ProForm PFSC03800 User Manual
WARNING:To reduce
the risk of serious injury, read these
warnings before using the scooter.
1. Read and follow all instructions.
2. It is the owner’s responsibility to
ensure that all users of the scooter
are adequately informed of all
warnings and instructions.
3. Inspect the scooter and tighten or
replace any loose or missing parts
before each use. In addition, make
sure that the handles and the stem
are securely locked in position, the
wheels rotate freely, the brake is in
working order and free of all debris,
and the wheel bolts are secure.
4. The scooter should not be used by
children under the age of eight. A
responsible adult must always
supervise young riders.
5. Always wear protective equipment,
including a helmet, knee pads, wrist
guards, elbow pads, and closed-toed
shoes, when using the scooter.
6. Never ride on streets, roadways, or
driveways that enter vehicle traffic
routes. Never ride on wet or uneven
surfaces, at night, or when visibility
is poor.
7. Never tow a rider with a bicycle,
motorcycle, or vehicle.
8. Locate the warning decals on the
scooter, and read the warnings
before using the scooter.
9. Save this User’s Manual for future
reference.
10. This scooter should not be used by
persons weighing more than 200
pounds.
11. Braking from high speeds or prolonged braking on inclines can cause
excessive wear of the rear wheel and
brake. Exercise caution when selecting your area of use.
12. To prevent burns, avoid touching the
brake after prolonged use.
User’s Manual
Model No. PFSC03800
Setup
1. Depress the lock pin on the left side of the deck (see the
drawing below). Pivot the upright up until it locks into a
nearly vertical position. Turn the release knob clockwise
until it is tight.
2. Insert the handles into the stem until the lock pins are visi-
ble in the holes in the stem.
3. Open the quick-release lever. Depress the lock pin on the
stem, and slide the stem up until the lock pin is visible in
the top hole. Close the quick-release lever so that it is snug
against the upright. If the quick release is not snug, see
ADJUSTING THE QUICK RELEASE on the back of this
user’s manual.
Before using the scooter, make sure that the scooter is set up as
described and that all parts are securely tightened.
The decal shown at the right has been placed on the scooter. If the
decal is missing, or if it is not legible, please call our Customer
Service Department toll-free at 1-800-999-3756, Monday through
Friday, 6 a.m. until 6 p.m. Mountain Time, to order a free replacement decal. Apply the replacement decal in the location shown.
Storage
1. Open the quick-release lever. Depress the lock pin on the
stem and slide the stem into the upright. Close the quickrelease lever.
2. Depress the lock pins and remove the handles from the
stem. Press the handles into the storage clip on the upright.
3. Turn the release knob counterclockwise until you can pull it
out, and pivot the upright down past the lock pin into the
horizontal position.
Release Knob
Release Knob
Storage Clip
Rear Brake
Stem
Groove
Front
Left Side
Right Side
Quick Release
Handle
Handles
Upright
Lock Pin
Lock Pins
Lock Pin
Upright
Loading...