Pro Series 44026 User Manual

SERIES 51®

Hitch Shown In Proper Position

Step Bumper

Installation Instructions

All Ford Pickup

(Except Ranger & Flare Side Pickup with

Fiberglass Rear Valence Panel)

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Hitch type

Weight Distributing

Weight Carrying

Ball Mount

Max Gross

Trailer WT (LB)

Part Numbers:

51009 44026

Max Tongue

WT (LB)

1000 (454 Kg)10,000 (4540 Kg)

500 (227 Kg)5000 (2270 Kg)

Equipment Required:

Fastener Kit: 51009-051

Wrenches: 3/4, 7/8

Drill Bits: 1/2”

Fasteners typical both sides.

Hex Bolt 1/2-13 X 1.75Qty. (6)

BlockQty. (6)

Flat Washer 1/2Qty. (6)

3 4 5

1 2

Vehicle Crossmember

Wiring Access Location: PC1, PC2

Lock Washer 1/2Qty. (6)

Hex Nut 1/2-13Qty. (6)

Frame rail

Due to vehicle variation, it may be necessary to adjust Step Bumper upward.

Note:

1. Remove all but a thin layer of undercoating from attaching surfaces.

2. Position hitch over rivets on both frame rails, making sure the hitch is centered.

Note: Make sure rearmost attachment will allow block to sit flat on inside of frame rail, and pushed up against the crossmember.

3. Using the hitch as a template, drill three (3) 1/2” holes into the bottom of each frame rail.

4. Install all fasteners as shown above, placing blocks inside vehicle frame as shown.

Tighten all 1/2-13 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.

z 2001, 2002, 2006 Cequent Towing Products

Form: F205 Rev A 5-6-05

Rev. A6-27-06N51009Sheet 1 of 1