Pro-Ject Head Box S USB User Manual

INSTRUCTIONS FOR USE

Pro-Ject Head Box S USB

Dear music lover,

thank you for purchasing a PRO-JECT AUDIO headphone amplifier.

In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Safety instructions

AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the voltage in your area meets the voltage requirements printed on the power supply.

The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily accessible at all times.

Avoid letting liquids enter the device or the power supply. Never place any item containing liquid, such as a flower vase on or near the device. Never spill any liquid on the device or the power supply. Never place any naked flame sources, such as lighted candles on or near the device. The product shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.

Never handle the device, the power supply while your hands are wet or damp.

Connections

Left

Pro-Ject Audio Systems, Vienna, Austria

Make all connections, except the connection to the computer and the headphone, whilst the unit is disconnected from the power supply.

Take care to connect the left and right channels correctly. The right channel is usually marked red, the left channel black or white.

Never use any other power supply than the one supplied with the unit.

Right

Left

Out

Right

18V

Connection to the amplifier (recorder)

Connect the TAPE / RECORD OUT RCA/phono sockets from your amplifier to the In RCA/phono sockets of the headphone amplifier. As the analog input signal is relayed to the RCA/phono sockets Out, the Out RCA/phono sockets of the headphone amplifier can be connected to the input sockets of your recorder.

Alternatively analog sources like CD player or tuner can be reconnected to the In RCA/phono sockets directly.

Connecting to a Computer

Connect the USB-input of the headphone amplifier (unit must be switched on) to a free USB-socket on your computer and turn it on/make sure it is powered on. The amp will be automatically recognised by the computer. There is no need to install a driver manually.

Please note: Connection should be made to an USB-socket of your computer directly. Connecting to USB-hubs or switches can cause problems.

Mains power connection

Connect the low voltage plug from the power supply to the Power 18V " socket before connecting the power supply to the mains.

+ 2 hidden pages