Psion HFAM1XT10 Users Manual

Mississauga, Ontario

Canada

Installation Instruction

Important: All Approval and safety information is outlined in the ‘OMNII Handheld-computer User Manual’ – part number

8100157. This manual is available on our website www.psion.com

http://community.psion.com/home/default.aspx

.

Important:

The OMNII with the RFID option must not be held closer than 20 cm from the rest of the body. This

product must not be used in a holster or on a belt-clip.

Easily installable expansion modules for the OMNII allow you to customise this hand-held to meet your specific mobile
computing requirements. This chapter outlines how to install the RFID Module HF-AM1-OMNII.
Before installing a module in the OMNII, all power sources must be turned off.

• Remove the Battery Pack. If your unit is using AC power, disconnect it:

Press the two latch buttons at the sides of the compartment simultaneously, and slide the
battery out.

through the community website

THE INFORMATION CONTAINED IN THIS DOCUMENT IS CONFIDENTIAL AND IS THE EXCLUSIVE INTELLECTUAL PROPERTY OF PSION INC. IT MAY ONLY BE USED FOR THE PURPOSE FOR
WHICH IT IS SUPPLIED AND MUST NOT BE REPRODUCED, STORED OR DISSEMINATED TO THIRD PARTIES BY ANY MEANS, IN WHOLE OR IN PART, WITHOUT THE EXPRESS WRITTEN
PERMISSION OF PSION INC.

MATERIALS AND PROCESSES USED TO PRODUCE THIS PART OR ASSEMBLY MUST COMPLY WITH EUROPEAN DIRECTIVE 2002/95/EC, RESTRICTION OF HAZARDOUS
SUBSTANCES (RoHS), AND REGULATION (EC) No: 1907/2006, REGISTRATION, EVALUATION, AUTHORISATION AND RESTRICTION OF CHEMICALS (REACH), OR LATEST VERSION
THEREOF.

TITLE: INSTRUCTION SHEET HF-AM1-OMNII RFID MODULE DRAWN BY: Nicolas FORNIER

DATE:

11/03/23

A

DRAWING NO.

8000236

SHEET 1 OF 8

SIZE

http://plm.ad.psion.com/Windchill/Library/Templates/Installation Instruction_Portrait_Template.doc

REV.

A.0

• Remove the existing Scanner pod or blank plate.

1. Remove the four M3X5 Torx screws securing the scanner pod on the main housing.

2. Lift the Pod or plate from the unit

3. Disconnect the scanner flex cable from the unit.

You can now install the RFID Module HF-AM1-OMNII

¾ Installing the RFID Module:

The RFID Module HF-AM1-OMNII includes one slim plastic pod, one flex cable and four M3X5MM Torx screws.

Generic Plastic Pod

Flex cable

PART NUMBER:

8000236

SHEET 2 OF 10

REV:

A.0

o Connect the Flex cable to the RFID Module HF-AM1-OMNII as shown hereafter:

Expansion port 1

o The RFID module HF-AM1-OMNII can be plugged on the OMNII using either expansion port 1 or expansion port 3.

(GPS option)

Expansion port 3

1. Expansion port 1: Connect the Flex cable to the main logic board as shown hereafter:

PART NUMBER:

8000236

SHEET 3 OF 10

REV:

A.0