PROLiNK PHA5010 User Manual

5GHz Outdoor Rugged Fixed Wireless

802.11a Access Point / Wireless Bridge Client (CPE)

Key Features

Up to 8km LOS range with integrated 18dBi antenna*
Outdoor waterproof IP65 Casing
Up to 108 Mbps (Turbo Mode)
MAC filtering & Remote AP Association Control
WPA, WPA-PSK, WEP and AES security
Bandwidth control with QoS VOIP and video.
Web and SNMP management.

Wireless Features

• IEEE 802.11a/h compliant radio, up to 54Mbps

• Support DFS and TPC.

• RF Power control between 100% to 12.5% of max power

• Support seamless roaming within the same subnet

between Access Point

• Best for used as Wireless Bridge Client (CPE)

• Support with or without wireless distribution system

(WDS)

Network (Internet and Intranet)

• Protocol Filtering

Security and Access Control for Client Mode

• Support static WLAN WEP up to 152 bits encryption

• MAC Address Control

• WPA with Radius Server for EAP-TLS, EAP-TTLS and EAP-

PEAP (In Access Point mode)

• WPA-PSK (AES and TKIP)

•

Wireless to wireless user isolation

Management

• Web-based management

• SNMP V1 & V2c management

• IP address discovery software (Viper Quick Start)

• Firmware upgradeable through web-server and telnet

Hardware

• Chassis Type: IP65 Rating with Bracket for pole mounting

• Ethernet Port: 10/100 Base-T auto MDIX

PHA-5010-Lite

PHA-5010-Gold

RF Specification

Frequency 4.900 ~ 5.875 GHz

Wireless Data Rate 54, 48, 36, 24, 18, 12, 9, 6 Mbps

Up to 108Mbps for Turbo mode

Channels Country dependent

Transmit Power Up to 20dBm

Modulation OFDM, BPSK, QPSK, 16QAM,

64QAM

Receiver Sensitivity -90dBm for 6Mbps

-89dBm for 9Mbps

-88dBm for 12Mbps

-87dBm for 18Mbps

-84dBm for 24Mbps

-81dBm for 36Mbps

-74dBm for 48Mbps

-71dBm for 54Mbps

Built-in Antenna Gain 18 dBi (5.1 ~ 5.9 GHz)

> 14 dBi (4.9 ~ 5.1 GHz)

Power Specification

• Power adapter: 18~48V DC through RJ45

• Power Consumption: Typical 6.5 Watts, 7.0 Watts Max

Environment

• Operating Ambient Temperature: 0ºC to +60ºC

• Operating Relative Humidity: 20~90% (non-condensing)

• Storage Ambient Temperature: -30ºC to 75ºC

• Storage Relative Humidity: 95% Max (non-condensing)

Ordering Model

• AP-5010-Gold: Support Access Point and

• AP-5010-Lite: Support Wireless Bridge Mode.

Standard Package

The standard package for AP-5010 comes with the following:

1) PHA-5010

2) 3m UTP cable (RJ45)

3) 48V DC combiner adaptor (PoE)

3) Screws, nuts, and washers

4) Mounting bracket (pole)

Specification are subject to changes without prior notice due to engineering improvement. Wireless range
and performance may vary with environment. Al l brands and product names are trademarks or registered
trademarks of their respective holders.

* Distance between AP based station. Distance may vary with environment.

Wireless Bridge Mode.