Pro-Ject RECEIVER BOX S User Manual

INSTRUCTIONS FOR USE

Pro-Ject Switch Box S

Dear music lover,

thank you for purchasing a PRO-JECT AUDIO input expander.

In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Safety instructions

AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the voltage in your area meets the voltage requirements printed on the power supply. The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily accessible at all times.

Avoid letting liquids enter the device or the power supply. Never place any item containing liquid, such as a flower vase on or near the device. Never spill any liquid on the device or the power supply. Never place any naked flame sources, such as lighted candles on or near the device. The product shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.

Never handle the device, the power supply while your hands are wet or damp.

Connectors

Left

In 5

Right

In 3

Out 2

Trigger

In 4

In 2

Pro-Ject Audio Systems, Vienna, Austria

Make all connections whilst the input expander is disconnected from the power supply. Take care to connect the left and right channels correctly. The right channel is usually marked red,

the left channel black or white. Never use any other power supply than the one supplied with the unit.

Out

Outputs

Out has to be connected to the In 2 of the Pro-Ject Pre Box S. Out 2 can be used to connect a Pro-Ject headphone amplifier, like the Head Box S ore the Head Box DS.

Inputs

Line level sources such as CD player tuner or TV can be connected to the input sockets marked In 2 - In 5.

Trigger (Pro-Ject Pre Box S only)

The socket marked Trigger Switch on the Pro-Ject Pre Box S provides a trigger signal for the Switch Box S. The trigger signal permits automatic synchronization with the input selector of the Pro-Ject Pre Box S.

A 30cm long trigger cable is supplied with the Pro-Ject Switch Box S for connecting the socket Trigger Switch on the Pro-Ject Pre Box S and the socket Trigger on the back of the Pro-Ject Switch Box S.

Do not use the trigger input and output for any other connections for which it is not designed.

Mains power connection

Connect the low voltage plug from the power supply to the Power ~16V socket before connecting the power supply to the mains.

+ 1 hidden pages