PROLiNK WNR1009 User Manual

PROLiNK WNR1009 and WNR1010 Universal Repeater Setup Guide

• Connect a LAN cable from any LAN port from the WNR1009/1010 to your LAN
Port in your PC.

1) Open IE and access http://192.168.123.254 and enter admin as username and
password as password.

2) Go to Wireless Settings > Basic Settings > Mode: Change to “Client” > Apply
Changes > Reboot Later

3) Go to Site Survey > Click “Site Survey” > It will scan the list of wireless AP
available > Select your wireless AP SSID e.g. PROLiNK_H5004N > Next

4) If your wireless AP is secured with wireless encryption, you need to key in the
password when prompted, then click “Connect”.

It will show “Connect successfully” if the password entered is correct. Click “OK”

5) Go back to Basic settings > You will see the SSID had been changed to your
connected wireless AP SSID > Tick “Enable Universal Repeater Mode” > You can
change the SSID of Extended Interface – this is the SSID you will see for your
WNR1009/1010 when in repeater mode. Click “ Apply Changes” > Reboot Later