PSB Speakers CW600E User Manual
Be Heard, Not Seen
PSB CustomSound In-Wall Speaker System
CW600E - Enclosed In-Wall System
In-wall speakers confront special acoustic challenges. Limited
interior space connes their effective enclosure volume, while
comparatively imsy partition construction is no substitute for a true
loudspeaker cabinet. There’s rarely enough in-wall volume for real
bass extension, and the same factor dooms most in-walls to being
both unusually power hungry and dynamically limited.
For the PSB CustomSound premium in-wall system, the CW600E,
the solution is a design that utilizes its own fully engineered
loudspeaker enclosure. Derived from the highly acclaimed Platinum
T6 tower, the CW600E incorporates a tall, narrow, highly braced,
fully enclosed, wooden enclosure just four inches deep that ts
fully within standard, 16-inch-studded construction. The CW600E’s
dual 6 1/2-inch (165mm) high-power woofers employ incredibly stiff
berglass cones and higher mass to optimize them to their enclosure
volume. The same MTM (midrange-tweeter-midrange) array found
in the acclaimed PSB Platinum T6 tower, and a specially optimized
crossover match system balance to the PSB Platinum Series
while extending bass response. The result is superb, “Platinum-
class” clarity and dynamics, with a highly dispersive “sweet spot”
so wide and tall that even large home-theater audiences will enjoy
maximum denition of movie sound and music alike. A “dog-leg”
mounting scheme assures fast, fool-proof and easy mounting. The
PSB CustomSound CW600E design nally settles the longstanding
conict between sound and design.
30 13/16"
782mm
31 3/4"
807mm
14"
356 mm
3 3/4"
86mm
12.875"
327mm
CW600E - Enclosed In-Wall System
• “Platinum-Class” In-Wall performance
• Five Driver, 3-way system utilizes Platinum T6 drivers
with stiff berglass cones and higher cone mass to
optimize them to their restricted enclosure volume
• Fully enclosed, highly braced wooden enclosure ts
within standard, 16” studded wall
• Midrange-tweeter array provides “Platinum-class”
clarity and dynamics with a highly dispersive “sweet
spot”.
Frequency Range (-6dB): 45-35,000Hz
Recommended Power: 15-200 Watts
Impedance: 6 Ohms
Sensitivity (1W (2.83V) @1m)
Anechoic Chamber: 86dB SPL
Typical Listening Room: 88dB SPL
Drivers: 2 x 6 1/2” Woofers,
2 x 3 1/2” Midranges,
1” Dome Tweeter
Overall Dimensions (W x H x D): 14 x 31 3/4 x 3 3/4”
Cut-out Dimensions (W x H): 12 7/8 x 30 13/16”
Weight: 31 lbs
Installation Notes
• The CW600E requires a full width stud bay
clear of any obstructions, pipes, wires, etc.
• Optimum mounting should place the tweeter
as close to ear level as possible.
• System should be vertical as shown.
• Wire connections are on bottom of system.
The system may be inverted if needed.
• Lift into aperture gently with two people if
possible. (System is heavy!)
• Tighten 12 “dog leg” screws with a rm
torque setting. Do not over tighten!
• Midrange and treble switches can be
adjusted to suit room acoustics and personal
taste.
• Due to the CW600E system being fully
enclosed no in-wall accoustic treatment is
required.
• System may be painted. Scufng and
priming recommended.
• See manual for more installation hints.
To Reach US Customer Ser vice dial 1 888 772 0000 ext 4445 or 4342
PSB Sp eakers rese rves the ri ght to chan ge specific ations or fe atures with out notice.
© 2005 PSB Speake rs, a divis ion of Lenb rook Indust ries Limited .
PSB is a register ed trademar k of Lenbro ok Industri es Limited. Printed in Canada 08/0 5. All righ ts reserved .
No part of this publication may be reproduced, stored or transmitted in any form whatsoever without the written permission of PSB Speakers.
869 CW600E Data
www.psbspeakers.com
1 888 772 0000
Loading...