Pulse Performance Products ATV QUAD Owner's Manual

ELECTRIC QUAD
OWNER’S MANUAL

FOR USE WITH THE FOLLOWING PULSE PERFORMANCE PRODUCTS™

•

ATV QUAD

DO NOT RETURN TO STORE! QUESTIONS OR COMMENTS?
CALL (866)-434-6067

05. 19. 17

Table of Contents

Safety and Warnings 2-3
Before You Start 4
Assembly
Hardware Maintenance 7
Before You Ride 7
Repair and Maintenance 8-12
Troubleshooting 13
Motorbike Components 14
Warranty 15

5-6

Safety and Warnings

WARNING: Riding an electric quad can be a dangerous activity. Certain conditions may cause components to fail without fault of

the manufacturer. This quad can and is intended to move and it is therefore possible to lose control, fall off and/or get into dangerous
situations that no amount of care, instruction or expertise can eliminate. If such a thing does occur you can become seriously injured or die,
even when using safety equipment and other safety precautions. RIDE AT YOUR OWN RISK AND ALWAYS USE COMMON SENSE.

This manual contains many warnings and cautions concerning the consequences of failing to inspect, maintain or properly use your electric
quad. Since any incident can result in serious injury or even death, we do not repeat the warning of possible serious injury or death each
time such a possibility is mentioned in this manual.

APPROPRIATE RIDING ATTIRE

Always wear proper protective equipment such as:

• Approved safety helmet. (Helmet may be legally required by local law or regulation in your area.)

• Elbow pads and knees pads

• Long sleeved shirt, long pants

• Gloves

• Lace up shoes with rubber soles, never ride barefooted or in sandals, and insure that shoelaces are tied and kept out of the way of the
wheels and drive system.

RIDER USE AND PARENTAL SUPERVISION

RIDER MUST NOT EXCEED THE WEIGHT LIMIT OF 120 pounds (54kg). Rider weight does not always mean a person’s size is appropriate

This manual contains extremely important safety information. It is your responsibility to completely review this information and make sure that
all riders understand all warnings, cautions, instructions and safety topics and assure that all riders are able to safely and responsibly use this
motorbike. Pulse Performance Products™ advises that you periodically review and reinforce all information in this manual with all riders, and
that you inspect and maintain your motorbike to insure their safety.

parent’s decision to allow their child to use this motorbike should be based on the child’s maturity, skill and their ability to follow rules.

Do not touch the motor or brakes on the quad when in use or directly after use as these parts can become extremely hot.

Keep this quad away from small children and remember that it is intended for use only by persons who are, at a minimum, completely
competent and comfortable while operating this product.

RIDING PRACTICES AND CONDITIONS

Check and obey any local laws or regulations which may affect the locations where the electric quad may be used.

Always ride defensively. Watch out for obstacles that could catch your wheel or force you to turn suddenly or lose control. Be careful to avoid
pedestrians, other wheeled products (such as skaters, skateboards, scooters, bikes, etc.), children or animals who may enter your path.
Always respect the rights and property of others.

Do not activate the throttle on the hand grip unless you are on the quad and in a safe, outdoor environment that is suitable for riding.

Do not attempt or perform stunts or tricks on this electric quad.
or any other type of misuse or stunts.

2 Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call [phone].

This product is not made to withstand abuse from jumping, curb grinding

Safety and Warnings

To reduce the risk of injury, adult supervision is required. Never use in roadways, near motor vehicles, on or near steep inclines or steps,
swimming pools, or other bodies of water.

Maintain a hold with both hands on the handlebars at all times.

Never allow more than one person at a time to ride the quad.

, steering system, wheels and all other moving components.

Never ride while using a cell phone or wearing headphones.

Never hitch on to or with another vehicle or pull anyone or anything.

Never immerse the quad in water; electrical and drive components could be damaged by water or create other possible unsafe
conditions.

ater, mud, ice,
bumpy, uneven, slick, or rough surfaces could impair traction and contribute to possible loss of control. Avoid excessive speeds that can occur
from downhill rides which could cause loss of control.

