CAL. V110
SOLAR WATCH
● POWERED BY LIGHT ENERGY
● NO NEED FOR BATTERY CHANGE
● LASTS FOR 5 MONTHS AFTER FULL CHARGE
● OVERCHARGING PREVENTION FUNCTION
ENGLISH
English
2
DISPLAY AND CROWN OPERATION
Hour hand Minute hand
a b
CROWN
a) Normal position : Free
b) Extended position: Time setting
✩
The solar cell is installed under the dial.
HOW TO CHARGE AND START THE WATCH
TO CHARGE THE WATCH
● When you start the watch or when the energy in the rechargeable battery is
reduced to an extremely low level, charge it sufficiently by exposing the watch
to light.
● When the watch is exposed to sunlight or strong artificial light (of more than
3,000 lux), it will start operating.
1 Expose the watch to sunlight or strong
artificial light.
* See the table on the next page.
▲
2 When the watch is charged after it has
completely stopped, set the time before
wearing the watch.
* See also “GUIDELINE OF CHARGING TIME”
on page 5.
English
3
Illumination
(lux)
3,000 50 minutes
5,000 25 minutes
10,000 12 minutes
100,000
NOTES:
1. It is recommended that you charge the watch for more than the time required until
the watch operates steadily. (See “GUIDELINE OF CHARGING TIME” on page 5)
2. It is not necessary to charge the watch fully. It is important, however, to charge
the watch sufficiently, especially in case of initial charge.
English
Time required until
the hands start moving
2 minutes
*
* The time required until the
watch starts operating after
it has completely stopped.
CAUTION
Caution for charging
● When charging the watch, do not place it too close to a photoflash light, spotlight,
incandescent light or other light sources as the watch temperature will become
extremely high, causing damage to the parts inside the watch.
● When exposing the watch to sunlight to charge it, do not leave it on the dashboard
of a car, etc. for a long time, as the watch temperature becomes extremely high.
● While charging the watch, make sure the watch temperature does not exceed 50° C.
4
GUIDELINE OF CHARGING TIME
Illumina-
tion
Light source
(lux)
60-watt incandes-
500
cent light
Fluorescent light
700
30-watt fluores-
1,000
cent light
30-watt fluores-
3,000
cent light
30-watt fluores-
5,000
cent light
30-watt fluores-
10,000
cent light
10,000
Sun
Sun
100,000
A: for full charge
B: until the watch operates steadily
Environment
Distance of 60 cm
(2 ft.)
Office, overhead
Distance of 70 cm
(2 ft. 4 in.)
Distance of 20 cm
(8 in.)
Distance of 12 cm
(5 in.)
Distance of 3 cm
(1 in.)
Cloudy weather
Fair weather 2 hours 15 minutes 1 minute
Time required (approx.)
A
190 hours
140 hours
100 hours
30 hours
15 hours
8 hours
8 hours
BC
20 hours
16 hours
11 hours
3.5 hours
100
minutes
50 minutes
50 minutes
C: to maintain 1-day usage
70 minutes
50 minutes
35 minutes
11 minutes
6 minutes
3 minutes
3 minutes
English
5
● The table above provides only a general guideline.
● When the watch is fully charged, it will keep operating for approximately 5
months.
TO PREVENT THE ENERGY DEPLETION
■ Wear the watch so that it is not covered by your clothes.
■ When the watch is not in use, leave it in a bright place as
long as possible.
* Make sure that the watch temperature does not exceed 50° C.
English
6
NOTE ON POWER SUPPLY
● This watch is provided with a rechargeable battery for exclusive use with the
watch. Unlike conventional battery-powered watches, therefore, battery
replacement is not necessary.
● The solar cell is a clean energy source, having no adverse effect on the natural
environment.
CAUTION
● Never insert a conventional silver oxide battery in your watch as it may explode,
generate an intense heat or catch fire. The watch is so designed that even if the
battery is installed in the watch, the watch will not operate.
English
7
TIME SETTING
Hour hand
English
NOTE:
When setting Minute hand, first advance it 4 to 5 minutes ahead of the desired time
and then turn it back to the exact minute.
8
Minute hand
1
➠
➠
➠
➠
3
CROWN
1 Pull out.
2 Turn to set Hour and Minute
hands to the desired time.
2
3 Push back in to normal position.
TO PRESERVE THE QUALITY OF YOUR WATCH
WATER RESISTANCE
● Non-water resistant
• If the watch becomes wet, have it checked by an AUTHORIZED
PULSAR DEALER or SERVICE CENTER.
● Water resistant 5/10/15/20 bar
• Before using in water, be sure the crown is pushed in completely.
• Do not operate the crown when the watch is wet or in water.
5
bar WR
10/15/20
bar WR
If used in sea water, rinse the watch in fresh water and dry it
completely.
• When taking a shower with the water resistant 5 bar watch, or taking
a bath with the water resistant 10, 15 or 20 bar watch, be sure to
observe the following:
* Do not operate the crown when the watch is wet with soapy water
or shampoo.
* If the watch is left in warm water, a slight time loss or gain may be
caused. This condition, however, will be corrected when the watch
returns to normal temperature.
English
9
* Pressure in bar is a test pressure and should not be considered as corresponding
to actual diving depth since swimming movement tends to increase the pressure
at a given depth. Care should also be taken on diving into water.
** We recommend that you wear a PULSAR Diver’s Watch for scuba diving.
TEMPERATURES MAGNETISM
Your watch works with
+50°C
stable accuracy within a
temperature range of 5° C
-5°C
and 35° C (41° F and 95°
Temperatures over 50° C (122° F) or
English
below –5° C (+23° F) may cause a
slight time loss or gain or shorten the
duration within which the watch keeps
operating.
However, the above conditions will
be corrected when the watch returns
to normal temperature.
F).
10
Normal accuracy will return if the watch
is moved away from the magnetic field.
The watch will be
adversely affected by
strong magnetism. Keep
S
N
it away from close contact
with magnetic objects.
CARE OF CASE AND BRACELET
To prevent possible
rusting of the case and
bracelet caused by dust,
moisture and perspiration,
wipe them periodically
with a soft dry cloth.
SHOCKS & VIBRATION
Light activities will not
affect your watch, but be
careful not to drop your
watch or hit it against hard
surfaces, as this may
cause damage.
CHEMICALS
Be careful not to expose
the watch to solvents,
mercury, cosmetic spray,
detergents, adhesives or
case, bracelet, etc. may become
discolored, deteriorated or damaged.
paints. Otherwise, the
PERIODIC CHECK
It is recommended that the
2 - 3
Years
DEALER or SERVICE CENTER to
ensure that the case, crown, gasket
and crystal seal remain intact.
watch be checked once
every 2 to 3 years. Have
your watch checked by an
AUTHORIZED PULSAR
PRECAUTION REGARDING
CASE BACK PROTECTIVE FILM
If your watch has a
protective film and/or a
sticker on the case back,
be sure to peel them off
before using your watch.
English
11
Loading...