Pro-Link 08901 User Manual

Urethane II

NFPA/HMIS : Health -1
Flammability - 0
Reactivity - 0

Complies With USDL Safety and Health Regulations, (29 CFR

1910.200)
Material Safety Data Sheet
US Department Of Labor

SECTION - 1 CHEMICAL AND COMPANY IDENTIFICATION

PRODUCT USE: Floor Finish

Pro Link
510 Chapman Street
Canton, Ma 02021

EMERGENCIES: 1-866-303-6948
REVISION DATE: 02/14/05

SECTION - 2 COMPOSITION ON INGREDIENTS

CAS # Chemical Names Wt% TLV (units)
111-90-0 Glycol Ether DE < 6 N/E

N/E = not established

SECTION - 3 HAZARDS INFORMATION

Primary Route(s) of Entry: Skin contact /absorption and inhalation
Signs and Symptoms of Overexposure: Gastrointestinal irritation

(nausea, vomiting, diarrhea), irritation to nose, throat, and respiratory
tract.
Target Organ Effects: Overexposure to this material (or its
components) has been suggested as a cause of the following
effects in laboratory animals and may aggravate pre-existing disorders
or these organs in humans: chronic ingestion may cause kidney and
liver lesions at high doses.
IMMEDIATE HEALTH EFFECTS:

EYES: Exposure may cause noticeable pain, and severe irritation.
SKIN: Exposure may cause mild skin irritation. Prolonged or repeated

exposure may dry the skin. Symptoms may include redness, burning,
drying and cracking and skin burns. Additional symptoms of skin
contact may include: allergic reaction. Skin absorption is possible, but
harmful effects are not expected from this route of exposure under
normal handling and use.
INHALATION: Exposure to vapor or mist is possible. Short term
inhalation is no likely to cause harmful effects: breathing large amounts
may be harmful. Symptoms are more typically seen at air
concentrations exceeding the recommended exposure limits.
INGESTION: Single dose oral toxicity is low. Swallowing small
amounts during normal handling is not likely to cause harmful effects:
swallowing large amounts may be harmful.
REPRODUCTIVE / DEVELOPMENTAL INFORMATION:
No Data
CARCINOGENIC INFORMATION: This material is not listed as a
carcinogen by IARC, NTP, or OSHA

LONG TERM EFFECTS: No Data

SECTION - 4 FIRST AID MEASURES

EYES- Immediately flush with water. Remove contact lenses if

applicable, and continue flushing with water. Call a physician if
irritation persists.
SKIN- Flush with water. Wash thoroughly with soap and water. Call
physician if irritation persists.
INHALATION- If symptoms develop, move victim to fresh air. If
symptoms persist, call a physician.

INGESTION- Do not induce vomiting. Rinse mouth with water, then
drink one glass of water. Call physician immediately. Never give
anything by mouth if victim is unconscious, is rapidly losing
consciousness or is convulsing.

SECTION - 5 FIRE FIGHTING MEASURES

Flash Point: No Flash at Boil (C.C. method)
Explosive limits: Not Applicable
Autoignition Temperature: Not Applicable
Hazardous Products of Combustion: Not Applicable
Extinguishing Media: Not Applicable
Fire Fighting Instructions: Avoid contact with this material. Avoid

walking in spilled material. Wear protective clothing for
skin and eyes

SECTION - 6 ACCIDENTAL RELEASE MEASURES

Small Spill: Absorb with an inert solid and scoop up for disposal, then

rinse soiled area with water down the drain.
Large Spill: Stop leak at the source and collect into a suitable
container, then treat as a small spill.

SECTION - 7 HANDLING AND STORAGE

Handling: Containers of this material may be hazardous when

emptied. Since emptied containers retain product residues (vapor,
liquid, and/or solid), all hazard precautions given in the data sheet
must be observed.
Storage: Store in a cool, dry place. Keep container closed when not in
use.

