Provision ISR 5MP 4 in 1 Series, DI-350A36, I3-350A36, DI-350AVF, I4-350AVF User Manual
...
5MP 4 in 1 Series
USER MANUAL
1
Contents
1) Cautions:
2 ) Product Introduction
2.1 Camera Introduction
2.2 Product Features
3)
Menu Setup
4) Product Installation
5)
Technical Specification
4.1 General Notes
4.2 Installation Tools and Information
4.3 Installation Method
4.4 Setting the Camera
4.5
4.7
Setting the video output type
OSD Control
4.8 OSD Menu Scheme
4.6 Connection
2 3
1 Cautions:
1. To reduce the risk of electric shock, do not open the
camera or perform internal maintainance by yourself.
Please consult a professional service person if needed.
2. To prevent fire or electrical shock hazard, make sure
that the input voltage, current, polarity and operating
temperature meet the requirements of the camera.
3. Please note the operating temperature and environmental limits of the camera. Do not install in higher/lower temperatures than -30°C~+50°C (-4°F~122°F).
These cameras are not waterproof! Minimize dust and
moisture erosion, otherwise camera would be damaged.
4. Avoid directing the camera to sunlight while powered
on, otherwise the sensor will be damaged.
5. Do not touch the sensor surface. If any foreign objects
exists use a cotton swab or lens paper to clean. if it is
difficult to remove, use a neutral detergent diluted with
water.
6. In order to ensure smooth and satisfactory image,
the power and video cables shouldn’t be too long.
Please follow general AHD/Analog sepcifications for
cables types and lenghts.
7. In order to prevent the camera from falling, please
install the camera on a stable surface.
8. The camera should not be placed near a radiator or
heating resistor.
4 5
3 Menu Setup
AHD/TVI: Click on “Iris+” button from the DVR’s PTZ
interface to call the OSD Menu. Use the PTZ interface to
scroll through the menu and “Iris+” to confirm.
CVI: Click “
►” button from the DVR’s PTZ interface,
then click “ ” and press “Enter” to call the OSD Menu.
4 Product Installation
4.1 General Notes
1. Make sure the unit is powered off before installation.
2. Check power supply voltage consistent with the
electric voltage to prevent voltage unworthy, resulting in
damage to the device.
3. Do not use in environment conditions exceeding the
specified temperature and humidity.
4. The installation and maintenance of this product
should be done by a professional. Please do not remove
or modify the camera in any way.
2 Product Introduction
2.1 Camera Introduction
PROVISION-ISR’s new series of cameras have
adopted a high performance CMOS image sensor,
which provides mega pixel resolution and supports HD
video. Moreover, it supports monitoring signals coaxial
transmission. Transmission distance can reach more
than 200M based on Rg59 coaxial cable. The series
can support all HD analog resolutions: AHD/TVI/CVI
as well as CVBS 960H output.
2.2 Product Features
● Coaxial cable with BNC connector
● DIP Switch for output selection
● Auto Day/Night (ICR)
● BLC
● 2D-DNR
● Super High Resolution Lens
● AHD/TVI/CVI/CVBS Signal Selectable
6 7
ON
1
HD CVI AnalogAHD HD TVI
2 1 21 2 1 2
ONON ON
4.2 Installation Tools and Information
Prepare the required tools and instructions. Before
installation please prepare the following tools:
A straight or a Phillips-head screwdriver, multi-meter,
cutter, needle nose pliers, measuring tape, pencil.
4.3 Installation Method
1. Check the camera for any external damage.
2. Mount the bracket or base:
① For cement wall, install the expansion screws, and
then mount the bracket/base.
② For wooden wall use self-tapping screws to mount.
Note:
The wall needs to bear at least 3X weight of
bracket (base) and camera. Installation
method above is for reference only.
4.4 Setting the camera:
a. Dome Camera
Adjust the lens position so it aims at the main monitoring
point and gives a clear picture.
b. Bullet Camera
Adjust the body so that the lens aims at the main
monitoring point and gives a clear picture. Tighten the
screws to ensure that it does not move.
