Psion UHFCA3A5 Users Manual

WORKABOUT PRO G2 RFID MODULE UHF-CA3-A5

EXPANSION MODULE INSTRUCTIONS

Important: All Approval and safety information is outlined in the ‘Workabout pro G2 Handheld-computer
User Manual’ – part number 8100140A. This manual is available on our website www.psionteklogix.com
through the Teknet extranet.

Important:
from the rest of the body. This product must not be used in a holster or on a belt-clip.

Easily installable expansion modules for the WORKABOUT PRO allow you to customise this hand-held to
meet your specific mobile computing requirements. This chapter outlines how to install the RFID Module
UHF-CA3-A5 (this module is composed of one RFID Coupler UHF-CA3 and RFID Antenna UHF-A5).
Before installing a module in the WORKABOUT PRO G2, all power sources must be turned off.

• Remove the batteries. If your unit is using AC power, disconnect it.

• Stick the FCC / IC Label

WAP C G2 WAP S G2

The WORKABOUT PRO G2 with the RFID option must not be held closer than 20 cm

(FCC ID: GM3UHFCA3A5, IC ID: 2739D-UHFCA3A5) underneath the battery.

Label area

• Slide the switch to position OFF to shut off internal battery power.

With the power shut down, you can install the RFID Module UHF-CA3-A5-G2.

• Remove and discard the two screws on the bottom of the metal frame.

• Put the RFID Coupler UHF-CA3 in the same alignment of the expansion connector on the

WORKABOUT PRO G2. Apply slight pressure to snap the module into place on the hand-held.

• Use four new screws (M2 x 6 mm) provided to secure the module in place.

Label area

March 09, 2009

DPD A00465 A00 Sheet 1 of 3

• Connect the RFID Antenna UHF-A5 to the RFID Coupler UHF-CA3.

• Slide the switch to the position ON to turn power back on.

• Replace the end-cap, back plate and batteries.

For detailed instructions, pleased refer to the WORKABOUT PRO G2 Hand-Held Computer User Manual
and to the RFID MODULE UHF-CA3-A5 User manual. These manuals are available on our website

www.psionteklogix.com

through the Teknet extranet

Important:

The WORKABOUT PRO G2 with the RFID option must not be held closer than 20 cm

from the rest of the body. This product must not be used in a holster or on a belt-clip.
READING AREA:

This area depend of the TAG type, TAG packaging, configuration of the WORKABOUT PRO G2
(scanner, Compact flash…), environment (metallic or not).

March 09, 2009

DPD A00465 A00 Sheet 2 of 3