ProMinent DULCOnneX Installation And Operating Instructions Manual
Installation and operating instructions
CAN
open
P PM 0038 SW
DULCOnneX
WiFi
DULCOnneX gateway
for compatible ProMinent® Ethernet controllers
EN
These operating instructions are only
valid in conjunction with the operating
instructions for the ProMinent® device
to be controlled.
Please carefully read these operating instructions before use. · Do not discard.
The operator shall be liable for any damage caused by installation or operating errors.
The latest version of the operating instructions are available on our homepage.
981828 BA PM 019 12/19 EN
Table of contents
Table of contents
1 About this unit......................................................................................................................... 3
2 Safety...................................................................................................................................... 4
3 Storage and Transport............................................................................................................ 6
4 Assembly................................................................................................................................. 7
4.1 Wall-mounting................................................................................................................ 7
4.2 Pipe Assembly................................................................................................................ 8
5 Installation, electrical............................................................................................................. 10
Commissioning of a controller with Ethernet connector on the DULCOnneX gateway......... 11
6
7 Troubleshooting.................................................................................................................... 14
7.1 Faults, particular........................................................................................................... 14
7.1.1 Checklist of requirements.......................................................................................... 14
7.1.2 Explanations for a better understanding of the "DULCOnneX gateway"................... 16
7.1.3 Potential problems when starting up......................................................................... 17
7.1.4 Router recommendations.......................................................................................... 17
8 Maintenance, Repair and Disposal....................................................................................... 19
8.1 Maintenance................................................................................................................. 19
8.2 Repairs......................................................................................................................... 19
8.3 Disposal........................................................................................................................ 19
9 Technical data....................................................................................................................... 20
10 Excerpt from the Declaration of Conformity.......................................................................... 21
2
About this unit
1 About this unit
The “DULCOnneX gateway” can communicate with many smart devices (smartphone, tablet, ...) or
desktop computers (PC, laptop, ...) via Wi-Fi or LAN. This enables CAN controllers, which have
been connected to the “DULCOnneX gateway” and that have been equipped by ProMinent for this
purpose, to be largely controlled and monitored by a smart device or desktop computer.
Order no. Controllable units
1098723 Controller AEGIS
1098756
Specific information must be stated in certain countries:
Country Information
USA: Contains FCC ID: 2ADHKATWINC1500
Canada: Contains IC: 29266ATWINC1500
Contiens IC: 29266-ATWINC1500
DULCOMETER® dialog DACb
3
Safety
2 Safety
CAUTION!
Danger from hackers
The user must guarantee the IT
security of his smart device (smart‐
phone, tablet, ...) to ensure that his
installation cannot be controlled by
hackers.
CAUTION!
Danger from hackers
With regard to passwords, apply the
generally accepted rules for a secure
password (minimum length, special
characters, lower/upper case, no
names...).
CAUTION!
Do not modify the unit.
In particular do not increase the size of
the aerial.
Intended use
n Only use the unit to monitor ProMinent
controllers in accordance with the oper‐
ating instructions.
n Only use the unit once it has been cor‐
rectly installed and started up in accord‐
ance with the technical data and specifica‐
tions contained in the operating
instructions.
n All other uses, software modifications or
conversions are prohibited.
n This network-capable product is not
intended for communication with other
mobile communication or network-capable
products in critical infrastructures without
the use of compensating measures in
accordance with the applicable regula‐
tions.
n The unit is not intended for use outdoors
without appropriate protective measures.
n Only allow trained and authorised per‐
sonnel to operate the unit.
n You have a responsibility to adhere to the
information contained in the operating
instructions at the different phases of the
unit's service life.
®
NOTICE!
Warning against illegal operation
Observe the regulations that apply
where the unit is installed.
4
Qualification of personnel
Personnel must:
n Be familiar with smart devices.
n Be familiar with network technology and
Ethernet technology.
n Have read and understood these operating
instructions.
Licenses for this Wi-Fi unit
The Wi-Fi unit may be operated licence-free in
the following countries:
Safety
Germany, Canada, USA
Belgium, Denmark, Estonia, Finland, France,
Greece, Great Britain, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands,
Norway, Austria, Poland, Portugal, Sweden,
Switzerland, Slovakia, Slovenia, Spain, Czech
Republic, Hungary and Cyprus.
CAUTION!
For all other countries:
Check whether the operation of the WiFi unit is permitted in the country in
question. Please get in touch with the
ProMinent head office.
Emissions
WARNING!
The “DULCOnneX gateway” is not
designed for applications in which inter‐
ference from or by the “DULCOnneX
gateway” can lead to fatal injury,
serious personal injury or serious mate‐
rial damage.
Start up the unit in accordance with the official
start-up instructions:
This unit complies with Part 15 of the FCC Reg‐
ulations. The following 2 conditions must be ful‐
filled for operation: (1) This unit should not
cause any hazardous interference, and (2) this
unit should tolerate all interference, including
interference that can cause undesirable opera‐
tion.
WARNING!
The Wi-Fi unit can cause interference
to or even destroy radio and television
frequencies.
It is essential to avoid this.
– For remedies, refer to the "Trou‐
bleshooting" chapter.
5
Storage and Transport
3 Storage and Transport
CAUTION!
Protect the module from moisture and
the effects of chemicals, even when still
packaged!
Store and transport the module it its original
packaging.
Ambient conditions for storage and transporta‐
tion:
n Temperature: -20 °C ... +60 °C
n Max. permissible relative humidity (DIN EN
60068-2-30): 95%, non-condensing
6
4 Assembly
2
1
A0273
CAUTION!
There needs to be Wi-Fi reception at the intended site of the "DULCOnneX gateway".
The unit is suitable for mounting on a wall or a pipe.
Tab. 1: Mounting materials (contained in the scope of delivery):
Description Quantity
Wall/tube retaining bracket 1
Half-round head screws 5x45 mm 2
Washer 5.3 2
Rawlplug Ø 8 mm, plastic 2
Sealing cap 1
Cable tie 2
Assembly
Locking screw (PT) 1
4.1 Wall-mounting
Assembly (mechanical)
Fig. 1: Removing the wall/tube retaining bracket
1. Remove the wall/tube retaining bracket.
Pull the two snap-hooks (1) outwards
and push upwards
2. Fold out the wall/tube retaining bracket
(2) and pull out downwards
3. Mark two drill holes diagonally to each
other, using the wall/tube retaining
bracket as a drilling template
4. Drill holes: Ø 8 mm, d = 50 mm
7
A0274
2
1
A0273
Assembly
Fig. 2: Screw the wall/tube retaining bracket in
place with washers
5. Screw the wall/tube retaining bracket in
place with washers
6. Suspend the device on the top of the
wall/tube retaining bracket and, using
light pressure at the bottom, press it
against the wall/tube retaining bracket.
Then press upwards until the device
audibly snaps into position
4.2 Pipe Assembly
Assembly (mechanical)
Pipe diameter
Pipe diameter: 25 mm to 60 mm.
Fig. 3: Removing the wall/tube retaining bracket
1. Remove the wall/tube retaining bracket.
Pull the two snap-hooks (1) outwards
and push upwards
2. Fold out the wall/tube retaining bracket
(2) and pull out downwards
3. Secure the wall/tube retaining bracket
using cable ties (or pipe clips) to the
pipe
8
Loading...