4
5
General Operation
A. SEL button
Press and hold this button to enter into SELECT function, then repeatedly short push
in succession results in the following menu options: Bass, Treble, Balance, Fader,
Loud, EQ, Beep, Initial Volume, Area. Press the VOL+ or VOL- to adjust the options.
-
Initial Volume. Refers to the loudness level upon start of the receiver.
- AREA. Choose between USA and European..
LOUD. Choose between Loud ON or OFF.
- EQ. Choose between Classic, Pop, Rock, Jazz and EQ off.
- Beep. Choose between Beep ON, Beep 2ND, Beep OFF. Beep ON will result in
the beep sound at the press of every button; Beep 2ND will result in the beep
sound once the button is long pressed; Beep OFF results in the beep sound off
completely.
-
Radio Operation
A. Pres button (BAND function) to access FM and AM. There are three FM bands
and two AM bands.
B. Tuning. A short press of the or button results in a search of the station and
stops at next sufficient signal strength. A long press results in manual tuning mode,
allowing you to search one odd digit frequency at a time. (It will revert back to AUTO
tune mode with out operation in 5 seconds.)
USB Operation
Note: USB slot is for USB sticks only. For play of other brands of media, please use the
auxiliary input.
A. Insert a USB stick into the USB slot. *Songs must be of the mp3 or wma format.*
B. button. Press it to pause the track. Press it again to resume play.
C. and button (Track Up / Track Down)
Short press Track Up or Track Down button to select the next or previous track.
Press and hold Track Up or Track Down button to go fast forward and rewind the
current track respectively.
Auxiliary Input Mode
A. Press the Mode button until “AUX” appears on the LCD screen.
B. The use of auxiliary mode allows you to play the portable music device through
the headphone jack.
Note: An additional accessory/adaptor must be purchased in order for this to happen.
Prospec's part, SEAMINI2, or SEAUSBMINI fulfills this option.
Bluetooth Operation
Your media device must incorporate the Bluetooth option in order to stream music.
A. To pair your Bluetooth device, press the MODE button on the stereo until
BT AUDIO appears.
B. Press and hold BAND button until PAIRING appears.
C. Next, go to settings on the Bluetooth device and turn the Bluetooth option to “on”.
C. Pick the “PRV-18” option on your Bluetooth enabled device (please note that
if you are prompted for a password, the code entered will be “1234”. If your stereo
does not immediately pair, press BAND. This will allow the pairing process to
finalize. A higher pitch frequency noise will alert you to the connection/success!
The display will also read “CONN OK” (connection ok).
D. To disconnect your device, press and hold BAND button. “DISCONN” will appear
letting you know you have successfully disconnected.
E. While BT Music playing, simply push to Pause playback.