Pro-Ject Set iPod goes Hifi User Manual

INSTRUCTIONS FOR USE

Pro-Ject “iPod goes Hifi”-Set

Dear music lover,

thank you for purchasing a Pro-Ject “iPod goes Hifi”-Set. In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the units or possible misuse.

Important notice.

Safety instructions

AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the voltage in your area meets the voltage requirements printed on the power supply.

The power cord/power supply is used to disconnect the unit from the mains. Make sure that the power cord/power supply is easily accessible at all times. cord/power supply while your hands are wet or damp.

Avoid letting liquids enter the device or the power supply. Never place any item containing liquid, such as a flower vase on or near the device. Never spill any liquid on the device or the power supply. Never place any naked flame sources, such as lighted candles on or near the device. The product shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.

Never handle the device, the power

What’s in the box

Stereo Box S including remote control handset, power supply and power cord Dock Box S Fi including remote control handset and power supply 2 x Speaker Box 5 including wall mount brackets and instruction for use Design Box 2iP Acryl Speaker cable, length 2 x 2 meter

8 x banana plugs (4mm ) Interconnect cable, length 25cm

Connectors - Stereo Box S

Record Out

Left

Pro-Ject Audio Systems, Vienna, Austria

Right

Make all connections whilst the amplifier is disconnected from the power supply.

Left

Right

Connecting amplifier and docking station

Connect, using the supplied interconnect cable, the sockets IN1 on the amplifier to the sockets OUT on the Dock Box S Fi.

Inputs Line level sources such as CD player radio or TV can be connected to the input sockets marked IN1 or IN2.

Take care to connect the left and right channels correctly. The right channel is usually marked red,

the left channel black or white.

Connecting amplifier and speakers

The output terminals accept loudspeaker cables terminated with 4mm  Banana plugs, spades connectors or naked wire. Connect the cable terminals on the amplifier to the terminals on the speakers.

The red speaker terminals carry the positive signal (+), the black speaker terminals the negative signal (–). Make sure the polarity of the connection is correct at each end of the cables.

Only connect one loudspeaker with an impedance not less than 4 ohms per channel.

Record output, connecting a headphone amplifier - Stereo Box S

Record Out connects an analogue record device ore a Pro-Ject Head Box headphone amplifier.

Record Out provides a fixed output level.

Connectors - Dock Box S Fi

18V

Pro-Ject Audio Systems, Vienna, Austria

Make all connections whilst the Dock Box is disconnected from the power supply.

Connecting to a computer, iPod® operating system

Connect the USB-output of the Dock Box to a free USB-socket on your computer and switch it on.

When the Dock Box is connected to a computer, all functions of the Dock Box are blocked.

Connection to a TV-set or a beamer

Connect the S-VIDEO socket to a s-video input of your TV-set or beamer.

„All digital“ units do not support the s-video output.

Fitting and adjustment of the iPod® cradle

Use the knurled screw supplied to fix the cradle to the Dock Box chassis. Do not fully tighten the screw yet. Now place your iPod the screw.

This device is suitable for iPods®/iPhones® with 30-pole connector only. To connect units with a lightning-connector, such as iPod

a lightning-adapter (lightning connector Use without the cradle will eventually break the 30-pole connector of the Dock Box and the socket of

the iPod

on the Dock Box contacts. Move the cradle so that it supports the iPod® and tighten

Nano 7. generation or iPod® Touch 5,



30-pole connector) is needed.

. Before connecting the iPod®, any sort of cover has to be removed.

Mains power connection

Stereo Box S Connect the low voltage plug from the power supply to the Power 20V supply to the mains.

Dock Box S Fi Connect the low voltage plug from the power supply to the Power 18V supply to the mains.

Never use any other power supply than the one supplied with the particular unit.

Remote control - Stereo Box S

socket before connecting the power

ON/OFF

VOL-

CH+

VOL+

CH-

ON/OFF

turns the unit on or back into standby

VOL

and

VOL

adjust the sound volume

select the inputs

Front panel controls - Stereo Box S

Stereo Box S

To switch on from standby or to standby - Stereo Box S

The push button (press and hold to switch into standby mode) on the left hand side of the front panel turns the unit on or back into standby. The blue LED above the stand-by push button shows that the unit is switched on.

Input selector - Stereo Box S

After the unit is powered on, pressing the push button on the right, selects the In 1 and In 2 inputs in turn. The optional input expander Pro-Ject Switch Box S provides three more inputs. For further details please see the

user guide of the Pro-Ject Switch Box S.

