Pro-Ject CD Box RS User Manual

Ject CD Box RS

INSTRUCTIONS FOR USE

Pro-

Dear music lover,

This product contains a laser diode of higher class than 1. To ensure continued safety, do not remove any

The power cord is

used to disconnect the unit from the mains. Make sure that the power cord is easily accessible at all

device or the power supply. Never place any item containing liquid,

such as a flower vase on or near the device. Never spill any liquid on the device or the power

he product

be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar

If a disc is cracked, chipped, warped, or otherwise damaged, don't risk to play it. You could end up

he unit. This player is designed for use with fully circular, full size CDs only. Use of shaped

discs is not recommended. The manufacturer and the distributor disclaims all liability arising in

Out Sonic

Clock In

Sonic

Clock

thank you for purchasing a Pro-Ject Audio CD Box RS. In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Caution! Laser diode, safety instructions

covers or attempt to gain access to the inside of the product. Refer all servicing to qualified personnel. AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the

voltage in your area meets the voltage requirements printed on the power supply.

times. Never handle the device, the power cord/power supply while your hands are wet or damp. Avoid letting liquids enter the

supply. Never place any naked flame sources, such as lighted candles on or near the device. T shall not conditions.

Discs to avoid

damaging t

connection with the use of damaged or shaped discs.

Connectors

Make all connections whilst the CD player is disconnected from the power supply. Never use any other power supply than the one supplied with the unit, except of Pro-Ject Power Box.

Connection to an external D/A-converter

Connect one of the digital outputs Out coax, Out opto, Out AES/EBU or i2S (Out Sonic/Clock In) to a matching digital input on the D/A converter or AV processor.

The cable length for

(I2S) and

can be used with Pro-Ject DAC Box RS and Pre Box RS Digital only.

and

connection must not be longer than 29,5 inch (75cm).

+ 4 hidden pages