Pro Series 44101 User Manual

SERIES 51®

Installation Instructions

Part Numbers:

Hitch Shown In Proper Position

Equipment Required:

Fastener Kit: 01131-023

Wrenches: 18mm, 19mm, 3/4, 7/8

Drill Bits: 1/2”

Place between frame and hitch if vehicle is equipped with step bumper

97 and Prior Models

Ford Ranger

Mazda B2300, B3000, & B4000

Relocation of spare tire bracket

is not

Bumper

required

Hitch type

Weight Distributing

Weight Carrying

Ball Mount

Wiring Access Location: PC1, PC2

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

1 2

Frame rail

3 4

Max Gross

Trailer WT (LB)

Bumper bracket

Existing bumper bracket fasteners rearmost to be removed

51032 44101

Max Tongue

WT (LB)

500 (227 Kg)5000 (2270 Kg)

300 (136 Kg)3500 (1589 Kg)

Note:

19mm open end style wrench must be purchased to allow removal of spare tire after hitch installation,

1. For vehicles with step bumper, remove rearmost bumper bracket bolt and j-nut (both sides).

2. Position hitch on vehicle, sandwiching bumper bracket (if present) between hitch and vehicle frame, install rearmost fasteners.

3. Using hitch as template drill two (2) 1/2 holes into frame at forward end of hitch. Note:

4. Install remaining fasteners as shown. For vehicles with step bumper, place block (Item 5) between frame and side brackets at forward attachment, as shown.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.

Carriage Bolt 1/2-13 X 1.75Qty. (4)

Block .25 X 1.00 X 2.00Qty. (4)

Lock Washer 1/2Qty. (4)

On some models holes may already exist.

Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)

Hex Nut 1/2-13Qty. (4)

Block .19 X 1.00 X 2.00Qty. (2)

Fasteners typical both sides

z 2001, 2002, 2006 Cequent Towing Products

Rev. A6-27-06N51032Sheet 1 of 1

Form: F205 Rev A 5-6-05