Pro-Link 06107 User Manual

Spin Shield
NFPA/HMIS : Health -1 Flammability - 0 Reactivity - 0
Complies With USDL Safety and Health Regulations, (29 CFR
1910.200) Material Safety Data Sheet US Department Of Labor
SECTION - 1 CHEMICAL AND COMPANY IDENTIFICATION
PRODUCT USE: Carpet bonnet cleaner and protector
Pro-Link 510 Chapman Street Canton, MA 02021
EMERGENCIES: 1-866-303-6948 REVISION DATE: 09/20/2010
SECTION - 2 COMPOSITION OF INGREDIENTS
CAS # CHEMICAL NAMES Wt% TLV (UNITS)
N/E Acrylic Copolymer <20 N/E N/E=None established
SECTION - 3 HAZARDS INFORMATION
Primary Route(s) of Entry: Skin contact /absorption and inhalation Signs and Symptoms of Overexposure: Gastrointestinal irritation (nausea, vomiting, diarrhea), irritation to nose, throat, and respiratory tract. Target Organ Effects: Overexposure to this material (or its components) has been suggested as a cause of the following effects in laboratory animals and may aggravate pre-existing disorders or these organs in humans: chronic ingestion may cause kidney and liver lesions at high doses.
IMMEDIATE HEALTH EFFECTS EYES: Exposure may cause noticeable pain, and severe irritation and
transient corneal injury. SKIN: Exposure may cause mild skin irritation. Prolonged or repeated exposure may dry the skin. Symptoms may include redness, drying and cracking. Additional symptoms: of skin contact may include: allergic reaction. Skin absorption is possible, but harmful effects are not expected from this route of exposure under normal handling and use. INHALATION: Exposure to vapor or mist is possible. Short-term inhalation is not likely to cause harmful effects: breathing large amounts may be harmful. Symptoms are more typically seen at air concentrations exceeding the recommended exposure limits. INGESTION: Single dose oral toxicity is low. Swallowing small amounts during normal handling is not likely to cause harmful effects: swallowing large amounts may be harmful.
REPRODUCTIVE / DEVELOPMENTAL INFORMATION: No Data CARCINOGENIC INFORMATION:This material is not listed as a
carcinogen by IARC, NTP, or OSHA
LONG TERM EFFECTS: No Data
SECTION - 4 FIRST AID MEASURES
Eyes: Flush with water for 15 minutes and contact a physician. SKIN:
Thoroughly wash exposed skin with soap and water. INGESTION: If swallowed, do not induce vomiting. Drink 2 to 3 glasses of water and contact a physician.
IN ALL CASES : If symptoms persist, seek medical attention.
SECTION - 5 FIRE FIGHTING MEASURES
Flash Point: No flash to boil (C.C. method) Explosive limits: Not Applicable Autoignition Temperature: Not Applicable Hazardous Products of Combustion: Not Applicable Extinguishing Media: Not Applicable Fire Fighting Instructions: Avoid contact with this material. Avoid
walking in spilled material. Wear protective clothing for skin and eyes
SECTION - 6 ACCIDENTAL RELEASE MEASURES
Small Spill: Absorb with an inert solid and scoop up for disposal, then
rinse soiled area with water down the drain. Large Spill: Stop leak at the source and collect into a suitable container, then treat as a small spill.
SECTION - 7 HANDLING AND STORAGE
Handling: Containers of this material may be hazardous when
emptied. Since emptied containers retain product residues (vapor, liquid, and/or solid), all hazard precautions given in the data sheet must be observed. Storage: Store in a cool, dry place. Keep container closed when not in use.
SECTION - 8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Eye Protection: Chemical Splash goggle in compliance with OSHA
regulations are advised: however , OSHA regulations also permit other type safety glasses. Consult your safety representative. Skin Protection: Wear rubber gloves (consult your safety equipment supplier). To prevent repeated or prolonged skin contact, wear impervious clothing and boots. Respiratory Protection: If workplace exposure limits of product or any component are exceeded (see exposure guidelines), NIOSH/OSHA approved air supplied respirator is advised in the absence of proper environmental control. OSHA relations also permit other NIOSH/OSHA respirators (negative pressure type) under specific conditions (see your industrial hygienist). Engineering or administrative controls should be implemented to reduce exposure. Engineering Controls: Provide sufficient mechanical (general and local exhaust) ventilation to maintain exposure below level of overexposure (from known, suspected or apparent adverse effects).
SECTION - 9 PHYSICAL AND CHEMICAL PROPERTIES
Appearance and odor: Thin, amber liquid with a fresh scent pH Concentrate: 8.0-9.0 Vapor Pressure: Unknown Vapor Density: Unknown Boiling Point: 212 Degrees Fahrenheit Solubility in Water: Complete Percent Volatile: 70 % Specific Gravity: (H2O =1) 1.01 +/- 0.02
SECTION - 10 STABILITY AND REACTIVITY
Chemical Stability: Stable Conditions to Avoid: Temperature Extremes Incompatibility: None Hazardous Decomposition: None Hazardous Polymerization: Will not Occur
SECTION - 11 TOXICOLOGICAL INFORMATION
No Data Available
No Data Available
Waste Disposal Information: Dispose of in accordance with all
applicable Federal, State, and Local regulations. RCRA Information: If this material becomes a waste, it would not be considered hazardous under 40 CFR 261.22
SECTION - 12 ECOLOGICAL INFORMATION
SECTION - 13 DISPOSAL CONSIDERATION
SECTION - 14 TRANSPORT INFORMATION
DOT Information 49 CFR 172.101 DOT Description: 33440 Class 55 DOT Hazard Class: Non Hazardous Hazardous Component: None Reportable Quantity (RQ) - 49 CFR 172.101 Not Applicable
US Federal Regulations: TSCA (Toxic Substances Control Act) Status TSCA (United States) the intentional ingredients of this product are listed. CERCLA RQ - 40 CFR 355 Appendix A: None SARA 302 Components 40 CFR Appendix A: None Section 311/312 Hazard Class 40 CFR 370.2 Immediate (X) Delayed (X) Fire ( ) Reactivity ( ) Sudden Release of Pressure ( ) SARA 313 Components - 40 CFR 372.65 CAS # Chemical Names % none State and Local Regulations California Proposition 65: None California SCAQMD Rule 443.1 VOC’s > 25g/L North Carolina Administrative Code 2D.1104 and 2B.0610: None South Carolina Regulation 62.5 Standard Number 8 none
The information accumulated herein is believed to be accurate but is not warranted to be whether originating with the company or not. Recipients are advised to confirm in advance of need that the information is current, applicable and suitable to their circumstances. This information was compiled from current manufacturer’s MSDS’s of the component parts of the product. as well as other sources, such as: Code of Federal Regulations 29, Revised as of July 1. 1994. Code of Federal Regulations 40, Revised as of July 1, 1994. ACGIH, Guide to Occupational Exposure Values, 1996. ANSI Z129.1-1994, Precautionary Labeling for Hazardous Industrial Chemicals. Hazard Communication Handbook, A Right To Know Compliance Guide. Craig A. Moyer & Michael Francis. Clark Broadman Company. Ltd. New York, NY 1992 \RCRA Regulations and Keyword Index, Compiled and Published by McCoy and Associates, Inc Lakewood, Colorado. 1992.
SECTION - 15 REGULATORY INFORMATION
SECTION - 16 OTHER INFORMATION
Loading...