PVI Industries 1000PHE125A-TPGO, 750PHE125A-TPGO, 1500PHE125A-TPGO, 1250PHE125A-TPGO User Manual
TURBOPOWER® GAS/OIL PACKAGED WATER HEATER
POLYSHIELD
®
POLYMER-LINED STORAGE TANK
TANK SERIES 125 GALLONS
HORIZONTAL
Model
Number
Recovery gph
40°- 120°F 40°- 140°F A B C J HP
Input
Btu/h
Min. Inlet Flow
Gas Pressure
"W.C.
#2 Oil
Dimensions (inches)
gph
750 PHE 125A-TPGO 750 600 600,000 4.5 4.3 42 6 1 31 1/2
1000 PHE 125A-TPGO 1000 800 800,000 6.0 5.7 42 8 1 31 1/2
1250 PHE 125A-TPGO 1250 1000 1,000,000 7.5 7.2 42 8 1 31 3/4
1500 PHE 125A-TPGO 1500 1200 1,200,000 7.5 8.6 42 8 1-1/4 31 1
Recoveries based on 83% thermal efficiency. ASHRAE 90.1 compliant for efficiency and standby loss.
“J” dimension is for the burner housing only. Gas train may exceed this dimension.
Standard gas train.
* The information presented is for Natural gas 0.6 S.G.— For operation with propane (LP gas), consult factory.
Dimensions are in inches unless otherwise specified.
Burner control panel requires 18" clearance for door swing.
For standard and optional equipment, see form PV 6047.
Blower
Motor
Volt/Ph/
Amps
115/1∅/10
115/1∅/10
115/1∅/14
115/1∅/16
Shipping
Weight
lbs
1420
1460
1550
1630
* GAS PRESSURE REQUIREMENTS
SEE TABLE FOR MINIMUM PRESSURE BY MODEL NUMBER.
MAXIMUM STATIC INLET PRESSURE: 14" W.C.
FOR PRESSURES OTHER THAN LISTED, CONSULT FACTORY.
Pressure shown is for standard UL gas train. Additional controls
may increase pressure requirements.
VENTING REQUIREMENTS
-.02" TO -.06" W.C. (NEGATIVE PRESSURE)
ENTIRE VENT SYSTEM SHOULD NEVER BE SIZED BASED
UPON THE VENT CONNECTION DIAMETER EXCLUSIVELY.
FOR PROPER SIZING, CONSULT
THE NATIONAL FUEL GAS CODE UNDER “FAN-ASSISTED.”
PVI INDUSTRIES, LLC
FORT WORTH, TEXAS 76111
PV 5477 02/04
(800) 784-8326
* REAR ACCESS MODULE
MODEL PREFIX M L STD or OPTIONAL
750-1500 23" N/A OPTIONAL
STANDARD ELECTRICAL REQUIREMENTS
CONTROL VOLTAGE: 120V, 1Ø, 60 HZ., 2 AMPS.
MOTOR VOLTAGE:
208V, 230V, AND 460V MOTORS ARE AVAILABLE BUT WILL
REQUIRE A SEPARATE 120V/2 amps CONTROL CIRCUIT OR AN
OPTIONAL CONTROL CIRCUIT TRANSFORMER.
PVI RESERVES THE RIGHT TO CHANGE THE DESIGN
(817) 335-9531 www.pvi.com
AND SPECIFICATION WITHOUT NOTICE.
Product is patented in the U.S., Canada, and Mexico.
Loading...