Volume - Stereo Box S

Adjust the volume to the desired level, using the large knob on the front panel.

To switch on and off, charging the battery - Dock Box S Fi

The Dock Box is turned on and off with the supplied user remote. A blue LED on the front panel shows that the unit is switched on.

When the Dock Box is connected to the mains supply it will charge the docked iPod

(even in standby).

Remote control - Dock Box S Fi

iPod® Touch and iPhone® must be unlocked and switched to music mode. The volume control of the apple

Blanked out buttons do not carry a function !

ON/OFF

ENTER

device has to be set to max..

REPEAT

SHUF

To switch on from standby or to standby

ON/OFF

turns the Dock Box off and the iPod® into standby. Switches the Dock Box on. Press any key (except ON/OFF) to turn on the iPod

Start / Pause

starts and pauses playback

Stepping between tracks, reverse and forward scanning

skips to the previous track.

skips to the next track

restarts the current track in playback mode

Press and hold the

button for reverse scanning, or the button

to start forward scanning.

Repeat play

REPEAT

starts repeat play for the current track. Pressing the button again starts repeat play for all tracks.

To deactivate repeat play press REPEAT once more.

Shuffle play

SHUF

activates and deactivates shuffle play

Navigating the menu

shows the menu. Returns to the previous step in the menu

and move the curser up and down, to highlight the requested option.

ENTER

selects or deselects the highlighted option. Shows the next step in the menu.

Replacing batteries

Proceed as follows:

 Unlock and slide open the battery case cover  Replace the battery.

Make sure the battery is the right way round !

 Close the battery case cover

Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V

Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at the appropriate collection sites - usually located at supermarkets and drugstores.

Technical specifications Pro-Ject Stereo Box S

Power output: 2 x 25W/30W at 8 ohms/4 ohms (both channels driven) Frequency response: 20Hz - 20kHz (±0,2dB) Channel separation: >40dB at 20kHz Noise floor: >-100dB (A weighted) THD: <0,05% at 10W Gain: 22dB Line-level inputs: 2 pairs RCA/phono sockets Input impedance: 20kohms Record Out: 3-pole 3,5mm co-axial jack Speaker connectors: 4mm  banana plugs, spades connectors or naked wire Outboard power supply: 20V/3A DC (peak 7A DC), suitable for your country's mains supply Power consumption: 3A DC, <1W in standby Replacement battery remote control: 1 x CR2032 / 3V Dimensions W x H x D (D with sockets): 103 x 36 x 104 (122)mm Weight: 720g without power supply

Technical specifications Pro-Ject Dock Box S Fi

Frequency response: 20Hz - 20kHz Line-level output: 1 pair RCA/phono sockets Output impedance: 15 ohms Output voltage: 1Vrms USB-output: 5-pole mini-B jack USB-signal: digital serial data protocol USB 1.1 Operating systems: Windows XP Video output: S-video socket Outboard power supply: 18V/500mA DC, suitable for your country's mains supply Power consumption: 300mA DC max.. Power consumption is not constant.

It depends on the charging needs of the battery. <1W in standby Replacement battery remote control: 1 x CR2032 / 3V or 1 x CR2025 / 3V Dimensions W x H x D (D with sockets): 103 x 36 x 104 (109)mm - height plus height of iPod or iPhone Weight: 585g without power supply

, Windows VISTA®, Windows 7®, Windows 8®, Mac OS

Technical specifications Pro-Ject Speaker Box 5

Recommended amplifier power: 10 - 150 watts Impedance: 8ohms Sensitivity (1W/1m): 86dB Dimensions W x H x D / weight: 160 x 255 x 210mm / 4,2kg

Service

Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions for use and/or by transportation without the original packaging. Modification or change to any part of the product by unauthorized persons release the manufacturer from any liability over and above the lawful rights of the customer.

PRO-JECT is a Registered Trademark of H. Lichtenegger.

This guide was produced by: Audio Trade GmbH Copyright

Windows XP

iPod

, Windows Vista®, Windows 7®, Windows 8® are trademarks of the Microsoft group of companies.

, Mac® and Mac OS® are trademarks of Apple Inc., registered in the U.S. and other countries.

The information was correct at the time of going to press. The manufacturer reserves the right to make changes to the technical specification without prior notice as deemed necessary to uphold the ongoing process of technical development.

Pro-Ject Set iPod goes Hifi User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual