PureEffect ULTRA Installation Instructions Manual

1

Thank you, and Congratulations on your purchase of The PureEffectTM ULTRA Water Filtration System

Featuring our: All-Natural FluorSorbTM Anti-Fluoride, AntiRad-PlusTM Anti-Radiation, SuperBlockTM Anti-

Chemical, KDF55

®

Heavy Metal Filtration and Natural Alkalization Technologies.

INSTALLATION INSTRUCTIONS

(Please read carefully)

Carefully remove and inspect your new filter system for any possible transportation damage. If
any damage is found, please notify us promptly.

1. ❏ Unscrew the housing chambers with included wrench and remove the cartridges.

Position filter unit on your kitchen countertop close enough to the sink to ensure that any
excess water coming out of spout will drain properly. *Keep filter out of direct sunlight.

2. ❏ Unscrew your existing faucet aerator head and replace it with the included Diverter

Valve (see diagram below), hand tighten. You may need an adapter (included)
depending on faucet type. *Plumbers Tape around the threading can help if there are
any leaks.

3. ❏ Turn unit upside down and find the flow indicators “IN” and “OUT” engraved into the

plastic near each port. Screw the Plastic Water-In Elbow into the “IN” port & Spout

Elbow into the “OUT” port, then insert Spout into Spout Elbow. (If you need to
position unit on left side of your sink, switch the wall-mount bracket from back to front of
unit, then turn unit around).

Customer Support:

Tel: [phone]

Email: [e-mail]

www.PureEffectFilters.com

Spout Elbow !

“OUT”

Spout !

" Water-In Elbow

“IN”

2

4. ❏ Next, Insert one end of the provided Tubing into the “Water In elbow” until it “pops-

in” as far as it can go, then measure how much tubing you will need to comfortably reach
the faucet diverter valve and attach to diverter by: unscrewing the metal ring (off the
diverter output) and putting the tubing through the ring, then attach the tube and screw
ring back on to secure. (note: make sure to factor in enough “slack” in tubing for when

you move your faucet around.

5. ❏ Remove shrink wrapping and insert the first two cartridges only: SuperBlockTM

Cartridge into Chamber # 1 and FluorSorbTM Cartridge into Chamber #2 and screw
the chambers closed, close Chamber # 3 empty for now (do not over tighten chambers).
Initiate cartridge flush, instructions on next page.

IMPORTANT! – PLEASE ENSURE CARTRIDGES ARE INSERTED IN

CORRECT ORDER!

#3 #2 # 1

AntiRad-Plus

TM

| FluorSorbTM | SuperBlock

TM

Close this last

chamber empty

for now.