PTN IR-PA2B User Manual

IR Remote/Receiver (For the Digital Amplifier PA2B)

PTN Electronics Limited www.PTN-electronics.com

IR-PA2B

PTN IR Remote/Receiver

(For the Digital Amplifier PA2B)

USER MANUAL

IR Receiver

IR Remote

IR Remote/Receiver (For the Digital Amplifier PA2B)

PTN Electronics Limited www.PTN-electronics.com

 Remote Controller

The IR remote has built in popular functions like Input Channels Selection, Mute and
Volume/EQ control.
The function description is showed as below:

Note: The battery of the remote controller is offered for charge. Please point the remote
controller at the IR receiver when use, to avoid getting out of control as there is no signal
detected.

 IR Receiver

The IR receiver is used to receive the IR code from the remote controller. It connects to
PA2B by 3.5mm jack connector, and receives the IR codes by the IR receiver. The IR
receiver has an adhesive tape at the back that can be stick on the wall or ceiling. The IR
receiver cable is about 1.5m in length.
Please see the illustration below:

Mute Mode:
MIC: Mute the
microphone volume.
LINE: Mute the line
volume.

Use to transmit the
infrared signal send by
the remote controller.

Audio Controlling Modes
MIC: turn up/down the
microphone volume.
LINE: turn up/down the
line volume.

BASS: bass tuning
TREBLE: treble of line

volume.

Audio Inputs
2 RCA dual-mono audio
inputs
1 3.5mm jack