Pro-Ject PRE BOX DS, PRE BOX RS, PRE BOX S User Manual

Pro-Ject Pre Box RS Digital

INSTRUCTIONS FOR USE

©

2

Dear music lover,

!

!

AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the

Tubes produce heat. Proper ventilation has to be guaranteed all the time. The unit must not be stacked.

!

disconnected from the power supply

which can replace original power supplies.

Analog Out

thank you for purchasing a Pre Box RS Digital from Pro-Ject Audio Systems.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Safety instructions

voltage in your area meets the voltage requirements printed on the power supply.
The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily

accessible at all times.
Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,

such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.
Never place any naked flame sources, such as lighted candles on or near the device. The product shall not
be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.

Never handle the device or the power supply while your hands are wet or damp.

Connectors

Make all connections whilst the preamplifier is
Take care to connect the left and right channels correctly. The right channel is usually marked red,

the left channel black or white.
Wiring XLR sockets: 1 ground, 2 “hot” and 3 “cold”.
Never use any other power supply than the one supplied with the unit except of Pro-Ject Power Boxes

Analog out

A power amplifier or active loudspeakers can be connected to the output sockets marked
(balanced connection) or RCA (unbalanced connection).

.

XLR

Pro-Ject Audio Systems · Pro-Ject Pre Box RS digital · Revision 2014.4.22