Proware Technologies Co DN4210DV1 User Manual
PW-DN4210D
Wireless High Gain USB Adapter
PW-DN4210D
Wireless High Gain USB Adapter
PW-DN4210D
Wireless High Gain USB Adapter
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user‟s authority to operate the equipment.
In the U.S., Channel 12 and Channel 13 are banned to use according to the act of FCC. So
please kindly make sure your AP is working on other channel before you use it.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter. This equipment has been SAR-evaluated for use in hand.
SAR measurements are based on a 5mm spacing from the body and that compliance is
achieved at that distance
PW-DN4210D
Wireless High Gain USB Adapter
Country
Restriction
Reason/remark
Bulgaria
None
General authorization required for outdoor use and
public service
France
Outdoor use limited to 10
mW e.i.r.p. within the band
2454-2483.5 MHz
Military Radiolocation use. Refarming of the 2.4 GHz
band has been ongoing in recent years to allow current
relaxed regulation. Full implementation planned 2012
Italy
None
If used outside of own premises, general authorization is
required
Luxembourg
None
General authorization required for network and service
supply(not for spectrum)
Norway
Implemented
This subsection does not apply for the geographical area
within a radius of 20 km from the centre of Ny-Ålesund
Russian Federation
None
Only for indoor applications
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio interference,
in which case the user may be required to take adequate measures.
National restrictions
This device is intended for home and office use in all EU countries (and other countries
following the EU directive 1999/5/EC) without any limitation except for the countries mentioned
below:
Note: Please don‟t use the product outdoors in France.
PW-DN4210D
Wireless High Gain USB Adapter
CONTENTS
Package Contents .................................................................................................... 1
Chapter 1. Introduction ........................................................................................ 2
1.1 Overview of the product ........................................................................................................ 2
1.2 Features ................................................................................................................................ 2
1.3 LED Status ............................................................................................................................ 3
Chapter 2. Installation Guide ............................................................................... 4
2.1 Hardware Installation ............................................................................................................ 4
2.2 Software Installation .............................................................................................................. 4
2.2.1 For Windows XP ............................................................................................................ 4
2.2.2 For Windows Vista ......................................................................................................... 8
2.2.3 For Windows 7 ............................................................................................................. 11
Chapter 3. Configuration Guide ......................................................................... 14
3.1 For Windows XP ................................................................................................................. 14
3.1.1 Current Status .............................................................................................................. 14
3.1.2 Profile Management ..................................................................................................... 16
3.1.3 Diagnostics .................................................................................................................. 24
3.2 For Windows Vista .............................................................................................................. 25
3.3 For Windows 7 .................................................................................................................... 27
Chapter 4. WPS configuration ........................................................................... 30
4.1 PBC (Push Button Configuration) method .......................................................................... 30
4.2 PIN method ......................................................................................................................... 33
4.2.1 Enter a PIN into your AP device .................................................................................. 33
4.2.2 Enter the PIN from your AP device.............................................................................. 34
Appendix A: Specifications ................................................................................... 36
Appendix B: Glossary ............................................................................................ 37
PW-DN4210D
Wireless High Gain USB Adapter
Package Contents
The following contents should be found in your box:
One PW-DN4210D 150Mbps Wireless High Gain USB Adapter
Quick Installation Guide
One USB cable
One Resource CD for PW-DN4210D, including:
AR51 Wireless Lite-N Client Utility (AWCU) and Drivers
User Guide
Other Helpful Information
Note:
Make sure that the package contains the above items. If any of the listed items are damaged or
missing, please contact with your distributor.
Conventions:
The „Adapter‟ mentioned in this user guide stands for PW-DN4210D 150Mbps Wireless High
Gain USB Adapter without any explanations.
1
PW-DN4210D
Wireless High Gain USB Adapter
Chapter 1. Introduction
Thank you for choosing PW-DN4210D 150Mbps Wireless High Gain USB Adapter.
1.1 Overview of the product
The adapter is designed to provide a high-speed and unrivaled wireless performance for your
notebook and PC. With a faster wireless connection, you can get a better Internet experience,
such as downloading, gaming, video streaming and so on.
