Psion ST4004 QUAD Quick Start Manual

Page 1
Front
Docking connectors (quantity 4)
GEttInG StArtED
DC In connector
RJ45 Ethernet ports
Charging compartment (quantity 4)
FEAturESContEntS oF thE Box
ST4004 Quad Docking Station
1
2
ovEr
>
This Guide
Omnii Accessories Regulatory & Warranty Guide
BACk
Country-specific power cord, sold separately
AC/DC Adaptor
opErAtIon
> Fast charging of the Omnii internal battery for 4 units. > An RJ45 10/100 Base-T Ethernet interface compatible with
the USB to Ethernet drivers included in Omnii.
> An additional Ethernet interface for connecting more
docking stations downstream, up to 4 on the same network.
The ST4004 features:
Connect the Docking Station to external power.
Note: Use only the universal AC power adaptor
approved by Psion for use with the Quad Docking Station.
Power cord
Power adaptor
DC In connector
AC outlet
Connect the Docking Station to an Ethernet network.
10 or 100 Base-T Ethernet connector
Left-side RJ45 port
Activity LED (flashing green)
Link LED (solid amber)
The Ethernet connection in the Quad Docking Station
Omnii computers (up to 4)
Internal Ethernet connection
Quad Docking Station
Ethernet hub
10 or 100 Base-T Ethernet
USB to Ethernet converter (4)
Daisy-chained to other ST4004 Quad Docking Stations
To Ethernet network
Warning: Use an IEC320-C13 power cord approved by Psion,
with the ground pin connected to a proper earth­grounded receptacle. Check with a qualified electrician if you are uncertain of your receptacle grounding.
Daisy chain cable
Ethernet network cable
Daisy chain cable
Maximum of four ST4004 Quad Docking Stations on one network cable
(Ethernet connector to other docks)
Right-side RJ45 port
(Ethernet connector to network)
8000222A.indd 1 8/19/2011 5:55:34 PM
Page 2
8000222
QuICk StArt GuIDE
August 19, 2011 PN 8000222.A
ISO 9001 Certifi ed Quality Management System
Charge LED Behaviour Function
OFF No battery detected.
Solid Green Battery charging complete.
Flashing Green Charge in progress.
Flashing Yellow Battery is not charging due to out-of-temper-
ature conditions.
Solid Red Unable to read battery or non Psion battery.
Note: Full battery performance is only
reached after the fi rst few charge/discharge cycles.
3-4 h
0 - 40 °C 32 - 104 °F
Allow the Omnii computers to charge for 3-4 hours before fi rst use.
4
Omnii Battery Charge LED Behaviour
St4004 QuAD DoCkInG StAtIon
© Copyright 2011 by Psion Inc.
2100 Meadowvale Boulevard, Mississauga, Ontario, Canada L5N 7J9
http://www.psion.com
Psion, the Psion logo, and the names of other products and services provided by Psion are trademarks of Psion Inc. All trademarks used herein are the property of their respective owners.
Insertion and removal of the Omnii computers.
Slide Omnii into the docking station until it latches.
3
When an Omnii is inserted in the docking station, a dock icon is dis­played in the taskbar at the bottom of the screen. The Omnii also de­tects the presence of the Ethernet network and automatically detects and loads the appropriate drivers to communicate with the network.
ConnECtInG to An EthErnEt nEtWork
To remove Omnii, push down on the release mechanism on the front face of the docking bay. The hand-held will detach from the docking bay release arms and can be pulled up and out.
Release mechanism
Release arm
8000222A.indd 2 8/19/2011 5:55:40 PM
Loading...