PVI Industries 250P225A-TPL User Manual
LOW NOx TURBOPOWER® • PACKAGED WATER HEATER
4
POLYSHIELD® POLYMER-LINED STORAGE TANK
TANK SERIES 225 GALLONS VERTICAL
MODEL
NUMBER
250 P 225A-TPL 250 200 199,000 4.5 2TPL 199 MBtu/h 27 4 1/2 16 1/3 8 1230
375 P 225A-TPL 375 300 300,000 4.5 3TPL 299 MBtu/h 27 4 3/4 16 1/3 8 1240
500 P 225A-TPL 500 400 399,000 4.5 4TPL 399 MBtu/h 27 5 3/4 16 1/3 8 1250
c Recoveries based on 83% thermal efficiency. ASHRAE 90.1 compliant for efficiency and standby loss.
d “J” dimension is for the burner housing only – gas train may exceed this dimension.
e Standard gas train.
* The information presented is for natural gas 0.6 S.G.
Dimensions are in inches unless otherwise specified.
For standard and optional equipment, see form #PV6550.
Recovery gph
0° - 120°F 40° - 140°F
c
INPUT
Btu/h
Min. Inlet
Flow Gas
Pressure
" W.C. e
SCAQMD Energy
Model No.
Dimensions (inches)
A B C J d HP Amps
Blower
Motor
Shipping
Weight
lbs
STANDARD GAS PRESSURE REQUIREMENTS:
SEE TABLE FOR MINIMUM PRESSURE BY MODEL NUMBER.
MAXIMUM STATIC INLET GAS PRESSURE IS 14" W.C.
FOR GAS PRESSURES OUTSIDE OF THIS RANGE,
CONTACT YOUR PVI REPRESENTATIVE.
VENTING REQUIREMENTS:
-.02" TO -.06" W.C. (NEGATIVE PRESSURE).
TYPE B VENTING.
ENTIRE VENT SYSTEM SHOULD NEVER BE SIZED BASED UPON
THE VENT CONNECTION DIAMETER EXCLUSIVELY. CHECK
NATIONAL FUEL GAS CODE UNDER "FAN ASSISTED."
CONTROL VOLTAGE: 120V, 1Ø, 60 HZ., 2 AMPS.
MOTOR VOLTAGE: 1/3 HP ARE 120V, 1Ø, 60 HZ.
208V, 230V AND 460V MOTORS ARE AVAILABLE BUT WILL
REQUIRE A SEPARATE 120V/2 amps CONTROL CIRCUIT OR AN
OPTIONAL CONTROL CIRCUIT TRANSFORMER.
STANDARD ELECTRICAL REQUIREMENTS:
PVI RESERVES THE RIGHT TO CHANGE THE DESIGN AND
SPECIFICATION WITHOUT NOTICE.
Product is patented in the U.S., Canada, and Mexico.
PVI INDUSTRIES, LLC
FORT WORTH, TEXAS 76111
PV 6554 02/25/04 (800) 784-8326 • www.pvi.com
Loading...