The PW-DN4210D‟s auto-sensing capability allows high packet transfer rate of up to 150Mbps for
maximum throughput. It has good capability on anti-jamming; it can also interoperate with other
wireless (802.11b/g) products. The adapter supports WEP, WPA and WPA2 encryption to prevent
outside intrusion and protect your personal information from being exposed.
The Quick Setup Wizard guides you step by step through the installation process; the AR51
Wireless Lite-N Client Utility helps you create a wireless connection immediately.
With unmatched wireless performance, reception, and security protection, the PW-DN4210D is
the best choice for easily adding or upgrading wireless connectivity.
1.2 Features
IEEE802.11n, IEEE802.11g, IEEE802.11b standards
Supports WPA/WPA2 data security, IEEE802.1x authentication, TKIP/AES encryption,
WEP encryption
Make use of IEEE 802.11n wireless technology to provide a wireless data rate of up to
150Mbps
supports automatically adjust to lower speeds due to distance or other operating limitations
Provides USB interface
Supports Ad-Hoc and Infrastructure modes
Good capability on anti-jamming
Supports roaming between access points when configured in Infrastructure mode
Easy to configure and provides monitoring information
Supports Windows 2000, XP32/64, Vista32, 7
2
PW-DN4210D
Wireless High Gain USB Adapter
Status
Working Status
Off
The driver has not been installed.
Flashing Slowly
The driver has been installed but there is no data being transmitted
or received.
Flashing Quickly
There is data being transmitted or received.
1.3 LED Status
3
PW-DN4210D
Wireless High Gain USB Adapter
Chapter 2. Installation Guide
2.1 Hardware Installation
There are two ways to install the Adapter:
1. Plug the Adapter directly to the USB port on your computer.
2. Connect the Adapter and your computer through the USB cable attached in package.
Note:
The promoted Found New Hardware Wizard screen will pop up when the adapter is installed
correctly. Click Cancel.
2.2 Software Installation
2.2.1 For Windows XP
The Setup steps for Windows 2000 and XP are similar with each other. This user guide takes
Windows XP for example.
1. Insert the Resource CD into your CD-ROM drive. To continue, double-click My Computer,
and then double-click the CD/DVD drive where the installation CD was placed. Open
PW-DN4210D folder, and double-click Setup.exe. Then you will see Figure 2-1.
2. Soon, Figure 2-2 will display after a moment. Click Next to continue.
Figure 2-1
4
PW-DN4210D
Wireless High Gain USB Adapter
Figure 2-2
3. After that, you should choose a Setup type. It is recommended that you select Install
Client Utilities and Driver. Select Install Driver Only to install driver only, select Make
Driver Installation Diskette(s) to make the diskette(s) as the installation driver (shown
in XFigure 2-3). Click Next to continue.
4. Click Browse… to change the destination location for the software, then click Next in the
screen below (shown in XFigure 2-4).
Figure 2-3
5
PW-DN4210D
Wireless High Gain USB Adapter
Figure 2-4
5. After that, select the program folder, you should create a new folder name or select one
from the Existing Folders list. It is recommended that you keep the default setting. Click
Next to continue the installation.
6. Choose configuration tool, if you are not sure, please leave it default. Then click Next to
continue.
Figure 2-5
6
PW-DN4210D
Wireless High Gain USB Adapter
Figure 2-6
7. Click OK to continue the Installation. Wait a while for the setup as shown in XFigure 2-7.
Note:
For Windows XP, the Setup Wizard will notify you of how to proceed with the installation during
these steps (shown in XFigure 2-8X). Our drivers have been tested thoroughly, and are able to work
with the operating system. Click Continue Anyway to continue the Installation.
Figure 2-7
7
PW-DN4210D
Wireless High Gain USB Adapter
Figure 2-8
8. After all the steps above, you will see the screen below, click Finish to reboot the system.
2.2.2 For Windows Vista
1. Insert the Resource CD into your CD-ROM drive. To continue, double-click My Computer,
and then double-click the CD/DVD drive where the installation CD was placed. Open
PW-DN4210D folder, and double-click Setup.exe. Then you will see Figure 2-10.
Figure 2-9
8
PW-DN4210D
Wireless High Gain USB Adapter
Figure 2-10
2. Soon, Figure 2-11 will display after a moment. Click Next to continue.
3. Wait a while for the setup as shown in Figure 2-12.
Figure 2-11
9
Loading...