ProPlex IQ Tester LV User Guide

ArtNet RX
The IP address of the receiver of the signal
regardless of the IP address)
Destination Port
Destination Port
FPS
Frame per second/ Data Packet Rate
A group of 256 ArtNet universes, totally is 128 groups
Universe
Select output universe
Activate/Deactivate output using Up/Down navigation buttons
Set the output source: One of 4 slots or DMX value using the Up/Down navigation buttons
Use external DMX input as a source
Use internal DMX
section)
Assign internal
a source
View/set DMX values. Values are set using the navigation buttons.
The IP address of the receiver. Note:
regardless of the destination IP address.
Rev. 031419
ProPlex IQ Tester LV – Function Guide v0.6.3
Monitor sACN Streams/Universe Data Via 100Base-TX FD Port
Input
sACN RX Monitor sACN Streams/Universe Data Via 100Base-TX FD Port
DMX-IN View DMX Data Via 5pin XLR DMX input
(255.255.255.255 is a special Broadcast address
Destination IP
signifying “current network”: Allows Broadcast packets to be sent to the connected network
Net
Enabled/Disabled
ArtNet
Slot 1-4
DMX In
Output
Artnet TX
sACN TX
sACN
Slot 1-4
Set
View
Destination IP
output as a source
DMX Out
(set in the DMX / RDM outp7ut
Artnet 01-04
ArtNet Slot (1-4) as
255.255.255.255 is a special Broadcast address meaning “current network,” allowing Broadcast packets to be sent to the network connection
Destination Port
Destination Port
FPS
Frame per second/ Data Packet Rate
Prio
Priority
Universe
Select output universe
Enabled/Disabled
Activate/Deactivate output using Up/Down naviga tion buttons
Set the output source: One of 4 slots or buttons
Use external DMX input as source
Use internal DMX output as DMX/RDM output sec tion)
Assign internal ArtNet Slot (1-4) as a source
View/set DMX values using the navigation buttons
DMX-OUT
View/set DMX values. The values are set using the navigation buttons.
Input Merge
RDM
RDM Enable/Disable
Enable/Disable RDM
device can be changed using the arrow keys
Network status
Activity Monitor
ArtNet
Identifies ArtNet protocols in the network + basic information
sACN
Identifies sACN protocols in the network + basic information
MA-Net2
Identifies MA-Net2 protocols in the network + basic information
HogNet
Identifies HogNet protocols in the network + basic information
HippoNet
Identifies HippoNet protocols in the network + basic information
GreenGo
Identifies the GreenGo protocols in the network + basic Devices
Multicast Streams
Set
DMX values, using Up/Down navigation
DMX In
DMX Out
sACN 01-04
View
Merge DMX output with incoming DMX signal
RDM Devices
If an RDM device is selected, the address and mode of the
Network traffic analyzer
about the ArtNet protocol
about the sACN protocol
a source (set in the
Protocol
Ethernet
Detector
Active
Lists the IP and MAC addresses of all active devices
Detects active multicast switches, detects multicast streams
about the MA-Net2 protocol
about the HogNet protocol
about the HippoNet protocol
information about the GreenGo protocol
IP Adress
Allows user to configure Tester's IP address
Allows user to customize the Tester Mask
Allows user to configure the Gateway Tester
GOOD
Correct connection
-->Pin X
Contact is mixed with Pin X
test
transmitting DMX data.
Capture mode
Single
Shows one cycle
Cont.
Shows continuously
D+
Source +
D-
Source -
DIFF
Difference between + and -
Slow LTC
Speed for signals with a long cycle (LTC)
Fast DMX/RDM
Speed for short cycle (LTC) signals
Break
Mark After Break
Mark before break
DMX-IN Signal Scope
Timecode Receiver v 1.0
24,25,30
Frame rate
DF30
NTSC Frame rate
Generate
Generate Time Code
Stop
Stop Time Code
Set the numbers by clicking on them and changing the navigation buttons
Run Test (Class4)
Interface address Config
Mask
These settings activate after
reboot.
Gateway
Cable Tester
DMX Timing
PIN test
Bitrate
Signal Shape Analysis
DMX-OUT Timing Config
N.C. Not connected
Check data rate. Indicates whether the cable is suitable for
Signal Source
Speed
24,25,30 Frame rate
These timings can be any value to add up to make a packet length of up to one second
Show signal shape analysis
Receives timecode from input port
Timecode
Timecode Generator v
1.0 Numbers
Run Test Run PoE Test
PoE Test
Run test for class 4 PoE
Loading...