Pro-Link MVP1500 User Manual

Material Safety Data Sheet
Sanitex MVP Surface Cleaner
Page 1 Issued: September 18, 2012
Component
CAS #
Ethanol
64-17-5
Glycerin
56-81-5
Propylene Glycol
57-55-6
Water
7732-18-5
1. PRODUCT AND COMPANY IDENTIFICATION
Product Name: Surface Cleaner
Distributed by: Vectair Systems, Inc.
Memphis, TN 38111
Telephone Number: (877) 697-7276 Website: www.vectairsystems.com
2.
COMPONENTS
3. HAZARD IDENTIFICATION
Potential Health Effects
Eye contact Moderately irritating to eyes.
Skin Contact This product is safe for contact with the skin, but prolonged exposure may cause skin dryness.
Inhalation Inhalation can lead to feeling of light-headedness.
Ingestion Ingestion can lead to loss of consciousness or death.
Material Safety Data Sheet
Sanitex MVP Surface Cleaner
Page 2 Issued: September 18, 2012
5.
FIRE-FIGHTING MEASURES
Flash point: 55 ºF (minimum)
Flammable Limits (volume percent in air):
LEL: Not Established
UEL: Not Established
Autoignition Temperature: Not determined
4. FIRST AID MEASURES
Eyes: Flush with water for fifteen minutes. If burning persists, see a physician. Do not rub eyes. Skin: In the case of chapped hands, apply a skin moisturizer. Ingestion: Immediately rinse mouth out with water. Do not induce vomiting. Get medical attention. Inhalation: Remove to fresh air. Seek medical attention if symptoms persist.
Fire-Fighting
Keep fire exposed containers cool with water spray. Separate unburning product from fire. Use carbon dioxide, foam, or dry chemical extinguishing media to put out fires.
Unusual Decomposition Products Under Fire Conditions None
6. ACCIDENTAL RELEASE MEASURES
Personal Precautions Rinse thoroughly after contact. Launder contaminated clothing before reuse.
Environmental Precautions Remove all sources of heat or flame. Dike large spills to prevent ingress into sewers. Clean spills with absorbent and store in marked containers for disposal. Dispose in accordance with all applicable regulations. Flush area with water to remove slippery floor hazard.
7. HANDLING AND STORAGE
Safe Handling and Storage Store containers away from sources of heat or flame. Do not smoke around or while using this product. Keep containers inside and out of direct sunlight. Avoid storage temperatures above 100 ºF and below 40 ºF. Do not reuse containers.
Incompatible Products Avoid strong oxidizing and reducing agents.
Material Safety Data Sheet
Sanitex MVP Surface Cleaner
Page 3 Issued: September 18, 2012
8. EXPOSURE CONTROL AND PERSONAL PROTECTION
Ventilation Not necessary when used as directed and work place exposure guidelines are maintained. If work place exposure guidelines are to be exceeded, use proper ventilation to maintain safe environment.
Respiratory Equipment Not required when work place exposure guidelines are maintained.
Protective Gloves Not Required. This product is safe for skin contact. If prolonged skin contact is expected, use of chemical resistant gloves is recommended.
Work Place Exposure Guide Lines Ethanol has a PEL of 1000 ppm; TLV of 1000 ppm
9. PHYSICAL AND CHEMICAL
PROPERTIES
Specific Gravity (water =1): 0.90 Vapor Pressure (mm Hg): Not
Established Melting Point: Not Applicable Vapor Density (Air =1): >1
Evaporation Rate (butyl Acetate=1): 1.2 Solubility in Water: Soluble Reactivity in Water: NIL Appearance: Colorless liquid Odor: Low odor
Boiling Point: 180 ºF
10. STABILITY AND REACTIVITY
Unstable [ X ] Stable Conditions to Avoid: None Incompatibility (Materials to avoid): Strong oxidizing and reducing agents. Hazardous Decomposition Products: Thermal decomposition may produce oxides of carbon and
nitrogen.
Hazardous Polymerization: [ ] May Occur [ X ] Will Not Occur Conditions to Avoid: Not Applicable.
Stability: [ ]
11. TOXICOLOGICAL INFORMATION
This product is believed to have a low toxicity and should not pose a hazard to health when used correctly in industry.
Material Safety Data Sheet
Sanitex MVP Surface Cleaner
Page 4 Issued: September 18, 2012
Health
1
Key
Flammability
3
4 = Severe
Reactivity
0
3 = Serious
2 = Moderate
1 = Slight
0 = Minimal
12. ECOLOGICAL INFORMATION
Please refer to Section 6 for accidental release information and Section 15 for reporting information.
13. DISPOSAL CONSIDERATIONS
Waste product can be disposed of by wastewater treatment or in an approved landfill according to all applicable regulations. Containers should be washed and sent to a plastic recycler.
14. TRANSPORT INFORMATION
This product is considered hazardous to transport. Transportation Name: UN1170, Ethanol Solutions, 3, PG II
15. REGULATORY INFORMATION
TSCA The components of this product are listed on the TSCA Inventory.
CERCLA If this product is spilled it does not require reporting under CERCLA.
SARA Title III SARA Title III does not apply to this product.
16. OTHER INFORMATION
This product has the following rating under the Hazardous Materials Identification System.
Loading...