Page 1
Output sh
ort protection: yes ( microcontroller )
Battery ex. 12V / 24V protection: yes ( microcontroller )
Battery polari
ty protection: yes (by fuse )
Fuse: 35A*1pc+15A*1pc (12V) // 20A*1pc+15A*1pc (24V)
TE-1203UB /
TE-1403UB
Dime
nsion: ( L*W*H): 140*73*58mm
Weight: 750g
DC
To AC Power Inverter
TROUBLESHOOTING
300W-USB 50Hz Modify Sine Wave
If the inverter does
not appear to be functioning properly, there are several reasons
why the inverter may not be responding.
TE-1203UB: DC12V to AC220V~240V
TE-1403UB: DC24V to AC220V~240V
1) Poor
contact
*Cleaning contact parts thoroughly.
AC
OUTLET
2)
Receptacle has no power
*check fuse, replace damaged fuse.
*check receptacle wiring. repair if necessary
3) Fuse is blown
*The fuse is located inside the DC plug. Please replace fuse with a new
equivalent value fuse.
4)
Overload caused AC output reduce
*Reduce the wattage of loading to lower than 300 watts.
Instruction Manual
Please read user manual before use.
5)
Thermal caused AC output reduce
*Under heavy loads for extended periods of time. The AC inverter will reduce
output to prevent damage to excess heat. If this happened, please proceed as
below:
SPECIFICATION
Input voltage range: DC 10~15V (12V) // DC 20~30V (24V)
Input full load current: 30A (12V) // 15A (24V)
(A)
Switch off the power of this inverter.
S
tandby input current: <0.6A (12V) // <0.5A (24V)
(B)
Decreases the load of this machine i. e. disconnect some of the appliances
or wait until this inverter become cool.
USB port : ou
tput 5VDC (500MA max.)
Output voltage (AC) : 220V~240V
(C)
Switch on the power of this inverter.
Output wavef
orm: modify sinewave
6) Low-b
attery shutdown
*Recharge your battery and resume operation.
CAUTION
Always place the inverter in an environment which is:
Output freq
uency: 50Hz
Continue output power: 300W
Peak output power: 900W
Ef
ficiency: 90%
Battery low pre-alarm: 10.5
± 0.5V (12V) // 21 ± 1V (24V)
(A) well
ventilated
Battery low shut
down: 10
± 0.5V (12V) // 20 ±1V (24V)
(B)
not exposed to direct sunlight or heat source
Auto-operation fan (tempe
rature or load)
(C)
out of reach from children
Thermal protection: 60
± 5 ℃(microcontroller )
(D) away
from water/moisture, oil or grease
Overlo
ad protection: yes (microcontroller )
(E)
away from any flammable substance
Page 2
©2014 Cop
yright by Prokit’s Industries Co., Ltd. All right reserved.
TERMINAL
TERMINAL
( - )
( + )
CHASSIS GROUND LUG
FAN
POWER SWITCH
POWER ON
INDICATOR
5VDC --- 500mA
USB PORT OUTPUT
AC
OUTLET
CAUTION: do not reverse input. Use red battery cord to connect (+) of a DC
battery to (+) terminal. Then, use black battery cord to connect (-) battery to (-)
terminal.
RED
BLACK
BATTERY
FAN
When connected to any appliance, be sure to turn on inverter first, and then
turn on the power of the appliance.
TELEVISION
TURN ON
SECONDLY
TURN ON FIRSTLY
BATTERY
WARNING:
Start the engine of car when connected to any appliance, do not exceed the
output power 150w of the inverter.
ON
OFF
NOTEBOOK
MP3 or other
WARNING SIGNAL
condition warning signal cycle shutdown signal cycle
Low battery alarm: BI BI BI (pause) BEE BEE BEE (pause)
Over heating alarm: BI BI (pause) BEE BEE (pause)
Over load alarm: BI BI BI BI BI BI continuous tone
NOTE: BI is a short beep, and BEE is a longer beep.
While using USB port: output 5VDC (500MA max) for charging, please turn on the switch
of the inverter first, then connect the USB cable to the electronic appliance needed to be
charged
ON
OFF
MP3 or other
TURN ON FIRSTLY
OUTLET
AC
During operation, when the power is switch on, if the power indicator doesn’t light
up, please check the fuse in the battery cables or cigarette plug. If the fuse is
spoilt, please replace fuse with a new same current fuse.
MAX : 35A (12V)
20A (24V)
MAX : 15A(12V or 24V)
If the total watts of electrical appliances exceeds the output capacity of inverter, or if the
temperature of the inverter reaches 60℃ after operating for a period of time, the
inverter shall be reduced AC output by the protection circuit.
0
60 C
※
WARNING ※FLUORESCENT LAMP
Do not use this device with fluorescent lamps.
BALLASTS
Glow switch
Lamp
AC IN
Power Factor
Capacitor
a
b
Loading...