ProScan PSS2115I User Manual

PROSCAN *

2.lCH SUBWOOFER SPEAKER SYSTEM

PSS2115! )

CAUTION

L Eil/lim ilii

CAUTION" TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USER-

SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.

®

DANGEROUS VOLTAGE:

The lightning flash with arrowhead symbol within an
equilateral triangle is intended to alert the user to the

presence of uninsulated dangerous voltage within the
product's enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.

ATTENTION:

The exclamation point within an equilateral triangle is

intended to alert the user to the presence of important

operating and maintenance (servicing)instructions in the

literature accompanying the appliance.

FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or

modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The

user could lose the authority to operate this equipment if an unauthorized
change or modification is made.

iPod is a trademark of Apple Computer, Inc., registered in the U.S. and
other countries.

INFORMATION:
This equipment complies with Class B digital device regulations.
This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

WARNING: TO PREVENT FIRE OR SHOCK

HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN

OR MOISTURE.

SURGE PROTECTORS:

It is recommended to use a surge protector for AC connection.
Lightning and power surges ARE NOT covered under warranty

for this product.

This Class B digital apparatus complies with Canadian

ICES=003.

2

Before using the unit, be sure to read all operating instructions carefully. Please
note that these are general precautions and may not pertain to your unit. For
example, this unit may not have the capability to be connected to an outdoor

antenna.

1. READ INSTRUCTIONS

All the safety and operating instructions should be read before the product is

operated.

2. RETAIN INSTRUCTIONS

The safety and operating instructions should be retained for future reference.

3. HEED WARNINGS

All warnings on the product and in the operating instructions should be adhered to.

4. FOLLOW INSTRUCTIONS

All operating and use instructions should be followed.

5. CLEANING

Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners
or aerosol cleaners. Use a dry cloth for cleaning.

6. ATTACHMENTS

Do not use attachments not recommended by the product's manufacturer as they may
cause hazards.

7. WATER AND MOISTURE

Do not use this product near water-for example: near a bathtub, washbowl, kitchen
sink or laundry tub; in a wet basement; or near a swimming poot.

8. ACCESSORIES

Do not place this product on an unstable cart, stand, tripod, bracket or table. The
product may fall, causing serious injury and serious damage to the
product. Use only with a cart, stand, tripod, bracket or table
recommended by the manufacturer or sold with the product. Any

mounting of the product should follow the manufacturer's instructions,
and should use a mounting accessory recommended by the

manufacturer.

An appliance and cart combination should be moved with care.

Quick stops, excessive force and uneven surfaces may cause the
appliance and cart combination to overturn.

9. VENTILATION

Slots and openings in the cabinet and in the back or bottom are provided for
ventilation, to ensure reliable operation of the product and to protect it from
overheating. These openings must not be blocked or covered. The openings should
never be blocked by placing the product on a bed, sofa, rug or other similar surface.
This product should never be placed near or over a radiator or heat source. This
product should not be placed in a built-in installation such as a bookcase or rack

unless proper ventilation is provided or the manufacturer's instructions have been
adhered to.

10. POWER SOURCES

This product should be operated only from the type of power source indicated on
the marking label. If you are not sure of the type of power supply to your home,
consult your appliance dealer or local power company. For products intended to

PORTABLE CART WARNING

(symbol provided by RETAC)

operate from battery power, or other sources, refer to the operating instructions.

11. GROUNDING OR POLARIZATION

This product is equipped with a polarized alternating-current line plug (a plug having
one blade wider than the other). This plug wilt fit into the power outlet only one way.
This is a safety feature. If you are unable to insert the plug fully into the outlet, try
reversing the plug. If the plug should still fail to fit, contact your electrician to replace
your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

12, POWER-CORD PROTECTION

Power-supply cords should be routed so that they are not likely to be walked on or
pinched by items placed upon or against them, paying particular attention to cords
at plugs, convenience receptacles, and the point where they exit from the appliance.

13. LIGHTNING

To protect your product from a lightning storm, or when it is left unattended and
unused for tong periods of time, unplug it from the walt outlet and disconnect the

antenna or cable system. This will prevent damage to the product due to lightning
and power-line surges.

14. POWER LINES

An outside antenna system should not be located in the vicinity of overhead power

lines or other electric light or power circuits, or where it can fall into such power lines
or circuits. When installing an outside antenna system, extreme care should be
taken to keep from touching such power lines or circuits as contact with them might

be fatal.

15. OVERLOADING

Do not overload wall outlets and extension cords as this can result in a risk of fire or
electric shock.

16. OBJECT AND LIQUID ENTRY

Never push objects of any kind into this product through openings as they may touch
dangerous voltage points or short out parts that could result in fire or electric shock.

17.

Never spill or spray any type
of liquid on the product.

OUTDOOR ANTENNA
GROUNDING
If an outside antenna is

connected to the product,
be sure the antenna

system is grounded so as
to provide some protection
against voltage surges and
built-up static charges.

Section 810 of the National
Electric Code, ANSI/NFPA
70, provides information

with respect to proper

grounding of the mast and
supporting structure,
grounding of the lead-in

ANTENNA

LEAD IN
WIRE

DISCHARGE UNIT
(NED SECTION 810-20)

SERVICE

(NEC SECTION 810-21)

ELECTRODE SYSTEM

NEC - NATIONAL ELECTRICAL CODE (NEC ART 250, PART H)

$2898A

EXAMPLE OF ANTENNA GROUNDING AS PER

NATIONAL ELECTRICAL CODE

4

wire to an antenna discharge product, size of grounding conductors, location of

antenna discharge product, connection to grounding electrodes and requirements

for grounding electrodes.

18. SERVICING

Do not attempt to service this product yourself as opening or removing covers may
expose you to dangerous voltage or other hazards. Refer all servicing to qualified
service personnel.

19. REPLACEMENT PARTS

When replacement parts are required, be sure the service technician uses
replacement parts specified by the manufacturer or those that have the same
characteristics as the original part. Unauthorized substitutions may result in fire,

electric shock or other hazards.

20. SAFETY CHECK

Upon completion of any service or repairs to this product, ask the service technician
to perform safety checks to determine that the product is in proper operating

condition.

21. WALL OR CEILING MOUNTING

The product should be mounted to a wall or ceiling only as recommended by the
manufacturer.

22. DAMAGE REQUIRING SERVICE

Unplug the product from the wall outlet and refer servicing to qualified service
personnel under the following conditions:
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled or objects have fallen into the product.
c. If the product has been exposed to rain or water.
d. Ifthe product does not operate normally by following the operating

instructions. Adjust only those controls that are covered by the

operating instructions, as an adjustment of other controls may result

in damage and will often require extensive work by a qualified

technician to restore the product to its normal operation.

e. Ifthe product has been dropped or the cabinet has been damaged.

f. When the product exhibits a distinct change in performance-this

indicates a need for service.

23. HEAT

The product should be situated away from heat sources such as radiators, heat
registers, stoves or other products (including amplifiers) that produce heat.

24. NOTE TO CATV SYSTEM INSTALLER

This reminder is provided to call the CATV system instalter's attention to Article 820-

40 of the NEC that provides guidelines for proper grounding and, in particular,

specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.

25. The MAINS plug or an appliance coupler is used as the disconnect device, the

disconnect device shall remain readily operable.

5