Pro-Link 06127 User Manual

REPRODUCTIVE / DEVELOPMENTAL INFORMATION: No Data
CARCINOGENIC INFORMATION: This material is not listed as a

carcinogen by IARC, NTP, or OSHA
LONG TERM EFFECTS: No Data

Protein Spotter #3

NFPA/HMIS : Health -1
Flammability - 0
Reactivity - 0

Complies With USDL Safety and Health Regulations, (29 CFR

1910.200)
Material Safety Data Sheet US Department Of Labor

SECTION - 1 CHEMICAL AND COMPANY IDENTIFICATION

PRODUCT USE: Carpet Spotter

PRO-LINK
510 Chapman Street
Canton, MA 02021

EMERGENCIES: 1-800-255-3924
REVISION DATE: 06/16/03

SECTION - 2 COMPOSITION ON INGREDIENTS

CAS # CHEMICAL NAMES Wt% TLV (UNITS)

67-62-0 Ispropanol <10 400(ppm) TWA
1336-21-6 Ammonia < 2 35 (PPM) STEL

SECTION - 3 HAZARDS INFORMATION

Primary Route(s) of Entry: Skin contact /absorption and inhalation
Signs and Symptoms of Overexposure: Gastrointestinal irritation

(nausea, vomiting, diarrhea), irritation to nose, throat, and respiratory
tract.
Target Organ Effects: Overexposure to this material (or its
components) has been suggested as a cause of the following
effects in laboratory animals and may aggravate pre-existing disorders
or these organs in humans: chronic ingestion may cause kidney and
liver lesions at high doses.

IMMEDIATE HEALTH EFFECTS:
EYES: Exposure may cause noticeable pain, and severe irritation and

transient corneal injury.
SKIN: Exposure may cause mild skin irritation. Prolonged or repeated
exposure may dry the skin. Symptoms may include redness, burning,
drying and cracking and skin burns. Additional symptoms of skin
contact may include: allergic reaction. Skin absorption is possible, but
harmful effects are not expected from this route of exposure under
normal handling and use.
INHALATION: Exposure to vapor or mist is possible. Short term
inhalation is not likely to cause harmful effects: breathing large
amounts may be harmful. Symptoms are more typically seen at air
concentrations exceeding the recommended exposure limits.
INGESTION: Single dose oral toxicity is low. Swallowing small
amounts during normal handling is not likely to cause harmful effects:
swallowing large amounts may be harmful.

SECTION - 4 FIRST AID MEASURES

EYES- Flush eyes with clear water for 15 minutes. Get prompt medical

attention.
SKIN-Rinse with water for 15 minutes. If irritation develops, get
medical attention.
INHALATION- If symptoms develop move victim to fresh air. If
symptoms persist, call a physician.
INGESTION- Immediately give 1 or 2 glasses of water and induce
vomiting by sticking finger down throat. Keep victims head below waist
to prevent aspiration into lungs. Get prompt medical attention.

SECTION - 5 FIRE FIGHTING MEASURES

Flash Point: Explosive limits

107 degrees F (C.C. method) Not Applicable

Autoignition Temperature Hazardous
Products of Combustion

Not Applicable Not Applicable

Extinguishing Media Fire Fighting Instructions

Not Applicable Avoid contact with this material.

Avoid walking in spilled material.

Wear protective clothing for skin

and eyes

SECTION - 6 ACCIDENTAL RELEASE MEASURES

Small Spill: Absorb with an inert solid and scoop up for disposal, then

rinse soiled area with water down the drain.
Large Spill:Stop leak at the source and collect into a suitable
container, then treat as a small spill.

SECTION - 7 HANDLING AND STORAGE

Handling: Containers of this material may be hazardous when

emptied. Since emptied containers retain product residues (vapor,
liquid, and/or solid), all hazard precautions given in the data sheet
must be observed.
Storage: Store in a cool, dry place. Keep container closed when not in
use.

