ProForm PFSC09900 User Manual

WARNING:To reduce

the risk of serious injury, read these warnings before using the scooter.

1. Read and follow all instructions.

2. It is the owner’s responsibility to ensure that all users of the scooter are adequately informed of all warnings and instructions.

3. Inspect the scooter and tighten or replace any loose or missing parts before each use. In addition, make sure that the lock pin is locked into position, the handles and the stem are securely locked in position, the wheels rotate freely, the brake is in working order and free of all debris, and the wheel bolts are secure.

4. The scooter should not be used by children under the age of eight. A responsible adult must always supervise young riders.

5. Always wear protective equipment, including a helmet, knee pads, wrist guards, elbow pads, and closed-toed shoes, when using the scooter.

6. Never ride on streets, roadways, or driveways that enter vehicle traffic routes. Never ride on wet or uneven surfaces, at night, or when visibility is poor.

7. Never tow a rider with a bicycle, motorcycle, or vehicle.

8. Locate the warning decals on the scooter, and read the warnings before using the scooter.

9. Save this User’s Manual for future reference.

10. This scooter should not be used by persons weighing more than 200 pounds.

11. Braking from high speeds or prolonged braking on inclines can cause excessive wear of the rear wheel and brake. Exercise caution when selecting your area of use.

12. To prevent burns, avoid touching the brake after prolonged use.

User’s Manual

Model No. PFSC09900

Warning Decal Placement

Setup

The decals shown at the right have been placed on the scooter. If a decal is missing or illegible, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time, to order a free replacement decal. Apply the replacement decal in the location shown.

Storage

1. Open the quick-release lever. Depress the push pin on the

stem and slide the stem down into the upright. Close the quick-release lever.

2. Depress the push pins and remove the handles from the

stem. Press the handles into the storage clip on the upright.

3. Pull the thumb tab and pivot the upright down until it locks

in the horizontal position.

Before using the scooter, make sure that the scooter is set up as described and that all parts are securely tightened.

1. Firmly press the thumb tab and pivot the upright up until it

locks in a nearly vertical position.

2. Insert the handles into the stem until the push pins are visi-

ble in the holes in the stem.

3. Open the quick-release lever. Depress the push pin on the

stem, and slide the stem up until the push pin is visible in one of the three holes in the upright. With the stem at the desired height, close the quick-release lever so that it is snug against the upright. If the quick-release is not snug, see ADJUSTING THE QUICK RELEASE on the next page.

Thumb Tab

Storage Clip

Brake

Stem

Quick

Release

Head Frame

Handle

Hand

Brake

Upright

Push Pins

Push Pin

Upright

+ 2 hidden pages