SECTION - 8 EXPOSURE CONTROLS / PERSONAL PROTECTION

Eye Protection: Chemical Splash goggle in compliance with OSHA

regulations are advised: however , OSHA regulations also permit other
type safety glasses. Consult your safety representative.
Skin Protection: Wear rubber gloves (consult your safety equipment
supplier). To prevent repeated or prolonged skin contact, wear
impervious clothing and boots.
Respiratory Protection: If workplace exposure limits of product or any
component are exceeded (see exposure guidelines) NIOSH/OSHA
approved air supplied respirator is advised in the absence of proper
environmental control.
OSHA relations also permit other NIOSH/OSHA respirators (negative
pressure type) under specific conditions (see your industrial hygienist).
Engineering or administrative controls should be implemented to
reduce exposure.
Engineering Controls: Provide sufficient mechanical (general and
local exhaust) ventilation to maintain exposure below level of
overexposure (from known, suspected or apparent adverse effects).

SECTION - 9 PHYSICAL AND CHEMICAL PROPERTIES

Appearance and odor: Opaque liquid with an ammonia odor
pH Concentrate: 8.0 - 9.0
Vapor Pressure: Unknown
Vapor Density: Unknown
Boiling Point: 209 Degrees Fahrenheit
Solubility in Water: Emulsion
Percent Volatile: 83%
Specific Gravity:(H2O =1) 1.04 +/- 0.02

SECTION - 10 STABILITY AND REACTIVITY

Chemical Stability: Stable
Conditions to Avoid: Temperature Extremes
Incompatibility: None
Hazardous Decomposition: Will not Occur
Hazardous Polymerization: Will not Occur

SECTION - 11 TOXICOLOGICAL INFORMATION

No Data Available

SECTION - 12 ECOLOGICAL INFORMATION

No Data Available

SECTION - 13 DISPOSAL CONSIDERATION

Waste Disposal Information: Dispose of in accordance with all

applicable Federal, State, and Local regulations.
RCRA Information: If this material becomes a waste, it would not be
considered hazardous under 40 CFR 261.22.

SECTION - 14 TRANSPORT INFORMATION

DOT Information 49 CFR 172.101

DOT Description:33440 Class 55
DOT Hazard Class:Non Hazardous
Hazardous Component:None

Reportable Quantity (RQ) - 49 CFR 172.101

Not Applicable

US Federal Regulations
TSCA (Toxic Substances Control Act) Status
TSCA (United States) The intentional ingredients of this product are
listed.
CERCLA RQ - 40 CFR 355 Appendix A:None
SARA 302 Components 40 CFR Appendix A: None
Section 311/312 Hazard Class 40 CFR 370.2
Immediate (X) Delayed (X) Fire ( ) Reactivity ( ) Sudden Release of
Pressure ( )
SARA 313 Components - 40 CFR 372.65
CAS # Chemical Names %
N/A * Glycol Ethers < 6.0
* Listed in Section 2 as Diethylene Glycol Monomethyl Ether

State and Local Regulations

California Proposition 65: None
California SCAQMD Rule 443.1 VOC’s: > 100g/L
North Carolina Administrative Code 2D.1104 and 2B.0610 None
South Carolina Regulation 62.5 Standard Number 8
None

The information accumulated herein is believed to be accurate but is
not warranted to be whether originating with the company or not.
Recipients are advised to confirm in advance of need that the
information is current, applicable and suitable to their circumstances.
This information was compiled from current manufacturer’s MSDS’s of
the component parts of the product. as well as other sources, such
as:
Code of Federal Regulations 29, Revised as of July 1. 1994.
Code of Federal Regulations 40, Revised as of July 1, 1994.
ACGIH, Guide to Occupational Exposure Values, 1996.
ANSI Z129.1-1994, Precautionary Labeling for Hazardous Industrial
Chemicals.
Hazard Communication Handbook, A Right To Know Compliance
Guide. Craig A. Moyer & Michael Francis. Clark Broadman Company.
Ltd. New York, NY 1992

RCRA Regulations and Keyword Index, Compiled and Published by
McCoy and Associates, Inc Lakewood, Colorado. 1992.

SECTION - 15 REGULATORY INFORMATION

SECTION - 16 OTHER INFORMATION