SECTION - 8 EXPOSURE CONTROLS / PERSONAL PROTECTION

Eye Protection: Chemical Splash goggle in compliance with OSHA

regulations are advised: however , OSHA regulations also permit other
type safety glasses. Consult your safety representative.
Skin Protection: Wear rubber gloves (consult your safety equipment
supplier). To prevent repeated or prolonged skin contact, wear
impervious clothing and boots.
Respiratory Protection: If workplace exposure limits of product or any
component are exceeded (see exposure guidelines),NIOSH/OSHA
approved air supplied respirator is advised in the absence of proper
environmental control. OSHA relations also permit other NIOSH/OSHA
respirators (negative pressure type) under specific conditions (see your
industrial hygienist). Engineering or administrative controls should be
implemented to reduce exposure.

Engineering Controls: Provide sufficient mechanical (general and
local exhaust) ventilation to maintain exposure below level of
overexposure (from known, suspected or apparent adverse effects).

SECTION - 9 PHYSICAL AND CHEMICAL PROPERTIES

Appearance and odor pH Concentrate

Thin, colorless liquid with an ammonia odor 10.5 - 11.5
Vapor Pressure Vapor Density

Unknown Unknown
Boiling Point Solubility in Water

209 Degrees Fahrenheit Complete
Percent Volatile Specific Gravity

97% (H

O =1) 1.01 +/- 0.02

2

SECTION - 10 STABILITY AND REACTIVITY

Chemical Stability Conditions to Avoid

Stable Temperature Extremes
Incompatibility Hazardous Decomposition

None None
Hazardous Polymerization

Will not Occur

SECTION - 11 TOXICOLOGICAL INFORMATION

No Data Available

SECTION - 12 ECOLOGICAL INFORMATION

No Data Available

SECTION - 13 DISPOSAL CONSIDERATION

Waste Disposal Information: Dispose of in accordance with all

applicable Federal, State, and Local regulations.
RCRA Information: If this material becomes a waste, it would not be
considered hazardous under 40 CFR 261.22.

SECTION - 14 TRANSPORT INFORMATION

DOT Information 49 CFR 172.101

DOT Description:
33440 Class 55

DOT Hazard Class:
Non Hazardous

Hazardous Component:
None

Reportable Quantity (RQ) - 49 CFR 172.101
Not Applicable

SECTION - 15 REGULATORY INFORMATION

US Federal Regulations

TSCA (Toxic Substances Control Act) Status
TSCA (United States) The intentional ingredients of this product are
listed.
CERCLA RQ - 40 CFR 355 Appendix A

None
SARA 302 Components 40 CFR Appendix A
None
Section 311/312 Hazard Class 40 CFR 370.2
Immediate (X) Delayed (X) Fire ( ) Reactivity ( ) Sudden Release of
Pressure ( )

SARA 313 Components - 40 CFR 372.65
CAS # Chemical Names %

none
* Listed in Section 2 as Ethylene Glycol Monobutyl Ether

State and Local Regulations
California Proposition 65
None
California SCAQMD Rule 443.1 VOC’s
> 120g/L
North Carolina Administrative Code 2D.1104 and 2B.0610
None
South Carolina Regulation 62.5 Standard Number 8
none

SECTION - 16 OTHER INFORMATION

The information accumulated herein is believed to be accurate but is
not warranted to be whether originating with the company or not.
Recipients are advised to confirm in advance of need that the
information is current, applicable and suitable to their circumstances.

This information was compiled from current manufacturer’s MSDS’s of
the component parts of the product. as well as other sources, such
as:

Code of Federal Regulations 29, Revised as of July 1. 1994.
Code of Federal Regulations 40, Revised as of July 1, 1994.
ACGIH, Guide to Occupational Exposure Values, 1996.
ANSI Z129.1-1994, Precautionary Labeling for Hazardous Industrial

Chemicals.
Hazard Communication Handbook, A Right To Know Compliance

Guide. Craig A. Moyer & Michael Francis. Clark Broadman Company.
Ltd. New York, NY 1992

RCRA Regulations and Keyword Index, Compiled and Published by
McCoy and Associates, Inc Lakewood, Colorado. 1992.