Puls CD5.241-S1 Connection Diagram

CD5.241-S1

CD-Series

9. FRONT SIDE AND USER ELEMENTS

Fig. 9-1 Front side

Input terminals

A

Screw terminals
+ Positive input

- Negative (return) input
Chassis ground: can be used to bond the housing to PE

Ground this terminal to minimize high-frequency emissions.

Output terminals

B

Screw terminals, dual terminals per pole, both pins are equal
+ Positive output

- Negative (return) output Screw terminals

Output voltage potentiometer

C

Open the flap to set the output voltage. Factory set: 24.1V

DC-OK LED (green)

D

Monitors the output voltage, which is produced by
the DC/DC converter itself and is on when the voltage is higher
than 90% of the adjusted output voltage.
DC-OK lamp and DC-OK contact functions are synchronized

E

Signal terminals

Plug Connector for DC-OK and Input-low relay contact

F

Input-low LED (yellow) see also chapter 13.

On when the input voltage is between 4Vdc and 20Vdc..
Input-low LED and Input-low contact functions are synchronized

DC/DC Converter 24V, 5A

Oct 2009 / Rev. 1.3 DS-CD5.241-S1-EN
All parameters are specified at 24V, 5A, 24Vdc input voltage, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone [phone] Germany

9/22