thank you for purchasing a PRO-JECT AUDIO docking station Dock Box.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
!
Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Connectors
18V
Pro-Ject Audio Systems, Vienna, Austria
Make all connections whilst the Dock Box is disconnected from the power supply.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the
!
left channel black or white.
Never use any other power supply than the one supplied with the unit.
Connection to the amplifier
Connect the Left/Right Out socket to a line input (such as AUX) on your amplifier.
Connecting to a computer, iPod® operating system
Connect the USB-output of the Dock Box to a free USB-socket on your computer and switch it on.
When the Dock Box is connected to a computer, all functions of the Dock Box are blocked.
Connection to a TV-set or a beamer
Connect the S-VIDEO socket to a s-video input of your TV-set or beamer.
„All digital“ units do not support the s-video output.
Fitting and adjustment of the iPod® cradle
Use the knurled screw supplied to fix the cradle to the Dock Box chassis. Do not fully tighten the screw yet.
Now place your iPod
the screw.
This device is suitable for iPods®/iPhones® with 30-pole connector only.
To connect units with a lightning-connector, such as iPod
a lightning-adapter (lightning connector
Use without the cradle will eventually break the 30-pole connector of the Dock Box and the socket of
!
the iPod
®
on the Dock Box contacts. Move the cradle so that it supports the iPod® and tighten
®
Nano 7. generation or iPod® Touch 5,
30-pole connector) is needed.
®
. Before connecting the iPod®, any sort of cover has to be removed.
Mains power connection
Connect the low voltage plug from the power supply to the Power 18V " socket before connecting the power
supply to the mains.
shows the menu. Returns to the previous step in the menu
and move the curser up and down, to highlight the requested option.
ENTER
selects or deselects the highlighted option. Shows the next step in the menu.
Replacing batteries
Proceed as follows:
Unlock and slide open the battery case cover
Replace the battery.
Make sure the battery is the right way round !
Close the battery case cover
Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.
Technical specifications Pro-Ject Dock Box S Fi
Frequency response: 20Hz - 20kHz
Line-level output: 1 pair RCA/phono sockets
Output impedance: 15 ohms
Output voltage: 1Vrms
USB output: 5-pole mini-B jack (USB cable supplied)
USB signal: digital serial data protocol USB 1.1
Operating systems: Windows XP
Video output: S-video socket
Outboard power supply: 18V/500mA DC, suitable for your country's mains supply
Power consumption: 300mA DC max.. Power consumption is not constant.
It depends on the charging needs of the battery. <1W in standby
Replacement battery remote control: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions W x H x D (D with sockets): 103 x 36 x 104 (109)mm - height plus height of iPod or iPhone
Weight: 585g without power supply
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Safety instructions
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply.
The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily
accessible at all times.
!
Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,
such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.
Never place any naked flame sources, such as lighted candles on or near the device. The product shall not
be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.
Never handle the device, the power supply while your hands are wet or damp.
Copyright, trademarks
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright
, Mac® and Mac OS® are trademarks of Apple Inc., registered in the U.S. and other countries.
, Windows Vista®, Windows 7®, Windows 8® are trademarks of the Microsoft group of companies.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.