Do not ride at night or in areas of limited visibility.

originally supplied by the manufacturer are in proper place and in serviceable condition.

That any and all axle guards, chain guards, or other covers or guards supplied by the manufacturer are in place and in serviceable condition.

Persons with the following conditions shall be cautioned not to operate: Those with heart conditions, pregnant women, persons with head,
back, or neck ailments, or prior surgeries to those areas of the body. Persons with any mental or physical conditions that may make them
susceptible to injury or impair their physical dexterity or mental capabilities to recognize, understand, and perform all of the safety instructions
and to be able to assume the hazards inherent in unit use.

Maximum operating speed is 7 MPH (11 KM/H).

Before each ride the following checks will need to be performed to the electric quad:

• Ensure that the brake system is functioning properly.

• Components shall be maintained and repaired in accordance with the manufacturers authorized replacement parts with installation
performed by dealers or other skilled individuals.

USING THE BATTERY CHARGER

The battery charger should be regularly examined for damage to the cord, plug, enclosure and other parts. In the event of such damage, if
any is found, the quad should not be charged until the battery charger has been repaired or replaced.

Use only with the supplied battery charger.

Always use caution when charging.

The battery charger is not a toy and should be operated by an adult.

Disconnect the battery charger and unplug from quad when not in use.

Do not exceed recommended charging time.

Always disconnect the battery charger from the quad prior to wiping down and cleaning with any liquid.

FAILURE TO HEED TO THE WARNINGS LISTED ABOVE INCREASES RISK OF POTENTIAL SERIOUS INJURY. USE THE
APPROPRIATE CAUTION WHEN RIDING AND ALWAYS WEAR PROTECTIVE GEAR.

3Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call [phone].

Before You Start

WARNING: Remove all packing and items from the display box. Make sure that the power switch is turned “OFF”

before assembling the quad.

NOTE: the ATV Quad is to be assembled by an adult.

Estimated Assembly Time

• Allow up to 15 minutes for assembly, not including initial charge time.

• Allow up to 14 hours for the initial charge

(see page 6 for charging information).

Brake lever

Throttle

On/Off switch

Battery charger
(included)

Required Tools

10mm/8mm
wrench
(included)

Phillips screwdriver

components may or may not be compatible with the design and will void the warranty.

Charging port

Air/tire pump with

5mm hex
wrench
(included)

6mm hex wrench
(not included)

pressure gauge for
schrader type valves
(not included)

WARNING: DO NOT USE NON-PULSE PERFORMANCE PRODUCTS™ PRODUCTS WITH YOUR

Altering of the original

4 Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call [phone].

Assembly

Handlebar Assembly

Tools required: 5mm hex wrench, 10mm wrench

C

A

E

B

F

D

1. Align handlebars vertically and horizontally
onto clamps (A&B). Install the 4 clamp bolts 5mm hex wrench (E) and 10mm wrench (F).
(C) and lock nuts (D) and hand tighten.

2. Tighten bolts evenly and securely with a

3. Check to ensure handlebars are tight by
applying pressure before riding, handlebars
should not move backwards or forwards.

NOTE : The gap between the clamps (A&B) should be the same on both sides of the handlebar.

Tools required: Air/tire pump

air pressure maybe lost between the manufacture date and your
purchase date.

Using a hand pump with a Schrader-type valve and pressure gauge

not recommended to use pressurized system similar to the ones found

have much higher air capacity volumes.

INFLATION

tires to the recommended PSI called out on the tires. Replace the
valve caps.

ENSURE ALL TIRES ARE AT THE CORRECT PSI
BEFORE RIDING THE QUAD.

REAR TIRE PSI: 30 MAX

WARNING: It is important to routinely check and maintain

tire pressure as this directly impacts the safety and performance

damage to the tires or the wheels.

5Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call [phone].