Page 1
Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin MN Power-Clean
—————————————————————————————————————————————
1 Identification of substance:
Product details:
Trade name: Lithofin MN Builders’ Clean
Application of the substance / the preparation Cleaning agent/ Cleaner
Distributor:
GranQuartz, L. P.
P.O. Box 2206
Tucker, GA 30085-2206/USA
Information Department:
see above
Emergency Information:
information department
24-Hour Emergency Telephone Number:
1-800-255-3924 (USA & Canada) or 813-248-0585
—————————————————————————————————————————————
2 Composition/Data on components:
Chemical characterization
Description: Alkaline cleaner
Dangerous components:
111-76-2 2-butoxyethanol 2.5-10 %
RTECS: KJ 8575000
67-63-0 propan-2-ol 2.5-10 %
RTECS: NT 8050000
497-19-8 sodium carbonate 2.5-10 %
68131-39-5 Isotridecanolethoxylat 2.5-10 %
Fatty alcohol ethoxylated < 2.5 %
TSCA
7732-18-5 water, distilled, conductivity or of similar purity
111-76-2 2-butoxyethanol
67-63-0 propan-2-ol
497-19-8 sodium carbonate
102-71-6 2,2',2''-nitrilotriethanol
527-07-1 sodium gluconate
28348-53-0 sodium cumenesulphonate
—————————————————————————————————————————————
3 Hazards identification
Hazard description: Corrosive
Information pertaining to particular dangers for man and environment
Causes burns.
Classification system Classification based on pH-value
NFPA ratings (scale 0-4)
Health = 1
Fire = 0
Reactivity = 0
Special: Alk
—————————————————————————————————————————————
1
Page 2
Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin MN Power-Clean
—————————————————————————————————————————————
4 First aid measures
General information
Immediately remove any clothing soiled by the product.
After inhalation
In case of complaints which may be caused by vapours supply fresh air and call for a doctor.
After skin contact
Take-off and remove wetted clothing, shoes and stocking immediately.
Rinse affected parts of the body with plenty of water.
Immediate medical treatment necessary. Failure to treat burns can prevent wounds from healing.
After eye contact
First check the victim for contact lenses and remove if present.
Rinse the eyes with open eyelids for 10 - 15 minutes with water. Then consult an eye specialist
immediately.
After swallowing
Do not induce vomiting
Drink plenty of water, but never give anything to an unconscious person.
Seek medical treatment.
Information for doctor
Treatment
Symptomatic treatment
In cases of irritation to the lungs, initial treatment with Dexametason metered aerosol.
—————————————————————————————————————————————
5 Fire fighting measures
Suitable extinguishing agents
The product is not combustible and does not support combustion.
Use fire fighting measures that suit the environment.
Special hazards caused by the material, its products of combustion or resulting gases:
No hazards known
Protective equipment:
Wear self-contained respiratory protective device.
Wear fully protective suit.
Additional information
Dispose of fire debris and contaminated fire fighting water in accordance with official regulations.
Collect contaminated fire fighting water separately. It must not enter the sewage system.
—————————————————————————————————————————————
6 Accidental release measures
Person-related safety precautions:
Ensure adequate ventilation
Wear protective clothing.
Keep unprotected persons away.
Measures for environmental protection:
Do not allow product to reach sewage system or any water course.
Do not allow to penetrate the ground/soil.
Measures for cleaning/collecting:
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Use neutralizing agent.
Send for recovery or disposal in suitable receptacles.
Dispose contaminated material as waste according to item 13.
—————————————————————————————————————————————
7 Handling and storage
Handling
Information for safe handling:
Use only in well ventilated areas.
2
Page 3
Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin MN Power-Clean
Avoid contact with eyes and skin.
Avoid inhalation of vapours.
Prevent formation of aerosols.
Only use alkali-resistant equipment.
Information about protection against explosions and fires:
No special measures required.
Storage
Requirements to be met by storerooms and receptacles:
Store receptacles tightly closed at a cool and dry place with sufficient ventilation
Store only in the original receptacle.
Provide alkali-resistant floor.
Information about storage in one common storage facility:
Store away from foodstuffs.
Store away from feed.
Do not store together with acids.
Further information about storage conditions:
Keep receptacle tightly sealed.
—————————————————————————————————————————————
8 Exposure controls and personal protection
Additional information about design of technical systems:
No further data; see item 7.
Components with limit values that require monitoring at the workplace:
111-76-2 2-butoxyethanol
PEL: 240 mg/m³, 50 ppm
Skin
REL: 24 mg/m³, 5 ppm
Skin
TLV: 97 mg/m³, 20 ppm
67-63-0 propan-2-ol
PEL: 980 mg/m³, 400 ppm
REL: short-term value: 1225 mg/m³, 500 ppm
long-term value: 980 mg/m³, 400 ppm
TLV: short-term value: 984 mg/m³, 400 ppm
long-term value: 492 mg/m³, 200 ppm
Additional information:
The lists that were valid during the creation were used as basis.
Personal protective equipment
General protective and hygienic measures
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
Provide eye wash facility.
If larger quantities are handled provide emergency showers.
The usual protective measures based on the application have to be followed.
All protective equipment used shall be according to 29 CFR.1910 Subpart I Personal Protective
Equipment
Breathing equipment:
Not necessary if room is well-ventilated.
A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements
or European Standard EN 149 must be followed whenever workplace conditions warrant a respirator's
use.
Always use a NIOSH or European Standard EN 149 approved respirator when necessary.
Protection of hands:
Alkali-resistant gloves
3
Page 4
Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin MN Power-Clean
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
After use of gloves apply skin-cleaning agents and skin cosmetics.
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer.
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has
to be observed.
Eye protection: Tightly sealed goggles.
Body protection: Alkali-resistant protective clothing
—————————————————————————————————————————————
9 Physical and chemical properties:
General Information
Form: Liquid
Color: Colorless, clear
Odor: Pleasant
Value/Range Unit Method
Change in condition
Melting point/Melting range: undetermined
Boiling point/Boiling range: > 90 ° C
Flash point: > 65 ° C
Auto igniting: Product is not selfigniting.
Danger of explosion: Product does not present an explosion hazard.
Density: at 20° C ~ 1.1 g/cm³
Solubility in / Miscibility with Water: Fully miscible
pH-value: at 20° C 10-13 in delivery state
—————————————————————————————————————————————
10 Stability and reactivity
Thermal decomposition / conditions to be avoided:
No decomposition if used and stored according to specifications.
Materials to be avoided: Acids
Dangerous reactions No dangerous reactions known
Dangerous products of decomposition:
No dangerous decomposition products known
—————————————————————————————————————————————
11 Toxicological information
Acute toxicity:
LD/LC50 values that are relevant for classification:
No toxicity data are available for the product itself.
Primary irritant effect:
on the skin:
Caustic effects on mucous membranes and respiratory tract possible.
on the eye: Caustic effect
Sensitization: No sensitizing effects known.
4
Page 5
Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin MN Power-Clean
Additional toxicological information:
The product was classified as corrosive, because the pH-value is < = 2 or > = 11.5. It is taken for
granted that a pH-value of < = 2 or > = 11,5 will lead to the same results as experimental tests with
corrosive substances do. Swallowing may lead to a strong caustic effect on mouth, throat and
stomach.
—————————————————————————————————————————————
12 Ecological information:
Ecotoxical effects:
Acquatic toxicity:
Presently there are no ecotoxicological values available.
Remark: Harmful effects possible due to shift of pH value.
General notes:
Do not allow product to reach ground water, water course or sewage system.
Danger to drinking water if even small quantities leak into the ground.
—————————————————————————————————————————————
13 Disposal considerations
Product:
Recommendation
Must not be disposed of together with household garbage. Do not allow product to reach sewage
system. Disposal according to instructions of local authorities.
Uncleaned packagings:
Recommendation:
Disposal must be made according to official regulations.
Non contaminated packaging can be used for recycling.
—————————————————————————————————————————————
14 Transport information
DOT regulations:
Hazard class: 8
Identification number: UN1719
Packing group: III
Proper shipping name (technical name):
CAUSTIC ALKALI LIQUID, N.O.S. (sodium carbonate)
Label 8
Land transport ADR/RID (cross-border)
ADR/RID class: 8 (C5) Corrosive substances
Danger code (Kemler): 80
UN-Number: 1719
Packaging group: III
Label 8
Description of goods: 1719 CAUSTIC ALKALI LIQUID, N.O.S. (sodium carbonate)
Maritime transport IMDG:
IMDG Class: 8
UN Number: 1719
Label 8
Packaging group: III
EMS Number: F-A,S-B
Marine pollutant: No
Propper shipping name: CAUSTIC ALKALI LIQUID, N.O.S. (sodium carbonate)
Air transport ICAO-TI and IATA-DGR:
ICAO/IATA Class: 8
UN/ID Number: 1719
Label 8
5
Page 6
Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin MN Power-Clean
Packaging group: III
Propper shipping name: CAUSTIC ALKALI LIQUID, N.O.S. (sodium carbonate)
————————————————————————————————————————————
15 Regulations
Cancerogenity categories
EPA (Environmental Protection Agency)
void
IARC (International Agency for Research on Cancer)
67-63-0 propan-2-ol: 3
102-71-6 2,2',2''-nitrilotriethanol: 3
diethanolamine: 3
NTP (National Toxicology Program)
void
TLV (Threshold Limit Value established by ACGIH)
void
MAK (German Maximum Workplace Concentration)
void
NIOSH-Ca (National Institute for Occupational Safety and Health)
void
OSHA-Ca (Occupational Safety & Health Administration)
void
Markings according to EU guidelines:
Code letter and hazard designation of product: Corrosive
Risk phrases: Causes burns.
Safety phrases:
Keep locked up and out of the reach of children.
When using do not eat or drink.
Avoid contact with skin and eyes.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
Wear suitable protective clothing and gloves.
If swallowed, rinse mouth with water (only if the person is conscious)
Regulation or reporting requirements USA
Sara section 355
not listed
Sara section 313
67-63-0 propan-2-ol
Prop. 65 - Cancer
not listed
Prop. 65 - Repr. tox.
not listed
—————————————————————————————————————————————
16 Other information:
This information is based on our present knowledge. However, this shall not constitute a guarantee for
any specific product features and shall not establish a legally valid contractual relationship.
Department issuing MSDS:
KFT-Chemieservice Marienstr. 3 D-64347 Griesheim
Postfach 1451 D-64345 Griesheim
Tel.: +49-6155-823241
Fax: +49-6155-823246
Contact: Angelika Torges
—————————————————————————————————————————————
6
Loading...