MATERIAL SAFETY DATA SHEET
1. Product and Company Identification
Material name
Version #
Issue date
Revision date
Supersedes date
CAS #
Manufacturer/Supplier
A358T Cool Cucumber
01
05-15-2012
-
-
Mixture
Pro-Link, Inc.
500 Chapman Street
Canton, MA 02021
Telephone number:
Emergency
(781) 828-9550
24-Hour Emergency: PROSAR: (866) 303-6948
2. Hazards Identification
Physical state
Appearance
Emergency overview
OSHA regulatory status
Potential health effects
Routes of exposure
Eyes
Skin
Inhalation
Ingestion
Potential environmental effects
Liquid.
Clear, pale yellow liquid.
WARNING
Combustible liquid and vapor.
Causes skin irritation.
This product is hazardous according to OSHA 29 CFR 1910.1200.
Inhalation. Eye contact. Skin contact.
Direct contact with eyes may cause temporary irritation.
Causes skin irritation.
In high concentrations, vapors may be irritating to the respiratory system.
No harmful effects expected in amounts likely to be ingested by accident.
The product is not classified as environmentally hazardous. However, this does not exclude the
possibility that large or frequent spills can have a harmful or damaging effect on the environment.
3. Composition / Information on Ingredients
Components CAS # Percent
142-92-7 15 - 25Hexyl Acetate
78-70-6 5 - 15Linalool
Composition comments
All concentrations are in percent by weight.
4. First Aid Measures
First aid procedures
Eye contact
Skin contact
Inhalation
Ingestion
Immediately flush with plenty of water for up to 15 minutes. Remove any contact lenses and open
eyelids wide apart. In case of irritation from airborne exposure, move to fresh air. Get medical
attention if symptoms persist.
Wash with soap and water. Get medical attention if symptoms occur after washing.
If symptomatic, move to fresh air. Get medical attention if symptoms persist.
Rinse mouth thoroughly. Seek medical advice. Only induce vomiting at the instruction of medical
personnel.
5. Fire Fighting Measures
Flammable properties
A358T Cool Cucumber
200 Version #: 01 Revision date: - Issue date: 05-15-2012
908
The product is combustible, but not flammable.
CPH MSDS NA
CPH MSDS NA
1 / 6
Extinguishing media
without risk. Dike the spilled material, where this is possible.
Canada. Ontario OELs. (Control of Exposure to Biological or Chemical Agents)
Suitable extinguishing
media
Unsuitable extinguishing
media
Protection of firefighters
Protective equipment and
precautions for firefighters
Fire fighting
equipment/instructions
Hazardous combustion
products
Water fog. Carbon dioxide (CO2). Dry chemical. Foam.
Do not use water jet as an extinguisher, as this will spread the fire.
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
Use water spray to cool unopened containers. Cool containers with flooding quantities of water
until well after fire is out.
Carbon oxides.
6. Accidental Release Measures
Personal precautions
Environmental precautions
Methods for cleaning up
Ensure adequate ventilation. Eliminate all ignition sources (no smoking, flares, sparks or flames in
immediate area). Avoid contact with skin. See Section 8 of the MSDS for Personal Protective
Equipment.
Do not contaminate water. Contact local authorities in case of spillage to drain/aquatic
environment.
Remove sources of ignition. Beware of the explosion danger. Stop the flow of material, if this is
Small Spills: Absorb spillage with non-combustible, absorbent material.
Large Spills: Use a non-combustible material like vermiculite, sand or earth to soak up the product
and place into a container for later disposal.
7. Handling and Storage
Handling
Storage
Wear appropriate personal protective equipment. Provide adequate ventilation. Avoid contact with
eyes, skin, and clothing. Do not taste or swallow. Wash thoroughly after handling.
Do not handle or store near an open flame, heat or other sources of ignition. Protect against direct
sunlight. Store in tightly closed original container in a dry, cool and well-ventilated place. Keep
away from food, drink and animal feeding stuffs. Store away from incompatible materials. Avoid
uncoated metal containers. Minimize exposure to air.
8. Exposure Controls / Personal Protection
Occupational exposure limits
TypeComponents
TWAHexyl Acetate (142-92-7) 294 mg/m3
Engineering controls
Personal protective equipment
Eye / face protection
Skin protection
Respiratory protection
General hygiene
considerations
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates
should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation,
or other engineering controls to maintain airborne levels below recommended exposure limits. If
exposure limits have not been established, maintain airborne levels to an acceptable level.
Wear safety glasses with side shields (or goggles).
Wear chemical-resistant gloves, footwear and protective clothing appropriate for risk of exposure.
Contact glove manufacturer for specific information.
In case of inadequate ventilation use suitable respirator.
Always observe good personal hygiene measures, such as washing after handling the material
and before eating, drinking, and/or smoking. Routinely wash work clothing and protective
equipment to remove contaminants.
Value
50 ppm
9. Physical & Chemical Properties
Appearance
Physical state
Form
Color
A358T Cool Cucumber
08200 Version #: 01 Revision date: - Issue date: 05-15-2012
9
Clear, pale yellow liquid.
Liquid.
Liquid.
Colorless to pale yellow.
CPH MSDS NA
CPH MSDS NA
2 / 6