Puch Magnum II MKII Owner's Manual

Dear

Puch

Owner

This

is

your

riding, maintenance

and

warranty guide. By following the instructions

described in this

booklet,

we

at

Puch know you will enjoy many miles

of

pleasurable

Moped Riding.
Should a need

ever

exist for parts

or

service, simply contact your Puch dealer.

He

also

has available for

your

purchase a Service Manual under

the

partNr. 907

.2. 71.894.5 0180

Thank you for joining the Puch family, please ride safely and have fun.

P.O.

BOX

7777

Greenwich, Ct. 06830

CONTENTS

Preface . .

..

.

..

.

Warranty-

Terms & Conditions
Extent

of

Coverage

Exclusions

Registration . . . .

A.

Serial

number

location

B.

Operating controls

C. Tire pressure . . . .

D . Oil,

Gas/oil

mixture .

E.

Operating instruction

F. Riding instruction

..
G. Trouble shooting
H.

Owner

maintenance

I.

Suggested maintenance and lubrication chart

J.

Consumer

information

2

PAGE

3
4
5

6
7

9

14
14
17

20

21

23
25

26

THE

WARRANTY-

Terms

&

Conditions

Subject to the terms set forth below, the

Puch

motorized bicycle is warranteed

to

be

free from defects

in

material

and

workmanship for a period of 6 months from the date

of original consumer purchase. While under this warranty, Steyr Daimler Puch of

America, hereafter SDPA, will, at its descretion, replace or repair without charge, any
product or part which

an

authorized service representative determines is defective

in

material or workmanship.

This warranty applies to the original consumer purchaser only.

This warranty gives the original consumer purchaser specific legal rights. The original

consumer purchaser may also have other rights which vary from state

to

state

3

EXTENT

OF

WARRANTY

COVERAGE

The warranty will not

be

extended to any machine that

has

been subject to mis-use,

negligence, alteration, use

of

non-authorized spare parts, improper maintenance

(including improper fuel mix ratio, lack of oil, or use

of

poor quality oil) or modification

of

assemby. Additionally, this warranty will not apply if the machine

is

damaged

by

fire,

flood, accident, acts of God or any other cause

of

a similar nature beyond SDPA's

control.

Under

no

circumstances will SDPA be liable for damages due to loss of use, loss of

business or profits or for any other incidental or consequential damages.

Some states

do

not allow the exclusion or limitation or incidential

or

consequential damages,

so

the above limitation may not apply.

This warranty

will

be

null

and

void

if:

1.

Any part of the serial numbers are removed, defaced

or

altered;

2.

If

any unauthorized modification or alteration

is

made;

3.

If

any unauthorized or non-standardized spare part

is

installed;

4.

If

any maintenance or repair

is

perfomed during

the

warranty period

by

anyone

other than

an

authorized

Puch

Dealer.

4

EXCLUSIONS:

Normal wear parts are excluded from this warranty.
Normal wear parts include:
Tires, tubes, spark plugs, brake linings, clutch hub, chains, spokes, sprockets,

ignition points, condenser, brake

cables, throttle cable, air filter.

Routine maintenance.

No

one

has

the authority

to

orally change the terms, conditions or exclusions of this

warranty

or

make any representations or express warranties other than those

contained here.

SDPA

is

proud

and

confident

of

its dealers

and

products,

and

wants to assure that

each new

Puch

owner receives full satisfaction.

In

the event satisfaction

is

not

obtained

at

the dealer level however, the original consumer

is

invited to contact

SDPA directly

at

P.O. Box

7777, Greenwich, Connecticut 06830

5

l

WARRANTY

REGISTRATION

The Warranty Registration form should

be

completed

by

the dealer

and

the consumer

purchaser

at

the

time of sale.

Part 1 shall

be

kept

by

the selling dealer.

Part 2 should

be

kept

by

the original purchaser

in

his/her possession.

ANY CLAIM MADE UNDER THIS WARRANTY MUST

BE

ACCOMPANIED

BY

PART

2

OF THE WARRANTY REGISTRATION FORM.

Part 3 which

is

self-addressed

and

stamped, must

be

mailed

to

Steyr Daimler

Puch

of

America Corporation,

P.O.

Box 7777, Greenwich, Connecticut 06830 not later than

ten

(1

0)

days after purchase of vehicle.

All

information

on

the

Form

must

be

written legibly. The serial numbers

on

the

Registration

Form

must agree with those

on

the Moped.

6

A)

SERIAL

NUMBER

LOCATION

The engine number is stamped on top of the right crankcase

half.

The specification plate is secured to the steering head.

l

8

0

c=::2

IMPORTANT!

Write down
key-number

at

once.
This saves time,
money

and

annoyance

if

the

keys are

lost.

The frame serial number

is

stamped

on

the steering head, just

above of the

vehicle identification number plate.

My

key number

is

______________

<(Z

__

1Q

__

J(

___

--

----------

----------------

·

--

B)

OPERATING

CONTROLS

The positions of the controls are shown

in

the enclosed technical

data sheet.

Following some operating controls described

in

detail:

Locking

and

unlocking

your

moped

To

lock, move

the

handlebar

to

the right. Insert key into lock.

Turn key to the left, push

in

and

turn key to the right.

Remove

key.

Unlock

in

reverse order.

Fuel

tank

filler

cap

TO

open, turn filler

cap

counter clockwise.

9

10

Fuel

valve

The fuel valve

is

located

on

the left side of the fuel tank.

The positions are

clearly indicated

on

the tank.

In

the

event

you

should

run

out of fuel, the reserve position

should give

you

adequate range

to

get

you

to a filling station.

Always turn the fuel valve

to

the "Off" position when the moped

is

not

in

use.

Carburetor

1)

The primer

is

operated

by

depressing the black rod extending

through the

left engine cover.

2)

The choke is operated

by

depressing the metal thrust pin

which extends upward toward the opening in the

left

engine cover.