WORKABOUT PRO RFID MODULE HF-T2-G2-XMOD
EXPANSION MODULE INSTRUCTIONS
Important: All Approval and safety information is outlined in the ‘Workabout pro G2
Handheld-computer User Manual’ – part number 8100140A. This manual is available on
our website www.psionteklogix.com through the Teknet extranet
Easily installable expansion modules for the WORKABOUT PRO allow you to customise this hand-held to
meet your specific mobile computing requirements. This chapter outlines how to install the RFID Module
HF-T2-G2-XMOD (this module is composed of one RFID Coupler HF-T2-G2-XMOD and one RFID
Antenna HF-A1-G2-XMOD).
Before installing a module in the WORKABOUT PRO G2, all power sources must be turned off.
• Remove the batteries. If your unit is using AC power, disconnect it.
• Slide the switch to position OFF to shut off internal battery power.
With the power shut down, you can install the RFID Module HF-T2-G2-XMOD.
• Remove and discard the two screws on the bottom of the metal frame.
• Put the RFID Coupler HF-T2-G2-XMOD in the same alignment of the expansion connector on the
WORKABOUT PRO. Apply slight pressure to snap the module into place on the hand-held.
August 29, 2007
DPD A00301 A10 Sheet 1 of 5
• Use four new screws (M2 x 6 mm) provided to secure the module in place.
• Remove and discard the two screws on the top of the metal frame.
• Slide the RFID Antenna HF-A1-G2-XMOD under the metal frame (with the spiral pattern facing
up).
• Connect the RFID Antenna HF-A1-G2-XMOD to the RFID Coupler HF-T2-G2-XMOD.
• Use two new screws (M2 x 12mm) provided to secure the antenna on the metal frame.
• Slide the switch to the position ON to turn power back on.
• Replace the end-cap, back plate and batteries.
For detailed instructions, pleased refer to the WORKABOUT PRO Hand-Held Computer User Manual and
to the RFID MODULE HF-T2-G2-XMOD User manual. These manuals are available on our website
www.psionteklogix.com
through the Teknet extranet
READING AREA:
This area depend of the TAG type, TAG packaging, configuration of the WORKABOUT PRO (scanner,
Compact flash…), environment (metallic or not).
TAG
August 29, 2007
DPD A00301 A10 Sheet 2 of 5
Loading...