4.5 Setting the video output type:
The camera supports AHD/TVI/CVI/CBVS video output.
Choosing the output type is done by setting a DIP switch
on the cable as illustrated:
8 9
4.6 Connection
Connection as shown in the figure below
4.8 OSD Menu Scheme:
4.7 OSD Control
The OSD control is available by CoC (Control over
Coax). If your AHD/TVI/CVI DVR supports this function*,
use the DVR’s PTZ interface to press on “Iris+” or “ ”
to open the OSD menu. Navigate through the OSD
menu using the PTZ direction arrows.
* Notice: CoC function works no more than 200M by RG59 coaxial cable
* All of Provision-ISR’s DVRs support CoC Starting from version 3.4.4
Main Menu Second Menu Third Menu
Brightness 1~20
GLOBE
BLC(1-9)
ATW
RGAIN 1~127
BGAIN 1~127
EXT
Auto
Color
B/W
Contrast 1~16
Sharpness 1~16
Color Gain 1~16
DNR 1~16
Mirror DEFAULT / H / V / HV
Video Standard
Language
Reset
Save-Exit
Exit
English/Chinese/Traditional Chinese
AE
WB
MWB
Image Enhance
Day / Night
Exposure Mode
4MP 30 / 4MP 25 / 5MP 20
Reboot & Apply
Video Output
5 Specifications:
5MP 4 in 1 camera
DI-350A36 / DI-350AVF / DAI-350AVF
Model
Image Sensor
Effective Pixels
Scanning System
Resolution
Min. Illumination
IR LED
OSD Menu
CoC Support
Day & Night Mode
Backlight Compensation
S/N Ratio
White Balance
Noise Reduction
Video Output
Defog
Privacy Mask
Motion Detection
D-Effect
Lens
Power
Operation temp.
Waterproof
Dimension
Net Weight
DI-350A36
2 LED Array (20m)
3.6mm
DC12V±10%, ~300mA
104*82*93.2mm
270g
DI-350AVF
3 LED Array (25m)
2.8-12mm
DC12V±10%, ~380mA
129.5*119*104mm
476g
DAI-350AVF
35 LED(20m)
2.8-12mm
DC12V±10%, ~300mA
ø145*119.5mm
960g
1/2.7" 5MP Sensor
2592(H)×1944(V)
Progressive
Digital: 2560X1936, Analog: 960H
0.01Lux (0 Lux with IR on)
Available via CoC Only
Yes
EXT, Color, B&W, Auto
BLC
≥35dB (AGC Off)
ATW / MWB
2D-DNR
5MP AHD/TVI; 4MP AHD/TVI/CVI; CVBS(Signal Selectable by DIP switch)
Not Available
Not Available
Not Available
Miror
-30°C~+50°C
IP66
Model
Image Sensor
Effective Pixels
Scanning System
Resolution
Min. Illumination
IR LED
OSD Menu
CoC Support
Day & Night Mode
Backlight Compensation
S/N Ratio
White Balance
Noise Reduction
Video Output
Defog
Privacy Mask
Motion Detection
D-Effect
Lens
Power
Operation temp.
Waterproof
Dimension
Net Weight
I3-350A36
3 LED Array (30m)
3.6mm
DC12V±10%, ~380mA
206.5*67.6*68.5mm
380g
I4-350AVF
4 LED Array (40m)
2.8-12mm
DC12V±10%, ~475mA
286*77*85.6mm
836g
1/2.7" 5MP Sensor
2592(H)×1944(V)
Progressive
Digital: 2560X1936, Analog: 960H
0.01Lux (0 Lux with IR on)
Available via CoC Only
Yes
EXT, Color, B&W, Auto
BLC
≥35dB (AGC Off)
ATW / MWB
2D-DNR
5MP AHD/TVI; 4MP AHD/TVI/CVI; CVBS(Signal Selectable by DIP switch)
Not Available
Not Available
Not Available
Miror
-30°C~+50°C
IP66
I3-350A36 / I4-350AVF
10 11
Loading...