with the four buttons and the alphanumeric display.
The device is manufactured in a standard 19'' 1U mechanics, adapted for stand mounting.
PX106 is also equipped with the DMX signal LED indicator and the control buttons, that allow to
test the outputs.

Depending on the number of analog outputs, 3 versions of demultiplexer are manufactured:

PX106 - 128 outputs
PX105 - 64 outputs
PX114 - 32 outputs