Pro-Ject Pick it DS2 MC Product information
PRODUCT INFORMATION
Pick it DS2 MC
High End MC cartridge
MSRP 599 € (incl. VAT)
� Moving Coil principle
� Simple and fast mounting
� High delity
� Exceptionally lively
� Very detailed with low distortion
� Needs MC-compatible phono input
� Robust polyamid-body
� Resonance free thanks to laser-sintering-process
� Rigid mounting plate out of metal
� Threaded holes for simple mouting without nuts
Output voltage: 0,5 mV
Frequency response: 20 - 24 000 Hz
Channel separation: 25dB @ 1kHz
Compliance dynamic/lateral: 14 µm/mN
Stylus type: Naked Elliptical
Stylus tip radius: 8/18 µm
Tracking force, recommended: 2,2 g (mN)
Tracking force, range: 2,0 - 2,5 g (mN)
Tracking angle: 20°
Spool material: Pure 4N Cu
Recommended load resistance: 20 Ω
Cartriddge weight: 9 g
� Optimum contact to headshell thanks to three-point
pad
PRO-JECT AUDIO SYSTEMS
www.project-audio.com
Technical data and price changes reserved.
Page 1/2
Moving Coil – high quality
PRODUCT INFORMATION
When looking for high quality HiFi cartridges it is very
obvious, that real High End systems almost exclusive-
ly use the Moving Coil principle. Because of the lower
moving mass – the moving coil is a lot lighter than a
moving magnet – a dynamic and detailed sound with
superior low distortion is possible. The resulting lower
output voltage can be compensated nowadays with the
use of a high quality phono stage (such as Phono Box
DS2, Tube Box DS2, Phono Box RS). Another advantage
is, that because of the very low source impedance (5
Ohms to 1 kOhm) outside interferences, like hum, are
surpressed very eectively. If your phono pre-amplier
has variable load impedance (like Phono Box RS, Tube
Box DS2) this allows for a wide ne-tuning. The four
connectors on the back are gold-plated, the threaded
holes oer a fast and ecient mounting. The massive
metal plate with three contact-points oers best possi-
ble contact to the tonearm.
Pick-it DS2 MC: Exceptional
Pick-it DS2 MC is Pro-Ject‘s current high end cartridge.
The corpus is made of polyamid, which has excellent me-
chanical specications. System-body and needle guard
are made in a special selective laser sintering (SLS) pro-
cess. Here the body is created by slowly melting the
material (powder) via laser. This results in almost reso-
nance-free material, which is an enormously important
aspect for analogue playback. Optimum attention to de-
tail and a distortion free, musical sound are the outcome!
PRO-JECT AUDIO SYSTEMS
www.project-audio.com
Technical data and price changes reserved.
Page 2/2
Loading...