ProForm PFTL98583, PFTL98584, PFTL98585, PFTL98580, PFMC98680 Owner's Manual

...
Stereo Speaker Kit Model No. PFMC98680
Congratulations for purchasing high fidelity speakers for your PROFORM®985 CD treadmill. The patented speakers are amplified and specially designed to boost bass at low volumes for optimal audio quality. To install and operate the speakers, follow the step-by-step instructions in this guide.
Before installing the speakers, please read all precautions and instructions in this guide. If you have any questions after reading this guide, or if there are any damaged parts, please call our toll-free Customer Hot Line at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).
Right Speaker
Rear View
D
I
(To treadmill console)
A
C
J
K
E
F G H
Left Speaker
Rear View
A. Volume control B. Power indicator C. Treble control D. Power button E. DC IN 15VDC jack F. SUB OUT jack (not used) G. SPEAKER OUT jack (white) H. INPUT jack (green) I. Jumper wire J. Speaker wire (white) K. Audio wire (green)
1. Keep the power cord away from walkways and heated surfaces.
2. Clean the speakers only with a soft, dry cloth. Never use abrasives or solvents.
3. Keep liquids away from the speakers.
4. The speakers should be serviced by qualified service personnel if : (a) the power cord is dam­aged, (b) liquid has been spilled into the speak­ers, (c) the speakers do not operate normally, or (d) the speakers have been dropped or the enclo­sures damaged.
Right Speaker
Front View
IMPORTANT PRECAUTIONS
B
ALTEC
LANSING
VOLUME TREBLE
DC IN
SUB
SPKR OUT
INPUT
POWER
15VDC
OUT
Peel the backing off one of the included plastic anchors (L). Press the plastic anchor onto the console plate (M) in the indicated location.
Fold the speaker wire (J) as shown and secure it to the plastic anchor (L) with a plastic tie (N).
4
J
M
N
Before beginning installation, lay all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until installation is completed. Included in this kit are ten 1/2” screws and eight long screws. For your convenience, separate the screws into two piles before beginning installation.
Installation requires a phillips screwdriver .
How to Install the Speakers
Attach the right speaker bracket (A) to the right upright (B) with four of the long screws (C). Next, peel the backing off the fastener strips (D).
Identify the right speaker (E) (refer to the front of this guide). Press the right speaker firmly onto the fastener strips (D), with the back of the speaker resting against the back of the speaker bracket (A).
Attach the left speaker bracket and the left speaker in the same way (not shown).
1
Remove the four 1/2” screws (F) and the six 3/4” screws (G) from the back of the console (H). Discard the screws.
Remove the back of the console (H).
2
Locate the audio wire (I) beneath the console. Plug the audio wire into the INPUT jack on the right speaker.
Locate the speaker wire (J) attached to the left speaker. Plug the speaker wire into the SPEAKER OUT jack.
Next, plug one end of the jumper wire (K) into the DC IN 15VDC jack. Plug the other end into the jack on the right upright.
3
A
F
F
G
G
H
I
J
K
B
E
D
C
I
2
L
L
Loading...
+ 2 hidden pages