PVI Industries 54 P 90A-MXG, 40 P 90A-MXG User Manual
MAXIM • PACKAGED GAS WATER HEATER
POLYSHIELD® POLYMER-LINED STORAGE TANK
90 GALLON TANK SERIES
MODEL NUMBER
GPH Recovery at 40° to 120° F 500 670
GPH Recovery at 40° to 140° F 400 540
Input Btu/h 399,000 540,000
* Minimum inlet flow gas pressure – " W.C. 4.5 4.0
A Cold Inlet - NPT 2 2
B Hot Outlet - NPT 2 2
C Drain - NPT 1 1
D I - Beam Skids 3 x 34-1/2 3 x 34-1/2
F Overall Height 64 72
G Flue Outlet Diameter 7 8
H Gas Inlet - NPT 3/4 1
J Motor HP 120 V, 1Ø, 60 Hz. 1/3 1/3
K Motor Amps 8 8
L Height to Outlet 53 61
M Height to Inlet 28 36
Approx. Shipping Weight - lbs 1010 1130
Recoveries based on 83% thermal efficiency. ASHRAE 90.1 compliant.
Dimensions are in inches unless otherwise specified.
* The information presented is for natural gas 0.6 S.G. – For operation with propane (LP gas), consult the factory.
For standard and optional equipment, see form # PV 6141.
40 P 90A-MXG 54 P 90A-MXG
1. Control Enclosure
2. ASME Temperature &
Pressure Relief Valve
3. 3” NPT Handhole
STANDARD GAS PRESSURE REQUIREMENTS:
SEE TABLE FOR MINIMUM PRESSURE BY MODEL NUMBER.
MAXIMUM STATIC INLET GAS PRESSURE: 14" W.C.
FOR GAS PRESSURES OUTSIDE OF THIS RANGE,
CONTACT YOUR PVI REPRESENTATIVE.
STANDARD ELECTRICAL REQUIREMENTS:
CONTROL VOLTAGE: 120V, 1Ø, 60 HZ., 2 AMPS
MOTOR VOLTAGE: 120V, 1Ø, 60 HZ.
SEE ABOVE CHART FOR BLOWER MOTOR AMPS
THE ENTIRE VENT SYSTEM SHOULD NEVER BE SIZED BASED UPON THE
FOR PROPER VENT SIZING, CONSULT THE NATIONAL FUEL GAS CODE
PVI RESERVES THE RIGHT TO CHANGE THE DESIGN AND
PVI INDUSTRIES, LLC
FORT WORTH, TEXAS 76111
PV 6291 9/07 (800) 784-8326 • www.pvi.com
VENTING REQUIREMENTS:
-.02" TO -.06" W.C. (NEGATIVE PRESSURE).
TYPE B VENTING
VENT CONNECTION DIAMETER EXCLUSIVELY.
UNDER "FAN-ASSISTED".
SPECIFICATION WITHOUT NOTICE
Product is patented in the U.S., Canada, and Mexico.
Loading...